Instruction/ maintenance manual of the product BCE 5224IM BTC
Go to page of 20
CD-WRITER 5224IM CD-ReWritable Drive User’s Manual.
CLASS 1 LA SER PRODUCT APPA REIL A LA SER DE CLASSE 1 LASER KLA SSE 1 LUOKAN 1 LA SERLAITE PRODUIT LASER CATEGORIE 1 DANGER INVISIBLE LASER RADIATION WHEN O PEN AVOID DIRECT EXPOSURE TO BEAM VORSICHT INSICHTBARE LASERSTRAHLUNG WENN ABDECKUNG GEÖFFNET NICHT DEM STRAHL AUSSETSEN ATTENTION RADIATIO N DU FAISCEAU LASER INVISIBLE EN CAS D’OUVERTURE.
FCC Compliance Statement This device complies with Part 15 of the FCC Ru les. Operation is subject to the following two condit ions: 1. this device ma y not cause harmful interference, and 2. this device must accept any interferen ce received, including interference that may cause undesired operat ion.
Table of Contents INTRODUCTION 1 S YSTEM R EQUIREMENTS 1 P ACKAGE C ONTENTS 2 INSTALLATION 3 H OST I NTERFACE C ONNECTIONS 3 H ARDWARE I NSTALLATION 4 D RIVER I NSTALLATION 6 Windows Environment 6 S O.
CD-WRITER 5224IM 1 INTRODUCTION CD-WRITER 5224IM is a half-height CD-ReWritable drive of standard IDE interface. It supports maximu m 52x speed writing ability on CD-R discs, 24x speed on CD-RW discs and 52x speed reading performance.
CD-WRITER 5224IM ♦ PC sufficient to run Windows 95/98/ME or WindowsNT/2000/XP ♦ Pentium II 350MHz above with at least 64MB of memory ♦ Fast and sufficient hard disk space (minimum 200MB for installation, 1GB or more is recommended.
CD-WRITER 5224IM INSTALLATION Host Interface Connections Most current mainboard models have two IDE ports (primary and secondary) which can connect two IDE cables. Two IDE cables allow you to connect up to four dev ices, but it is recommended that you separate IDE ports for your hard drive and your CD-ReWritable drive.
CD-WRITER 5224IM 4 You may consider one of the two ways recommended below to connect your drive. ♦ To get the most stable performance for the CD-RW drive to write: Primary IDE Master: Hard Disk Prim.
CD-WRITER 5224IM The red-edge of the IDE Cable must be connected to Pin 1 on the CD- ReWritable drive. 5. If you have a sound card that can be connected to this CD- ReWritable drive, you can connect the drive (as Audio-out) and the sound card (as Audio-in) with a 4- pin audio cable.
CD-WRITER 5224IM 6 Driver Installation Windows Environment CD-WRITER 5224IM is a PnP device, and Windows 95/98/ME and Windows NT/2000/XP can automatically detect the drive and load the appropriate driver. If Windows c annot detect the drive, you can operate manually: 1.
CD-WRITER 5224IM CONNECTION & OPERATION Front Panel BUSY 1. Headphone Plug By plugging in the headphone jack here, you can listen to an audio CD (CD-DA disc) directly playing from the CD-ReWritable drive. 2. Headphone Volume Control This knob adjusts the audio output level.
CD-WRITER 5224IM this hole for manual ejection. Please make sure to power off the system before you do that. 6. Play/Skip button Press this butt on to play tracks or skip to next track during the playing state. 7. Close/Eject button This button opens and closes the disc tray.
CD-WRITER 5224IM 9 3. Device Configuration Jumper Set the jumper to Master, Slave or Cable Select according to your system configuration. 4. IDE Interface Connector Plug one end of the 40-pin IDE cable here to join the 40-pin IDE connector on the motherboard.
CD-WRITER 5224IM 10 TECHNICAL DATA Performance Transfer rate Read : CD-ROM/CD-R 7800kb/s(up to 52X) CD-RW 4800 kb/s(up to 32X) Write: CD-R 7800kb/s (up to 52X) CD-RW 3600kb/s (up to 24X) Access time 8.
CD-WRITER 5224IM 11 Disc loading Tray (motorised) Audio output level Line out = 0.6 ± 10%Vrms Headphone out = 0.6± 10%Vrms Power 5 VDC & 12VDC Dimensions Height 41.
CD-WRITER 5224IM 12 Operating temperature 5°C to 45°C Non-operating temperature -20°C to 60°C Humidity Operating humidity 8% ~ 80%RH Non-operating humidity 5% ~ 95%RH.
CD-WRITER 5224IM 13 TROUBLESHOOTING To help you get more familiar with CD-WRITER 5224IM, the following FAQ lists some common problems you might encounter. Please read it for reference before you request RM A support from your dealer. Q1. CD-WRITER 5224IM cannot be recognized.
CD-WRITER 5224IM 14 (1) Please check if the audio cable is connected to the audio connector properly. (2) Check both rear side of the CD-RW drive and sound card on M/B (If Audio chipset is on board). If they are well connected, check if the sound card is working.
CD-WRITER 5224IM 15 (4) Increase main memory capacity. (5) Select other burning software. (6) De-fragment the hard disk. (7) Keep the source & destination discs clean. (no scratches, fingerprints or contamination.) (8) Copy data as image file to hard drive to avoid buffer underrun.
3100551170 Version 1.1 Jan. 2003.
An important point after buying a device BTC BCE 5224IM (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought BTC BCE 5224IM yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data BTC BCE 5224IM - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, BTC BCE 5224IM you will learn all the available features of the product, as well as information on its operation. The information that you get BTC BCE 5224IM will certainly help you make a decision on the purchase.
If you already are a holder of BTC BCE 5224IM, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime BTC BCE 5224IM.
However, one of the most important roles played by the user manual is to help in solving problems with BTC BCE 5224IM. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device BTC BCE 5224IM along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
