Instruction/ maintenance manual of the product tr 8500 Life Fitness
Go to page of 8
TREADMILL INSTALLATION INSTRUCTIONS.
Congratulations... and welcome to the world of and the Life Fitness 8500 treadmill. The following Parts Identification Listing and the step by step installation procedures have been assembled to make the set-up of your aerobic trainer as quick and easy as possible.
S A F E T Y F I R S T ! ⇒ DO NOT position the rear of the treadmill within 3 feet ( 1 meter ) of the nearest obstruction. Life Fitness recommends a clearance of 6 feet ( 2 meters ) at the rear of the treadmill. The sides of the treadmill should maintain a minimum clearance of 8 inches ( 21 cm ) from the nearest treadmill or other obstruction.
T OOLS R EQUIRED FOR A SSEMBLY ... Phillips screwdriver, Hex key wrench set P ARTS D ESCRIPTION 1 DISPLAY CONSOLE ASS’Y AK45-00036-0001 Qty: 1 2 CENTER SUPPORT AK36-00072-0000 Qty: 1 3 DISPLAY CONSO.
Step 1 Untie and uncoil the WIRE HARNESS attached to the front, right side of the treadmill. Pull gently on the HARNESS to remove any slack. Step 2 Place the RIGHT HANDRAIL next to the treadmill and feed the WIRE HARNESS CONNECTOR into the slot located at the bottom of the RIGHT HANDRAIL (#10) until it exits through the top opening.
Step 4 Snap together the male and female 10-PIN CONNECTORS protruding from the top of the RIGHT HANDRAIL (#10) and the underside of the HANDLEBAR ASSEMBLY (#5).
Step 10 Open the WAX KIT (#20) and install the WAX according to the directions provided on the Instruction Sheet enclosed within the WAX KIT. WARNING: DO NOT OPERATE THE LIFE FITNESS 8500 TREADMILL PRIOR TO INSTALLING THE WAX ACCORDING TO THE INSTRUCTIONS ENCLOSED WITHIN THE WAX KIT.
OPERATION CHECKLIST ⇒ Make sure the HANDLEBAR and HANDRAIL BOLTS are tight. ⇒ Make sure the STRIDING BELT is properly centered or tracked. ⇒ Check the operation of the STOP KEY. ⇒ Check to insure that the POWER CORD is not located beneath or alongside the machine.
An important point after buying a device Life Fitness tr 8500 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Life Fitness tr 8500 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Life Fitness tr 8500 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Life Fitness tr 8500 you will learn all the available features of the product, as well as information on its operation. The information that you get Life Fitness tr 8500 will certainly help you make a decision on the purchase.
If you already are a holder of Life Fitness tr 8500, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Life Fitness tr 8500.
However, one of the most important roles played by the user manual is to help in solving problems with Life Fitness tr 8500. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Life Fitness tr 8500 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
