
DESCRIPTION The MCT-3 MegaCode® digital transmitter is a wireless radio control designed for use with automatic garage and gate operators. Each of the three transmitter buttons will send a unique code when pressed. One button can be used to activate the individual’s garage door opener, a second button can operate an access gate, a third button can activate an additional garage door operator or most Linear 318 MHz MegaCode® wireless receivers. MegaCode® transmitters and receivers do not contain a typical “coding switch”. Each transmitter is permanently coded at the factory. The receiver is programmed by “learning” a transmitter’s unique digital code. The receiver will activate only from the “memorized” transmitters. The transmitter is powered by two Type 2032 “coin-cell” batteries. They should last 3 years with normal use. The red indicator on the face of the transmitter will glow when the unit is activated. If the indicator lights dimly, or not at all when transmitting, the batteries need to be replaced. To conserve battery life, an internal timer limits the transmission duration to 10 seconds if a transmitter button is held down.
PROGRAM RECEIVER & TEST TRANSMITTER Refer to the instructions provided with the receiver to set it into “learn” mode. With the receiver ready to learn, press the desired transmitter button to program that button into the receiver’s memory. Repeat to program additional buttons for other receivers.
THE CODE SENT FROM ANY OF THE TRANSMITTER'S THREE BUTTONS CAN BE LEARNED BY A RECEIVER
CHOOSE ONE BUTTON ON THE TRANSMITTER TO CONTROL THE SPECIFIC OPERATOR OR RECEIVER
UP DOWN UP DOWN
TO PROGRAM THE CODE, WITH THE RECEIVER IN LEARN MODE, PRESS THE TRANSMITTER BUTTON TO SEND A SIGNAL TO THE RECEIVER
After programming, test the transmitter from various locations. Be sure the door or gate areas are clear. Activate the transmitter and verify that the receiver triggers the operator(s).
BE SURE THE DOOR OR GATE AREA IS CLEAR!
ACTIVATE THE TRANSMTTER TO TEST THE RECEIVER AND OPERATOR
(760) 438-7000 USA & Canada (800) 421-1587 & (800) 392-0123
Toll Free FAX (800) 468-1340
VISOR CLIP INSTALLATION REPLACING THE BATTERY LINEAR LIMITED WARRANTY This product is warranted to the consumer against defects in material and workmanship for one year from the date of purchase. This warranty applies to first retail buyers of new devices. Warrantor will repair, or at its option, replace, any device it finds that requires service under this warranty, and will return the repaired or replaced device to the consumer at the warrantor’s cost. For warranty service and shipping instructions contact warrantor at the address shown below. Devices must be sent to warrantor for service at owner’s expense. The remedies provided by this warranty are exclusive. Implied warranties under state law are to the one year period of this written warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. In order to be protected by this warranty, save your proof of purchase and send copy with equipment should repair be required. This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. All products returned for warranty service require a Return Product Authorization Number (RPA#). Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
1 TWIST DIME IN SLOT TO OPEN CASE 2
THE VISOR CLIP CAN BE INSTALLED FOR HORIZONTAL OR VERTICAL MOUNTING
SLIDE THE VISOR CLIP INTO ONE OF THE SLOTS ON THE REAR OF THE TRANSMITTER
INSERT TWO NEW TYPE 2032 BATTERIES PLUS SIDE UP THEN REASSEMBLE UNIT
Copyright © 2004 Linear LLC 222267 A
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.