Instruction/ maintenance manual of the product g7 Life Fitness
Go to page of 21
G7 CABLE MOTION ™ GYM SYSTEM USER GUIDE W ARNING: Read and follow all directions for each step to insure proper assembly of this product. CLASS H P ART # 8352100 REV .
2 T ABLE OF CONTENTS Safety S tatement . . . . . . . . . . . . . . . .2 Assembly Instructions . . . . . . . . . . . . . .7 Gym Dimensions. . . . . . . . . . . . . . . . .3 General Maintenance . . . . . . . . . . . . . .19 Components List . . . . . . .
3 GYM DIMENSIONS Weight: 720 lbs Resistance Ratio: 1:2.
ITEM NO. QTY . P ART NO. DESCRIPTION 1 1 8172901 LEFT TOWER 2 1 8178003 TOP BRACKET TUBE 3 1 8178002 MIDDLE BRACKET TUBE 4 1 8178004 BOTTOM BRACKET TUBE 5 1 8351601 LEFT SLIDE TUBE (WITH ROLLER CARRIA.
5 HARDW ARE LISTED BELOW ITEM NO. QTY . P ART NO. DESCRIPTION 26 32 3256201 M10 X20MM SCREW 27 52 3264201 M10 W ASHER 28 20 3242201 M5 HEX SCREW 29 20 3264101 M6 W ASHER 30 4 3256208 M10 X 55MM SCREW .
6 HARDW ARE:.
7 NOTE: T wo person assembly is recommended. STEP 1: Make sure the LEFT TOWER (1) and the RIGHT TOWER (1 1) are positioned correctly prior to assembly . The LEFT U BRACKET (A) and RIGHT U BRACKET (B) should point towards each other as shown in the above illustration.
8 STEP 2: Attach the CHIN UP BAR (12) between the LEFT TOWER (1) and RIGHT TOWER (1 1) using four M10 x 70mm SCREWS (33), eight M10 W ASHERS (27), and four M10 HEX NYLOCK NUTS (32). Finger tighten only . NOTE: Make sure the CHIN UP BAR (12) is in the correct position as shown.
9 STEP 3: Slide the top of the LEFT SLIDE TUBE ASSEMBL Y (5) over the UPPER BRACKET (C) on the LEFT T OWER (1). NOTE: MAKE SURE THE ENGRA VED NUMBERS ON THE LEFT SLIDE TUBE ASSEMBL Y (5) F ACE THE INSIDE OF THE GYM. NOTE THE ORIENT A TION OF THE CARRIAGE.
10 STEP 4: Remove the protective paper from the SIDE SHROUD (23) before installation. Install one SIDE SHROUD (23) to the RIGHT TOWER (1 1) using sixteen M5 SHOULDER SCREWS (39) on the inside of the SIDE SHROUD (23) into the UPRIGHT TUBES (E) of the RIGHT TOWER (1 1).
11 STEP 5 NOTE: INST ALL FROM THE INSIDE OF THE UNIT . Position two WEIGHT ST ACK CUSHIONS (20) and GUIDE RODS (16) at the GUIDE ROD BRACKET (G) on the RIGHT TOWER (1 1) as shown. NOTE: MAKE SURE THA T THE PLUGGED END OF THE GUIDE RODS (16) ARE F ACING UP .
12 STEP 6: Uncoil cables to remove all twists. Remove the UPPER PULLEYS (H) on the RIGHT TOWER (1 1) and LEFT TOWER (1) by removing the M10 x 50mm SCREW (I), PULLEY RET AINER (J), M10 SOCKET HEAD NUT (K), and P ARTIAL PULLEY COVERS (L). Set the UPPER PULLEYS (H) and hardware aside.
13 STEP 7: Insert the threaded end of the CABLE (21) where UPPER PULLEY (H) was located. Lower the CABLE (21) down the long vertical tube that is in front of the gym until it can be retrieved near where the LOWER PULLEY (M) was located. Carefully pull enough cable out to reach the ROLLER CARRIAGE (Q).
14 STEP 8: Dissemble one QUICK CONNECT by removing the two M5 HEX SCREWS (T) from the QUICK CONNECT COU- PLER (U). Carefuly remove the QUICK CONNECT SPRING (V), the QUICK CONNECT SLEEVE (W) and the QUICK CONNECT HOUSING (X). Slide the QUICK CONNECT HOUSING (X), QUICK CONNECT SPRING (V), and QUICK CONNECT SLEEVE (W) onto the cable as shown.
15 STEP 9: Make adjustments to the HEAD PLA TE PULLEY (19) and the threaded cable end to adjust cable length and to ensure the cable is taut. If the threaded cable end is completely threaded into the ROLLER CARRIAGE (Q) and there is still some slack in the CABLE (21), remove the pulley from the HEAD PLA TE PULLEY (19).
16 STEP 10: Install the FOOT EXTENSIONS (22) to the BOTTOM BRACKET TUBES (4) using four M10 x 20mm SCREWS (26) and four M10 W ASHERS (27) on each side.
17 STEP 1 1: Attach the six KIOSK BRACKETS (24) to the RIGHT TOWER (1 1) and LEFT TOWER (1) using two M5 HEX SCREWS (28) and two M6 W ASHERS (29) each. T ighten the screws securely . Fasten the KIOSK (25) to the KIOSK BRACKETS (24) using twelve M10 x 20mm SCREWS (40) and twelve 10.
18 STEP 12: Adjust the rollers if the ROLLER CARRIAGE (Q) rolls up and down the tube with difficulty , or if it seems to sloppy . Unscrew the cable end from the roller carriage housing. Remove the SCREWS (Y) that hold the two PLASTIC COVERS (Z) together .
19 MAINTENANCE Please note: * W e recommend cleaning your product (pads and frame) on a regular basis, using warm soapy water . T ouch-up paint can be purchased from your Life Fitness cus- tomer service representative at (800) 351-3737. * Inspect equipment daily .
20 LIMITED W ARRANTY Life Fitness® G7 Cable Motion™ Gym System Life Fitness extends the following LIMITED W ARRANTY to the original owner (proof of purchase required, keep your receipt with this manual) of the Life Fitness product. The W arranty terms apply to IN HOME and LIGHT INSTITUTIONAL USE ONL Y .
LIFE FITNESS 5100 NOR TH RIVER ROAD. SCHILLER P ARK, IL 60176 U.S.A. T el: 1.847.288.3300 Fax: 1.800.216.8893 1.800.351.3737 (T oll-free within the U.S.
An important point after buying a device Life Fitness g7 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Life Fitness g7 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Life Fitness g7 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Life Fitness g7 you will learn all the available features of the product, as well as information on its operation. The information that you get Life Fitness g7 will certainly help you make a decision on the purchase.
If you already are a holder of Life Fitness g7, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Life Fitness g7.
However, one of the most important roles played by the user manual is to help in solving problems with Life Fitness g7. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Life Fitness g7 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
