EN
Linear logo
Official user manual

Linear LMT-1

2 pages·43 KB·Satellite Radio·PDF·ENDEFRITNLJA
Linear LMT-1
Table of Contents 25 sections (619) 438-7000 • FAX (619) 438-7043 · Instruction Manual · TRANSMITTER CODING · Transmitter · … ShowHide
Page 1 of the Linear LMT-1 user manual — IMPORTANT !!!
Page 1 · click to enlarge
Page 1

The LMT-1 is a compact, light-weight, wireless transmitter. When

activated by pressing the button for two seconds, it will trigger the

The unit can be used on a key ring or worn suspended from a

The LMT-1 incorporates Linear’s proprietary “MegaCode” circuit

that provides each transmitter with over one million security

A Duracell MN21 battery powers the transmitter. The red LED on

Each LMT-1 transmitter has been pre-programmed at the factory

to one in a million codes. The transmitter will retain its

Refer to the receiver’s instructions for details on programming the

transmitter into the receiver. Most receivers have a “learning” or

“program” mode. Triggering the transmitter with the receiver in a

“learning” mode will cause the transmitter’s code to be entered

the front of the transmitter will light when the unit is activated.

USA & Canada (800) 421-1587 & (800) 392-0123

remote receiver programmed to recognize the transmitter.

neck chain. A neck chain is packaged with the LMT-1.

pre-programmed code even with low or no batteries.

(619) 438-7000 • FAX (619) 438-7043

Toll Free FAX (800) 468-1340

Instruction Manual

TRANSMITTER CODING

into the receiver’s memory.

Transmitter

INTRODUCTION

Portable

LMT-1

codes.

This Linear product is warranted against defects in material and

workmanship for twelve (12) months. The Warranty Expiration

Date is labeled on the product. This warranty extends only to

wholesale customers who buy direct from Linear or through

Linear’s normal distribution channels. Linear does not warrant

this product to consumers. Consumers should inquire from

their selling dealer as to the nature of the dealer’s warranty, if any.

There are no obligations or liabilities on the part of Linear

Corporation for consequential damages arising out of or in

connection with use or performance of this product or other

indirect damages with respect to loss of property, revenue,

or profit, or cost of removal, installation, or reinstallation. All

implied warranties, including implied warranties for

merchantability and implied warranties for fitness, are valid only

until Warranty Expiration Date as labeled on the product. This

Linear Corporation Warranty is in lieu of all other warranties

For warranty service on Linear equipment return product, at

Linear radio controls provide a reliable communications link and fill an

1 For U.S. installations onlyThe radios are required to comply with FCC Rules

and Regulations as Part 15 devices. As such, they have limited transmitter

1 A receiver cannot respond to more than one transmitted signal at a time and

may be blocked by radio signals that occur on or near their operating

1 Infrequently used radio links should be tested regularly to protect against

1 A general knowledge of radio and its vagaries should be gained prior to acting

as a wholesale distributor or dealer, and these facts should be communicated

1 This device complies with FCC Rules Part 15. Operation is subject to the

following two conditions(1) This device may not cause harmful interference

and (2) this device must accept any interference that may be received,

Copyright © 1993 Linear Corporation 208378 A

1 Changes or modifications to the device may void FCC compliance.

including interference that may cause undesired operation.

frequencies, regardless of code settings.

LINEAR LIMITED WARRANTY

limitations which must be observed.

power and therefore limited range.

2580 Pioneer Avenue, Suite C Vista, CA 92083

undetected interference or fault.

express or implied.

sender’s expense to:

to the ultimate users.

IMPORTANT !!!

Linear Service Center

Page 2 of the Linear LMT-1 user manual — DOOR
Page 2 · click to enlarge
Page 2

When the transmitter button is pressed, the red LED should light

indicating that the unit is transmitting and the battery is good. If

the LED does not light, the battery is low, dead or installed

Operate the transmitter from various locations to identify any

weak signal areas or “dead spots” that may be caused by

1 IMPORTANT: The transmitter button must be pressed for two seconds to activate the receiver.

WHEN CHANGING THE

IMPORTANT!

BATTERY, INSERT

THE NEGATIVE (-)

Figure 2. Proper Installation of Battery

END FIRST

interference or certain metal obstacles.

INTO TRANSMITTER LAST

PUSH POSITIVE (+) END

TESTING

incorrectly.

To send a signal to the receiver, a single button on the face of the

transmitter must be pressed for a minimum of two seconds. When

The maximum transmitting range is determined by the receiver

Under normal conditions, the 12 volt Duracell MN21 battery

When the battery gets low, the red LED will flicker dimly when the

The LMT-1 uses a 12 volt Duracell type MN21 battery or

1. Twist the key chain loops and remove the battery door
2. Carefully remove the old battery and discard according
3. Install a fresh battery as shown in Figure 2. R e p l a c e

BATTERY LIFE & LOW BATTERY INDICATION

TWIST

LOOPS

the unit is sending a signal, the red LED will light.

Figure 1. Removing Battery Door

used, and various conditions in the installation.

to the manufacturers recommendations.

TRANSMITTING RANGE

CHANGING BATTERIES

OPERATING THE UNIT

should last 12 to 18 months.

the transmitter battery door.

REMOVE

unit is activated.

DOOR

(see Figure 1).

equivalent.

Ask about the Linear LMT-1

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Linear LMT-1

Be the first to ask — other owners or our team will answer.

Original document

Linear LMT-1 manual PDF

2 pages·43 KB·Satellite Radio·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…