EN
Linear logo
Official user manual

Linear 3089

2 pages·49 KB·Satellite Radio·PDF·ENDEFRITNLJA
Linear 3089
Table of Contents 9 sections DIGITAL TRANSMITTER MODEL 3089 · INSTALLATION INSTRUCTIONS · ACCESSING THE CODE SWITCH · LINEAR LLC · … ShowHide
Page 1 of the Linear 3089 user manual — LINEAR LLC
Page 1 · click to enlarge
Page 1

Congratulations! You have just purchased a MULTI-CODE Digital Transmitter,

which we believe to be the fi nest product of its kind on the market. With a little

care this transmitter should provide you with many years of excellent service.

Please take a moment to read the following instructions and you will fi nd that setting

Insert a small coin into the slot located at the bottom end of the transmitter. Twist

the coin and remove the access cover to expose the code switch and battery

DIGITAL TRANSMITTER MODEL 3089

INSTALLATION INSTRUCTIONS

your new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH

compartment.

To check operation, move back a reasonable distance (about 50 ft.) and press

the transmitter button. Operation should be reliable at this distance but

environment and location of both the transmitter and receiver will affect the

range. If the transmitter is stowed well out of sight, it may be necessary to

remove it from its mounting and hold near the windshield. Try different locations

and positions. If operation is still unsatisfactory, the problem may be isolated by:

1. Checking the door operator. If the door will not open when the wall button is pressed, the problem is likely to be the operator. If the door will open by pressing

the wall button, but not when the radio control button is pressed, the problem is

2. Replacing the transmitter battery. If after performing the above operational checks, the controls still do not function, they should be returned to your dealer for

which are not expressly approved by LINEAR LLC could void the user’s authority

to operate this equipment. This applies to intentional and unintentional radiators

Copyright © 2008 Linear LLC 215641 B

(800) 421-1587 • (760) 438-7000

certifi ed per Part 15 of the F.C.C. rules and regulations.

www.linearcorp.com

LINEAR LLC

OPERATIONAL CHECK

probably in the radios.

repair or replacement.

®

Page 2 of the Linear 3089 user manual — SELECTING A CODE
Page 2 · click to enlarge
Page 2

The transmitter is completely self contained, including battery, and can be

operated while mounted in the car. It is supplied with a clip for attaching to the

sun visor, if desired. If the clip is used attach to the case by sliding it into the

recess provided on the back of the transmitter until the small dimples fi t into the

The battery in the transmitter can be checked or changed by removing the front

lower half of the transmitter. Refer to the directions under “accessing the code

A replacement or new transmitter or receiver may be purchased by specifying the

Model Number and the RF frequency designated on the identifi cation label. The

RF frequency is set at the factory and must not be adjusted in the fi eld. The digital

code can be matched to the companion receiver or transmitter by following the

Replacement battery - 9 volt NEDA 1604 (Eveready 216 or equivalent).

TRANSMITTER BATTERY REPLACEMENT

switch” for battery replacement.

TRANSMITTER INSTALLATION

TO REPLACE OR ADD A SET

holes in the clip.

above procedure.

You may set your transmitter to any code you desire but be sure that the code you

set matches the code that has been set on your radio receiver. The digital code

is determined by the positions of the 10 small switches numbered 1 through 10

located in the receiver and transmitter. Any combination of ON (CLOSED) or OFF

(OPEN) positions can be selected by using a small screwdriver or ball point pen.

(NOTEThe switches are in the “On” position when the side next to the number

is pressed in.) In setting your own personal code we strongly urge that several

coding schemes be avoided: ALL ON; ALL OFF; 2,4,6,8,10 ON; 1,3,5,7,9 ON.

These positions are similar to our or other manufacturer’s test positions, or are

frequently used. Once the code has been set, check the operation and replace

SELECTING A CODE

the hatches.

Sources

References & links

Pages referenced in this manual — manufacturer, support and downloads.

Ask about the Linear 3089

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Linear 3089

Be the first to ask — other owners or our team will answer.

Original document

Linear 3089 manual PDF

2 pages·49 KB·Satellite Radio·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…