Instruction/ maintenance manual of the product WATL26806.0 Weslo
Go to page of 28
Model No. WATL26806.0 Serial No. CAUTION Read all precautions and instruc- tions in this manual before using this equipment. Save this manual for future reference. Serial Number Decal USER'S MANUAL QUESTIONS? As a manufacturer, we are com- mitted to providing complete customer satisfaction.
T ABLE OF CONTENTS IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions. 2. Use the treadmill only as described. 3. Place the treadmill on a level surface, with at least 2.5 m (8 ft.) of clearance behind it and 0.
4 23. DANGER: Always unplug the power c ord immediately after use, before cleaning the treadmill, and before performing the maintenance and adjustment procedures de- s cribed in this manual. Never remove the motor hood unless instructed to do so by an authorized service representative.
5 T hank you for selecting the new WESLO ® C ADENCE C 80 treadmill. The CADENCE C80 treadmill combines advanced technology with innovative design to hel p y ou achieve your fitness goals in the convenience of your hom e.
ASSEMBL Y Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant.
7 1. Make sure that the power cord is unplugged. A ttach a Wheel (95) to each side of the Base (37) with a Wheel Bolt (4), two Wheel Spacers ( 94), and a Nut (12) as shown. D o not over- tighten the Wheel Bolts; the Wheels should turn freely. Identify the Right Upright (39), which has a square hole in the location shown.
4. See the left inset drawing. Identify the two Frame Spacers (45). Open the included packet of g rease, and apply grease to both sides of both Frame Spacers.
9 7. Locate the wire in the upper end of the Right Upright (39). Pull the wire until the end of the Upright Wire (69) is extending from the Right Upright. Then, untie and discard the wire. 39 7 69 Wire 6. Set the Console (68) face down on a soft sur- face to avoid scratching the Console.
10 9 . Finger tighten two Handrail Bolts (9) with two Handrail Star Washers (11) into the Left Upright (38) and the Left Handrail (96). Next, finger tighten two Handrail Bolts (9) with two Handrail Star Washers (11) into the Right Upright (39) and the Right Handrail (40).
1 1 11. Attach the ground wire on the Upright Wire (69) to the indicated hole in the Base (37) with a S ilver Ground Screw (10). P ress the indicated grommet into the Right Upright (39). 37 6 9 39 Grommet 11 10 Ground Wire 13. Make sure that all parts are properly tightened before you use the treadmill.
12 OPERA TION AND ADJUSTMENT THE PRE-LUBRICATED WALKING BELT Your treadmill features a walking belt coated with high-performance lubricant. IMPORTANT: Never apply sili- cone spray or other substances to the walking belt or the walking platform. Such substances will deterio- r ate the walking belt and cause excessive wear.
13 FEATURES OF THE CONSOLE The treadmill console offers a selection of features designed to make your workouts more effective. When you select the manual mode of the console, you can chang e the spee d and incline of the treadmill with the touch of a button.
14 H OW TO USE THE MANUAL MODE Insert the key into the console. See HOW TO TURN ON THE POWER on page 1 3. Select the manual mode. When you insert the key, the manual mode will be selected. If you have selected a preset program, reselect the manual mode by press- ing the Program Select button repeatedly until a track appears in the matrix.
15 The upper display can show the elapsed time ( or the time remaining in a program), the dis- t ance that you have walked or run, the ap- proximate number of calories you have burned, and the speed of the walking belt. Press the Display button repeatedly until the upper display shows the information that you are most interested in viewing.
16 H OW TO USE A PRESET PROGRAM I nsert the key into the console. S ee HOW TO TURN ON THE POWER on page 13. S elect a preset program. To select one of the four preset programs, press the Program Select button repeat- edly until “P1,” “P2,” “P3,” or “P4” appears in the upper display.
17 H OW TO USE THE STEREO SOUND SYSTEM To play music or audio books through the console’s stereo speakers, you must connect your MP3 player or CD player to the console. Plug one end of the included 3 .5mm to 3.5mm stereo audio wire into a jack on your MP3 player or CD player.
18 HOW T O FOLD AND MOVE THE TREADMILL HOW TO FOLD THE TREADMILL FOR STORAGE Before folding the treadmill, adjust the incline to the lowest position. If you do not do this, you may damage the t readmill when you fold it. Next, unplug the power cord. CAUTION: You must be able to safely lift 20 kg (45 lbs.
19 HOW TO LOWER THE TREADMILL FOR USE 1. Hold the treadmill with your right hand as shown. Pull the latch knob to the left and hold it. Pivot the frame down until it is past the latch pin and release the latch knob. 2. Hold the metal frame firmly with both hands , and lower it to the floor.
20 TROUBLESHOOTING Most treadmill problems can be solved by following the steps listed below. Find the symptom that ap- plies, and follow the steps listed. If you need further assistance, please see the front cover of this manual. PROBLEM: The power does not turn on S OLUTION: a .
21 Locate the Reed Switch (59) and the Magnet (83) on the left side of the Pulley (86). Turn the Pulley until t he Magnet is aligned with the Reed Switch. M ake sure that the gap between the Magnet and the R eed Switch is about 3 mm (1/8 in.). I f necessary, loosen the Screw (10), move the Reed Switch slightly, and then retighten the Screw.
22 CONDITIONING GUIDELINES The following guidelines will help you to plan your ex- ercise program. For more detailed exercise informa- tion, obtain a reputable book or consult your physician.
23 SUGGESTED STRETCHES T he correct form for several basic stretches is shown at the right. Move slowly as you stretch—never bounce. 1 . Toe Touch Stretch Stand with your knees bent slightly and slowly bend forward from your hips. Allow your back and shoulders to relax as you reach down toward your toes as far as possible.
P ART LIST—Model No. W A TL26806.0 R1206A Key No. Qty. Description Key No. Qty. Description 1 2 Frame Bolt 2 1 Console Cover 3 15 3/4" Screw 4 2 Wheel Bolt/Upright Bolt 5 1 On/Off Switch 6 5 Up.
30 3 10 75 31 12 59 85 12 20 50 84 15 20 82 81 26 17 47 48 21 21 22 32 57 22 8 19 14 19 8 86 58 22 32 26 36 55 47 48 78 50 17 32 32 83 87 43 43 10 26 26 26 54 29 10 26 26 26 29 88 88 76 35 35 3 35 35 3 72 25 EXPLODED DRA WING A—Model No. W A TL26806.
23 7 41 25 24 73 49 64 10 12 12 31 60 23 7 18 6 61 16 18 62 10 10 28 28 80 66 22 28 10 42 44 3 56 63 46 12 10 22 22 27 33 71 70 74 100 5 101 EXPLODED DRA WING B—Model No.
39 69 9 11 52 51 22 7 1 52 45 6 4 6 4 51 69 10 51 95 4 94 94 12 51 22 12 4 92 89 89 95 94 94 37 22 22 3 53 53 40 34 3 34 11 9 3 3 3 10 68 67 3 3 3 3 3 3 91 38 45 1 7 3 93 3 53 53 96 34 34 11 9 9 11 3 3 3 2 98 100 13 77 65 77 65 65 90 79 90 79 99 97 27 EXPLODED DRA WING C—Model No.
Part No. 243267 R1206A Printed in China © 2006 ICON IP, Inc. ORDERING REPLACEMENT P ARTS To or der r eplac ement parts , please call the telephone number on the warranty card accompanying this manual. T o help us assist you, be prepared to provide the following information: • the MODEL NUMBER of the product (WATL26806.
An important point after buying a device Weslo WATL26806.0 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Weslo WATL26806.0 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Weslo WATL26806.0 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Weslo WATL26806.0 you will learn all the available features of the product, as well as information on its operation. The information that you get Weslo WATL26806.0 will certainly help you make a decision on the purchase.
If you already are a holder of Weslo WATL26806.0, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Weslo WATL26806.0.
However, one of the most important roles played by the user manual is to help in solving problems with Weslo WATL26806.0. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Weslo WATL26806.0 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
