EN
Linear logo
Official user manual

Linear VB-2

1 pages·196 KB·Home Security System·PDF·ENDEFRITNLJA
Linear VB-2
Table of Contents 8 sections REMOVE JUMPER · NOTE: REMOVE JUMPER WHEN · USING AN EXTERNAL · SPEAKER · … ShowHide
Page 1 of the Linear VB-2 user manual — REMOVE JUMPER
Page 1 · click to enlarge
Page 1
2 & VB-3 MODULES ay Central Station B-2 only) With DVS-1200, 00, DVS-2408, Systems lation ctions (760) 438-7000 • FAX (760) 438-7043 A & Canada (800) 421-1587 & (800) 392-0123 Toll Free FAX (800) 468-1340PRODUCT DESCRIPTION 1. COMPONENT LOCATIONS The VB-2 and VB-3 Audio Modules are designed as add-on accessories for the DVS-1200. DVS-2400, and DVS-2408 Security Systems. Each module plugs directly into the unit’s circuit board. The modules provide voice prompts for TERM operating the system and voice feedback for remote command of the system through a pushbutton telephone. The VB-2 module features 2-way audio and audio listen-only capabilities for Central Station monitoring. The digitally synthesized human voice produced by the module annunciates important system information through the Console’s speaker or through a remote speaker. Both modules are pre-programmed with a multi-word vocabulary. Each time the system’s mode is changed, the voice module will sound the status of the Console and its sensors. The volume control adjusts the voice level. With either the VB-2 or VB-3 installed, and the Console connected to a telephone line, local or off-site telephone sets can be used to control and interrogate the DVS-2400 or DVS-2408. To gain access to the system, the user first enters their user code. The module’s voice will then prompt the user to press various telephone buttons to control the system. The DVS-1200 can be accessed only from off-side telephones. The VB-2 module supports 2-way audio communications with the Central Station. The small microphone supplied fits into the Console’s case. The microphone’s high-gain amplifier allows the Central Station to monitor the sounds in the installation. The Central Station operator can control the direction of the 2-way communications using a pushbutton telephone. In 2-way mode, the operator can MODUL CO talk back to the subscriber through the Console’s speaker or a remote speaker.GAIN JUMPER MICROPHONE CUT JUMPER FOR USE WITH OLDER INALS (VB-2 ONLY) DVS-2400/DVS-2408 OR IF EXTERNAL MICROPHONE (+) FEEDBACK OCCURS MICROPHONE COMMON (-) MODULE-TO-CONSOLE CONNECTOR CONSOLE MICROPHONE (+) 2-WAY AUDIO CONSOLE SPEAKER VOLUME CONTROL DIGITAL VOICE VOLUME CONTROL E-TO-CONSOLE NNECTOR MICROPHONE (SUPPLIED WITH VB-2 ONLY) NECT MICROPHONE3. PLUG MODULE INTO CIRCUIT BOARD 4. MOUNT MICROPHONE MODEL VB-2 T BLACK - ONLY - ONE WIRE TO TERMINAL CONNECT RED MICROPHONE WIRE TO THIS TERMINAL E DVS-2408 INSTALLATION INSTRUCTIONS R USE WITH THE DVS-2408REMOVE POWER FROM CONSOLE PR MODELL DIN VE SA -2R 4 S 0E 0C /U DR VI ST -Y 2 4S 0Y 8S /T DE VM S-1200 LOCATION OF VOICE FIR CIRCUIT BOARD BOARD INSIDE CONSOLE MO (ARROWS MUST POINT UP) MODEL: VB-2 OR VB-3 VOICE MODULE WARNING ! SMALL ARROWS ON VOICE MODULE POINT UP START BY INSERTING THIS CONNECTOR PART WAY COMPLETE INSTALLATION BY ALIGNING PINS ON OTHER CONNECTOR AND CAREFULLY PRESSING THE MODULE IN WARNING ! BE SURE ALL CONNECTOR PINS ALIGN WITH CIRCUIT BOARD SOCKETSESS MICROPHONE MODEL VB-2 MLY INTO MICROPHONE - ONLY - UNTING HOLE OTE SPEAKER & MICROPHONE6. VOICE SYNTHESIS SETUP 7. REMOTE SYSTEM OPERATION OPTIONAL REMOTE SPEAKER & MICROPHONE CONNECTIONS AIN TERMINAL BLOCK VB-2 TERMINAL BLOCK AC AC EXTERNAL MICROPHONE (+) EXT. SPKR MICROPHONE COMMON (-) (-) CONSOLE MICROPHONE (+) H/A - H/A + RELAY N.O. RELAY DRY RSM-1 TERMINALS USE TWISTED PAIR TERMINAL BLOCK WIRE FOR MICROPHONE LINEAR MODEL RSM-1FROM START IN LEARN MODE PROGRAM THE CONSOLE TO ENABLE AUDIO FROM PRESS P R THE MODULE TO THE PROGRAMMING STEP #78 SPEAKER T U H O PROGRAM ARM ED 1 FOR SPEAKER ENABLE HOM E MS OY DS ETEM A A STORE PROGRAM SWITCH THE SYSTEM BETWEEN MODES TO TEST THE AUDIO OUTPUT ADJUST THE MODULE'S VOLUME CONTROL TO SET THE VOICE LEVELA HOUSE PHONE DIAL THE INSTALLATION, LET IT RING TWICE, HANG UP AND DIAL THE INSTALLATION AGAIN (2ND CALL NEEDS TO BE 10-30 SECONDS AFTER 1ST CALL) THEN LISTEN FOR TONE ENTER A USER CODE THEN PRESS # CONSOLE WILL REPORT MODE, ALARMS, AND TROUBLE PRESS "1" TO SWITCH SYSTEM TO OFF MODE PRESS "2" TO SWITCH SYSTEM TO CHIME MODE PRESS "3" TO SWITCH SYSTEM TO HOME MODE PRESS "4" TO SWITCH SYSTEM TO AWAY MODE PRESS "5" TO LISTEN TO ALARM STATUS NOTE: THE SYSTEM MUST BE CONNECTED PRESS "6" TO LISTEN TO TROUBLE STATUS TO A TELEPHONE LINE TO USE THESE FUNCTIONS PRESS "7" TO LISTEN TO SENSOR STATUS TRAL STATION AUDIO (VB-2 ONLY)LINEAR LIMITED WARRANTY This Lin RAM THE SYSTEM FOR months. DESIRED AUDIO MODE MODEL VB-2 only to - ONLY - distributi should in are no damage ALL other in remova PROGRAMMING STEP #76 AUDIO PRESS "9" TO DISCONNECT THE CALL for merc MODES Date as warrant All prod PROGRAM (RPA#). PRESS "3" TO LISTEN importan 0 FOR NO AUDIO MONITORING 2-WAY MANUAL Linear r 1 FOR LISTEN-ONLY AUDIO MODE portable 1 For 2 3 F FO OR R 2 2- -W WA AY Y M FUA LN LU DA UL PLEX PRESS "1" TO TALK 1 R t Ah e e rg r ee bloc STORE PROGRAM THE "1" AND "3" KEYS ARE NOT USED IN LISTEN-ONLY AUDIO MODE 1 c Co hd ae 1 Infre THE "1" AND "3" KEYS CAN BE USED IN FULL DUPLEX MODE, inter THE ALARM REPORT ALTHOUGH THE MODULE WILL SWITCH TO 2-WAY MANUAL 1 A ge whol T THE SYSTEM WILL MODE UNTIL THE NEXT CALL user H TO THE PROGRAMMED MODE FOR 90 SECONDS Copyrigear product is warranted against defects in material and workmanship for twelve (12) The Warranty Expiration Date is labeled on the product. This warranty extends wholesale customers who buy direct from Linear or through Linear’s normal on channels. Linear does not warrant this product to consumers. Consumers quire from their selling dealer as to the nature of the dealer’s warranty, if any. There obligations or liabilities on the part of Linear corporation for consequential s arising out of or in connection with use or performance of this product or direct damages with respect to loss of property, revenue, or profit, or cost of l, installation, or reinstallation. All implied warranties, including implied warranties hantability and implied warranties for fitness, are valid only until Warranty Expiration labeled on the product. This Linear Corporation Warranty is in lieu of all other ies express or implied. ucts returned for warranty service require a Return Product Authorization Number Contact Linear Technical Service at 1-800-421-1587 for an RPA# and other t details. IMPORTANT !!! adio controls provide a reliable communications link and fill an important need in wireless signalling. However, there are some limitations which must be observed. U.S. installations only: The radios are required to comply with FCC Rules and ulations as Part 15 devices. As such, they have limited transmitter power and fore limited range. ceiver cannot respond to more than one transmitted signal at a time and may be ked by radio signals that occur on or near their operating frequencies, regardless of settings. nges or modifications to the device may void FCC compliance. quently used radio links should be tested regularly to protect against undetected ference or fault. neral knowledge of radio and its vagaries should be gained prior to acting as a esale distributor or dealer, and these facts should be communicated to the ultimate s. ht © 1999 Linear Corporation 214074 B

REMOVE JUMPER

NOTE: REMOVE JUMPER WHEN

USING AN EXTERNAL

SPEAKER

SPKR SPKR MIC (-) MIC (+)

P R

N

H O

A A

Ask about the Linear VB-2

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Linear VB-2

Be the first to ask — other owners or our team will answer.

Original document

Linear VB-2 manual PDF

1 pages·196 KB·Home Security System·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…