EN
Mini logo
Official user manual

Mini Convertible (R52)

5 pages·263 KB·Car·2004-2008·PDF·ENDEFRITNLJA
Mini Convertible (R52)
Table of Contents 1 sections Installation Instructions ShowHide
Page 1 of the Mini Convertible (R52) user manual — Installation Instructions
Page 1 · click to enlarge
Page 1

Installation Instructions

Page 1 of 5

Audio, iPod Interface Ver 1.0 Accessory Development

SUBJECT iPod® Interface Kit – P/N 65 11 0 392 139 MODEL MINI Cooper (R50): Select Vehicle Production 03/02 – On* MINI Cooper-S (R53): Select Vehicle Production 03/02 – On* MINI Convertible (R52): Select Vehicle Production 09/04 – On* * Not compatible with 6-Disc CD Changer (SA672), Sirius Satellite Radio, or Hands-Free Phone System. SUGGESTED INSTALLATION TIME: 0.5 Hours The instructions below are developed for MINI vehicles and are not be compared to any other existing instructions for vehicles other than MINI. No methods other than those specified in this document are to be used for installation in MINI vehicles. Left and right are determined from driver’s seat. Carefully read all instructions and supplements before proceeding with the installation. Reference should be made to TIS for instructions dealing with a stock part of the vehicle but not stated in detail in these instructions. The instructions were complete and up to date at time of publication; however, changes to the vehicle or installation may have occurred. Please report any problems or changes noted with the installation to BMW Technical Hotline, along with VIN, date of manufacture and as much detail as possible. PARTS INFORMATION Contents of Kit – P/N 65 11 0 392 139

Description QTY MINI Part Number iPod Adapter 1 65 11 0 392 138 iPod I/F cable 1 65 11 0 393 656 Radio I/F cable 1 65 11 0 392 142 Rubber Grommet 1 N/A Owner's Manual 1 65 11 0 392 140 SPECIAL TOOLS Pin Removal Tool – 61 1 134 Crimp Tool – 408 449

 DO IT RIGHT THE FIRST TIME, ON TIME, EVERY TIME   Installation Instruction P/N 01 29 0 393 657 MINI, a division of BMW of North America, LLC © 2004 BMW of North America, LLC

November 2004

Page 2 of the Mini Convertible (R52) user manual — Installation Instructions
Page 2 · click to enlarge
Page 2

Procedure:

Mini Convertible (R52) — Installation Instructions diagram (page 2)
Fig. 1 · Installation Instructions
  • 1. Disconnect negative battery terminal. 2. Remove the following components using information available in TIS:
  • Drivers knee bolster (1)
  • Center dash face (3) (Refer to RA62 21 001)
  • Radio side pillars (4) (Refer to RA51 16 198)
  • Radio (5) (Refer to RA 65 11 030)
  • Glove box (6)
Mini Convertible (R52) — Installation Instructions diagram (page 2)
Fig. 2 · Installation Instructions
3. Remove the blue lock (1) from radio harness by releasing tab and sliding upwards, then remove following terminals (2) using AMP terminal removal tool p/n 61 1 134:
Pin #ColorDescription 9White/RedI-Bus 12BrownGround 15Red/BrownKL 30 16Violet/BlueKL-R
Mini Convertible (R52) — Installation Instructions diagram (page 2)
Fig. 3 · Installation Instructions
4. Cut original terminals off of 4 wires (1) removed from locations 9, 12, 15 &16. Cut wire as close as possible to existing terminal to maintain wire length. 5. Strip 1/8” of wire shielding from 4 wires.
6. Using terminal crimping tool (BMW p/n 408 449 or Snap-on PWC47) crimp new female bullet connectors included in kit onto each of the wires from previous step.
Mini Convertible (R52) — Installation Instructions diagram (page 2)
Fig. 4 · Installation Instructions
ColorLocationDescription Violet/blue1KL-R Red/brown2KL 30 White/red3I-Bus Brown4Ground
Page 3 of the Mini Convertible (R52) user manual — Installation Instructions
Page 3 · click to enlarge
Page 3
Mini Convertible (R52) — Installation Instructions diagram (page 3)
Fig. 5 · Installation Instructions
ColorLocationDescription White/gray9I-Bus Brown12Ground Violet/white16KL-R Red/green15KL-30
9. Remove white 12-pin connector (3) from lower section of radio connector.
Mini Convertible (R52) — Installation Instructions diagram (page 3)
Fig. 6 · Installation Instructions
10. Insert white 12-pin connector (1) from iPod harness (2) into lower left section of radio connector (3). 11. The white 12-pin connector (4) removed from the factory radio connector in Step 9 will not be re-used for this installation.
Mini Convertible (R52) — Installation Instructions diagram (page 3)
Fig. 7 · Installation Instructions
12. Connect 4-pin connectors (1 & 2)
Mini Convertible (R52) — Installation Instructions diagram (page 3)
Fig. 8 · Installation Instructions
13. Locate and drill 5/8” (16mm) hole in glovebox.

A = 1” (25mm) B = 1” (25mm) C = 5/8”(16mm) Ø

Page 4 of the Mini Convertible (R52) user manual — Installation Instructions
Page 4 · click to enlarge
Page 4
Mini Convertible (R52) — Installation Instructions diagram (page 4)
Fig. 9 · Installation Instructions
14. Insert iPod cable (1) through hole in glovebox as indicated.
Mini Convertible (R52) — Installation Instructions diagram (page 4)
Fig. 10 · Installation Instructions
Mini Convertible (R52) — Installation Instructions diagram (page 4)
Fig. 11 · Installation Instructions
16. The flat iPod connector (1) should be located in the glovebox and the 8-pin DIN connector (2) for the adapter box should be routed through the center console to a location behind the radio. 17. Re-connect glovebox vent tube.
18. Re-install glovebox.
Mini Convertible (R52) — Installation Instructions diagram (page 4)
Fig. 12 · Installation Instructions

Caution: Check for bent pins on adapter cables before attaching to iPod adapter. If pins are damaged carefully bend them back into position with a small screwdriver. 19. Slide iPod adaptor fully into foam padding tube (1). 20. Connect white “iPod” adapter cable (2) and black “Radio” adapter cable (3) to iPod adapter, making sure to connect cables in their proper location.

Page 5 of the Mini Convertible (R52) user manual — Installation Instructions
Page 5 · click to enlarge
Page 5
Mini Convertible (R52) — Installation Instructions diagram (page 5)
Fig. 13 · Installation Instructions
21. Mount iPod interface as indicated below radio and secure with cable ties(not included).
22. Re-install all components removed for installation procedure.

VEHICLE CODING There is no vehicle coding required for this installation. TROUBLESHOOTING

  • iPod mode is not selectable from the radio until an iPod is connected. (refer to MINI iPod Interface Owner’s Manual)
  • This iPod Interface is compatible with the following software versions:

o Gen3 iPod – SW 2.2 or newer o Gen4 iPod - SW 3.0 or newer o iPod mini – SW 1.1 or newer If the customer’s iPod or iPod mini has older versions of software, please advise them to upgrade the software before connecting them to the Interface in their MINI vehicles. (refer to MINI iPod Interface Owner’s Manual)

Ask about the Mini Convertible (R52)

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Mini Convertible (R52)

Be the first to ask — other owners or our team will answer.

Original document

Mini Convertible (R52) manual PDF

5 pages·263 KB·Car·2004-2008·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…