

ance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid dam- aging the cooling unit, especially at the rear near the heat exchanger. The ma- terials used on this appliance marked by the symbol are recyclable.
This appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insula- tion materials. The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appli-
Switching on Insert the plug into the wall socket. Turn the Temperature regulator clockwise to a medium setting.
A medium setting is generally the most suitable.
Switching off To turn off the appliance, turn the Tempera- ture regulator to the "O" position.
Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accesso- ries with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly.
Environment Protection · Temperature Indicator

The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired.
Positioning the door shelves
To permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposi- tion as required.
Meat (all types) : wrap in polythene bags and place on the glass shelf above the veg- etable drawer. For safety, store in this way only one or two days at the most. Cooked foods, cold dishes, etc..: these should be covered and may be placed on any shelf. Fruit and vegetables: these should be thor- oughly cleaned and placed in the special drawer(s) provided. Butter and cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to exclude as much air as possible. Milk bottles: these should have a cap and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigera- tor.
Movable shelves

Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply.
This appliance contains hydrocarbons in its cooling unit; maintenance and re- charging must therefore only be carried out by authorized technicians.
Clean the condenser (black grill) and the compressor at the back of the appliance with a brush. This operation will improve the performance of the appliance and save electricity consumption.
Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special contain- er at the back of the appliance, over the motor compressor, where it evaporates. Periodically clean the defrost water drain hole in the middle of the refrigerator com- partment channel to prevent the water overflowing and dripping onto the food in- side. Use the special cleaner provided, which you will find already inserted into the drain hole.

Problem Possible cause Solution
The appliance does not operate. The lamp does not operate.
The appliance is switched off. Switch on the appliance.
The mains plug is not connected to the mains socket correctly.
Connect the mains plug to the mains socket correctly.
The appliance has no power. There is no voltage in the mains socket.
Connect a different electrical ap- pliance to the mains socket. Contact a qualified electrician.
The lamp does not work. The lamp is in stand-by. Close and open the door.
The lamp is defective. Refer to "Replacing the lamp".
The compressor oper- ates continually.
The temperature is not set cor- rectly.
Set a higher temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too frequently.
Do not keep the door open longer than necessary.
The product temperature is too high.
Let the product temperature de- crease to room temperature be- fore storage.
The room temperature is too high.
Decrease the room temperature.
Water flows on the rear plate of the refrigerator.
During the automatic defrosting process, frost defrosts on the rear plate.
This is correct.
Water flows into the re- frigerator.
The water outlet is clogged. Clean the water outlet.
Products prevent that water flows into the water collector.
Make sure that products do not touch the rear plate.
Water flows on the ground.
The melting water outlet does not flow in the evaporative tray above the compressor.
Attach the melting water outlet to the evaporative tray.
The temperature in the appliance is too low.
The temperature regulator is not set correctly.
Set a higher temperature.
The temperature in the appliance is too high.
The temperature regulator is not set correctly.
Set a lower temperature.


1. Disconnect the mains plug from the mains socket. 2. Remove the screw from the lamp cov- er. 3. Remove the lamp cover (refer to the il- lustration). 4. Replace the used lamp with a new lamp of the same power and specifical- ly designed for household appliances. (the maximum power is shown on the lamp cover). 5. Install the lamp cover. 6. Tighten the screw to the lamp cover. 7. Connect the mains plug to the mains socket. 8. Open the door. Make sure that the lamp comes on.
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "Installation".

The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label.

Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance.
Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance:
Replacing the lamp

Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power sup- ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not ob- served. This appliance complies with the E.E.C. Di- rectives.
min. 200 cm2
The airflow behind the appliance must be sufficient.
min. 200 cm2
consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative
Ventilation requirements
Common problems, likely causes, and what to do.
| Problem | Possible cause | Remedy | |
|---|---|---|---|
| The appliance does not operate. The lamp does not operate. | The appliance is switched off. | Switch on the appliance. | p.6 |
| The appliance does not operate. The lamp does not operate. | The mains plug is not connected to the mains socket correctly. | Connect the mains plug to the mains socket correctly. | p.6 |
| The appliance does not operate. The lamp does not operate. | The appliance has no power. There is no voltage in the mains socket. | Connect a different electrical ap- pliance to the mains socket. Contact a qualified electrician. | p.6 |
| The lamp does not work. | The lamp is in stand-by. | Close and open the door. | p.6 |
| The lamp does not work. | The lamp is defective. | Refer to "Replacing the lamp". | p.6 |
| The compressor oper- ates continually. | The temperature is not set cor- rectly. | Set a higher temperature. | p.6 |
| The compressor oper- ates continually. | The door is not closed correctly. | Refer to "Closing the door". | p.6 |
| The compressor oper- ates continually. | The door has been opened too frequently. | Do not keep the door open longer than necessary. | p.6 |
| The compressor oper- ates continually. | The product temperature is too high. | Let the product temperature de- crease to room temperature be- fore storage. | p.6 |
| The compressor oper- ates continually. | The room temperature is too high. | Decrease the room temperature. | p.6 |
| Water flows on the rear plate of the refrigerator. | During the automatic defrosting process, frost defrosts on the rear plate. | This is correct. | p.6 |
| Water flows into the re- frigerator. | The water outlet is clogged. | Clean the water outlet. | p.6 |
| Water flows into the re- frigerator. | Products prevent that water flows into the water collector. | Make sure that products do not touch the rear plate. | p.6 |
| Water flows on the ground. | The melting water outlet does not flow in the evaporative tray above the compressor. | Attach the melting water outlet to the evaporative tray. | p.6 |
| The temperature in the appliance is too low. | The temperature regulator is not set correctly. | Set a higher temperature. | p.6 |
| The temperature in the appliance is too high. | The temperature regulator is not set correctly. | Set a lower temperature. | p.6 |
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.