EN
Linear logo
Official user manual

Linear 3089

2 pages·21 KB·Satellite Radio·PDF·ENDEFRITNLJA
Linear 3089
Table of Contents 10 sections DIGITAL TRANSMITTER MODEL 3089 · INSTALLATION INSTRUCTIONS · ACCESSING THE CODE SWITCH · LINEAR CORPORATION · … ShowHide
Page 1 of the Linear 3089 user manual — LINEAR CORPORATION
Page 1 · click to enlarge
Page 1

Congratulations! You have just purchased a MULTI-CODE Digital Transmitter,

which we believe to be the finest product of its kind on the market. With a little

care this transmitter should provide you with many years of excellent service.

Please take a moment to read the following instructions and you will find that setting

On the model 3089 the entire front lower half of the transmitter is removable.

Grasp the front lower half of the case near the bottom on both sides and pull

upward away from the transmitter, this will disengage the lower end. Then pull

downward to remove the lower cover, this will expose both the code switch and

DIGITAL TRANSMITTER MODEL 3089

INSTALLATION INSTRUCTIONS

your new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH

battery compartment.

To check operation, move back a reasonable distance (about 50 ft.) and press the

transmitter button. Operation should be reliable at this distance but

environment and location of both the transmitter and receiver will affect the

range. If the transmitter is stowed well out of sight, it may be necessary to

remove it from its mounting and hold near the windshield. Try different locations

1. Checking the door operator. If the door will not open when the wall button is pressed, the problem is likely to be the operator. If the door will open by pressing

the wall button, but not when the radio control button is pressed, the problem is

2. Replacing the transmitter battery. If after performing the above operational checks, the controls still do not function, they should be returned to your dealer for

radiators which are not expressly approved by LINEAR CORPORATION could

void the user’s authority to operate this equipment. This applies to intentional

and unintentional radiators certified per part 15 of the F.C.C. rules and

Copyright © 1999 Linear Corporation 215641 A

and positions. If operation is still unsatisfactory, the problem may be isolated by:

2055 Corte del Nogal • Carlsbad, CA 92009 (760) 438-7000

LINEAR CORPORATION

OPERATIONAL CHECK

probably in the radios.

repair or replacement.

regulations.

®

Page 2 of the Linear 3089 user manual — OPEN
Page 2 · click to enlarge
Page 2

The transmitter is completely self contained, including battery, and can be

operated while mounted in the car. It is supplied with a clip for attaching to the

sun visor, if desired. If the clip is used attach to the case by sliding it into the

recess provided on the back of the transmitter until the small dimples fit into the

The battery in the transmitter can be checked or changed by removing the front

lower half of the transmitter. Refer to the directions under “accessing the code

A replacement or new transmitter or receiver may be purchased by specifying

the Model Number and the RF frequency designated on the identification label.

The RF frequency is set at the factory and must not be adjusted in the field. The

digital code can be matched to the companion receiver or transmitter by

Replacement battery - 9 volt NEDA 1604 (Eveready 216 or equivalent).

TRANSMITTER BATTERY REPLACEMENT

TRANSMITTER INSTALLATION

switch” for battery replacement.

TO REPLACE OR ADD A SET

following the above procedure.

holes in the clip.

You may set your transmitter to any code you desire but be sure that the code you

set matches the code that has been set on your radio receiver. The digital code is

determined by the positions of the 10 small switches numbered 1 through 10

located in the receiver and transmitter. Any combination of ON (CLOSED) or OFF

(OPEN) positions can be selected by using a small screwdriver or ball point pen.

(NOTEThe switches are in the “On” position when the side next to the number

is pressed in.) In setting your own personal code we strongly urge that several

coding schemes be avoided: ALL ON; ALL OFF; 2,4,6,8,10 ON; 1,3,5,7,9 ON.

These positions are similar to our or other manufacturer’s test positions, or are

frequently used. Once the code has been set, check the operation and replace

1 2 3 4 5 6 7 8 9 10

OPEN

SELECTING A CODE

the hatches.

Ask about the Linear 3089

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Linear 3089

Be the first to ask — other owners or our team will answer.

Original document

Linear 3089 manual PDF

2 pages·21 KB·Satellite Radio·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…