EN
Mini logo
Official user manual

Mini Mini Steamer

4 pages·113 KB·Car·PDF·ENDEFRITNLJA
Mini Mini Steamer
Table of Contents 4 sections Operation Instructions · Model FCL-H08 Mini Steamer · SAVE THESE INSTRUCTIONS · WARNINGS: ShowHide
Page 1 of the Mini Mini Steamer user manual — Model FCL-H08 Mini Steamer
Page 1 · click to enlarge
Page 1
Mini Mini Steamer — Operation Instructions diagram (page 1)
Fig. 1 · Operation Instructions

Operation Instructions

Model FCL-H08 Mini Steamer

TOP: Read all instructions carefully before using this item.

Filling the Steamer with Water

1. Place the steamer on a flat, level surface.
2. Fill the water reservoir with a measuring cup.
3. Never fill the water above MAX mark.
4. Replace the water reservoir cap.

When using your appliance, basic safety precautions should always be taken. Read all instructions

before use. Save this user manual for further reference.

Page 2 of the Mini Mini Steamer user manual — SAVE THESE INSTRUCTIONS
Page 2 · click to enlarge
Page 2

When using your appliance, below basic precautions should always be followed:

1. Read all instructions.
2. To reduce the risk of contact with hot water emitting from steam vents, check appliance before each use by

holding it away from body and operating switch button.

3. Use appliance only for its intended use.
4. To avoid the risk of electric shock, do not immerse the appliance in water or other liquids.
5. Never yank cord to disconnect from outlet; instead, grasp plug and pull it out gently.
6. Do not allow cord to touch hot surfaces. Let appliance cool completely before putting away. Loop cord

loosely around appliance when storing.

7. Always disconnect appliance from electrical outlet when filling with water, emptying, or whenever it is not

being used.

8. Do not operate appliance with a damaged cord, or when the appliance has been dropped or damaged. To

avoid the risk of electric shock, do not attempt to disassemble or repair the appliance, take it to a qualified

service person for evaluation and repair. Incorrect reassembly or repair could cause the risks of fire, electric

shock, or injury to persons while using the appliance.

9. Close supervision is necessary for any appliance being used by or near children. Do not leave appliance

unattended while connected.

10. Burns could occur if touching hot metal parts, hot water, or steam. Be careful when you turn a steam

appliance upside down – there may be hot water in the reservoir.

11. To reduce the likelihood of circuit overload, do not operate another high wattage appliance on the same

circuit.

12. If an extension cord is absolutely necessary, a 10ampere rated cord should be used. Cords rated for less

amperage may overheat. Care should be taken to arrange the cord so that the cord cannot be pulled or

tripped over.

13. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other).

This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug.

If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any

way.

SAVE THESE INSTRUCTIONS

Page 3 of the Mini Mini Steamer user manual — WARNINGS:
Page 3 · click to enlarge
Page 3

WARNINGS:

1. Never fill the water reservoir when the power cord is plugged in.
2. Allow the appliance to cool for at least 5 minutes after it has been used.
3. Never add cold water into hot water tank. Steam may spray out of the filling hole and cause injuries. Always

let the appliance cool before adding water.

Steaming Fabrics and Linens

following steps.

1. Plug the steamer power cord into an electrical outlet. The heat indicator light will illuminate when turned on.
2. The steamer will start to spray after approximately 50 seconds.
3. Direct the steam nozzle towards the material you wish to iron.
4. Keep the flow of steam focused on the material. Using a slight back and forth motion will further enhance

the steaming process.

1. Place the garment on a clean hanger.
2. Begin steaming slowly from the bottom to the top of the garment. The steam will rise along the inside and

outside of the fabric, removing the wrinkles.

3. Periodically point the steamer away from the garment and smooth the fabric with your free hand.
4. Repeat the above steps as necessary until the garment is free of wrinkles.
1. Steaming both sides of the fabric will help to remove stubborn wrinkles.
2. Delicate fabrics need to be steamed carefully to avoid damage caused by water spotting.
3. Drapery and curtains can be steamed while still hanging.
4. Caution should be taken while using a ladder or step ladder. Do not use a stool, chair or revolving chair.
5. To steam towels, handkerchiefs and napkins, hang them over a rod or towel holder.

Steaming Garments · Steaming Tips

Page 4 of the Mini Mini Steamer user manual — WARNINGS:
Page 4 · click to enlarge
Page 4
1. Use distilled water to avoid mineral build-up.
2. Remove all accessories from the steamer.
3. Empty any remaining water into a sink to minimize mineral buildup.
4. Reattach the water reservoir cap. Do not over tighten.
5. It is recommended to store the steamer and any supplied accessories together in the original packaging.
6. Store the steamer in a cool, dry place.

Specification:

ProblemPossible CauseSolution No Light on the switchThe steamer is not plugged in.Plug the steamer power cord into an electrical outlet. The household circuit breaker has been tripped; there is a blown fuse in the electrical circuit.Reset the household circuit breaker or replace the blown fuse. Contact an electrician or your area’s electrical provider. The steamer heats up but there is no steam.The water reservoir is empty.Refill the water reservoir. There is mineral buildup in the steamer.Remove the mineral build –up. The steamer flow light is flashingThere is mineral build-up in the steamer.It is normal for the flow of the steam to stop for a few seconds. If it stays off for a longer period, check for mineral buildup.

Handling and Storing · 220-240V~, 50/60Hz, 800W · Troubleshooting

Fix-it

Troubleshooting

Common problems, likely causes, and what to do.

ProblemPossible causeRemedy
No Light on the switchThe steamer is not plugged in.Plug the steamer power cord into an electrical outlet. p.4
No Light on the switchThe household circuit breaker has been tripped; there is a blown fuse in the electrical circuit.Reset the household circuit breaker or replace the blown fuse. Contact an electrician or your area’s electrical provider. p.4
The steamer heats up but there is no steam.The water reservoir is empty.Refill the water reservoir. p.4
The steamer heats up but there is no steam.There is mineral build- up in the steamer.Remove the mineral build –up. p.4
The steamer flow light is flashingThere is mineral build-up in the steamer.It is normal for the flow of the steam to stop for a few seconds. If it stays off for a longer period, check for mineral build- up. p.4

Ask about the Mini Mini Steamer

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Mini Mini Steamer

Be the first to ask — other owners or our team will answer.

Original document

Mini Mini Steamer manual PDF

4 pages·113 KB·Car·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…