EN
Lorus logo
Official user manual

Lorus V145

15 pages·205 KB·Watch·PDF·ENDEFRITNLJA
Lorus V145
Table of Contents 31 sections CAL. V145, V182 SOLAR WATCH · G GETS ENERGY FROM LIGHT · G NO BATTERY REPLACEMENT · G FULL CHARGE GIVES ENERGY FOR · … ShowHide
Page 1 of the Lorus V145 user manual — G GETS ENERGY FROM LIGHT
Page 1 · click to enlarge
Page 1

CAL. V145, V182 SOLAR WATCH

G GETS ENERGY FROM LIGHT

G NO BATTERY REPLACEMENT

G FULL CHARGE GIVES ENERGY FOR

6 MONTHS (Cal. V145) / 2 MONTHS (CAL. V182)

G WARNING FUNCTION IN CASE OF INSUFFICIENT ENERGY

G FAST-START FUNCTION

G PREVENTION STORAGE OF EXCESS ENERGY

Page 2 of the Lorus V145 user manual — CAL. V145, V182 SOLAR WATCH
Page 2 · click to enlarge
Page 2
Diagram . .
Diagram . .

a) Normal mode: Free b) First click: Set date c) Second click: Setting time

$The solar ball is mounted under the dial.

Page 3 of the Lorus V145 user manual — Twisting the crown
Page 3 · click to enlarge
Page 3

SCREW CROWN

[for models with a crown of screw]

Unscrewing the crown

1 Unscrew the crown by turning it left. 2 The crown can be pulled out.

Twisting the crown

1 Press the crown back into normal position. 2 Turn the crown upside down by turning it to the right and also pressing lightly.

Page 4 of the Lorus V145 user manual — CHARGE
Page 4 · click to enlarge
Page 4

CHARGING AND STARTING THE WATCH

CHARGE

G If you want to start the watch or when energy in the solariel until it

minimum has dropped, you can charge the watch by exposing it to light. M Quick start function:

When the watch is exposed to sunlight or strong artificial light (over 1000 lux), the second hand will immediately move with a two-second interval.

Diagram . .
Diagram . .

1 Put the watch under exposure to sunlight or strong artificial light.

* A watch that has stood still will move with a two-second interval.

2 Keep the watch in light until the second hand moves with a one-second interval.

Page 5 of the Lorus V145 user manual — LET OP
Page 5 · click to enlarge
Page 5

3 If the watch is charged after it has stopped completely, you will need to reset the date, day and time before you can wear it again.

* See chapter "Shooting Guidelines" on page 86 (Cal. V145) / on page 87 (Cal. V182).

NOTES: 1 When the quick start function is activated by exposing the watch to light, the second hand will immediately move with a two-second interval. The energy in the solariel will not be enough, however, because as soon as you remove the watch from the light it stops functioning. 2 It is not necessary to charge the watch completely. However, you must charge the watch sufficiently. This is particularly true if the watch has stopped.

LET OP

Attention when charging

G If you want to charge the watch, do not place it too close on the light source

(flashlight, spotlight, filament lamp or other light sources). The temperature can rise too high so that parts in the watch can damage. G If you want to charge your watch with sunlight, don't leave the watch on the dashboard

of a car for too long. The temperature could be too high. G While charging your watch, the temperature of the watch should never be higher

50 degrees Celsius.

Page 6 of the Lorus V145 user manual — (Cal. V145)
Page 6 · click to enlarge
Page 6

GUIDELINES ON CHARGING TIMES

(Cal. V145)

Lighting (lux)Light sourceEnvironmentTime required (approx.) AB$C 50060-watt filament lampDistance from 60 cm250 hours15 hours60 minutes 700Fluorescent lightOffice, ceiling175 hours11 hours50 minutes 1.00030-watt fluorescent lightDistance from 70 cm120 hours6 hours30 minutes 3.00030-watt fluorescent lightDistance from 20 cm40 hours2 hours10 minutes 5.00030-watt fluorescent lightDistance from 12 cm22 hours80 minutes6 minutes 10.00030-watt fluorescent lightDistance from 3 cm10 hours30 minutes3 minutes 10.000sunfoggy weather10 hours30 minutes3 minutes 100.000sungood weather3 hours8 minutes1 minute
Page 7 of the Lorus V145 user manual — (Cal. V182)
Page 7 · click to enlarge
Page 7

(Cal. V182)

Lighting (lux)Light sourceEnvironmentTime required (approx.) AB$C 50060-watt filament lampDistance from 60 cm110 hours8 hours100 minutes 700Fluorescent lightOffice, ceiling82 hours6 hours75 minutes 1.00030-watt fluorescent lightDistance from 70 cm60 hours4 hours55 minutes 3.00030-watt fluorescent lightDistance from 20 cm20 hours1.3 hours18 minutes 5.00030-watt fluorescent lightDistance from 12 cm10 hours33 minutes9 minutes 10.00030-watt fluorescent lightDistance from 3 cm5 hours15 minutes5 minutes 10.000sunfoggy weather5 hours15 minutes5 minutes 100.000sungood weather2.1 hours7 minutes2 minutes
Page 8 of the Lorus V145 user manual — (Cal. V182)
Page 8 · click to enlarge
Page 8

A: fully charged B: for one-second interval C: for use of a day

$ The values in this column represent the desired loading times until the

second hand constantly moves with a one-second interval after first moving with a two-second period. Even if the watch is not loaded according to a time from this column, the second hand can temporarily move with a one-second interval. After that, however, it will start to move again with a two-second interval. Therefore it is better to charge the watch immediately enough.

G The table above gives broad guidelines. G When the watch is fully loaded it will last for about 6 months (Cal.

V145) / 2 months (Cal. V182) have energy to function properly.

Page 9 of the Lorus V145 user manual — (Cal. V182)
Page 9 · click to enlarge
Page 9
Diagram . .
Diagram . .

1 Pull off until the first click and set the date of the previous day.

2 Pull off until the second click when the second hand is on 12 hours.

4 Turn to set the time and minute pointer at your desired time.

5 Press back into normal mode at the same time with a time signal of e.g. The radio.

Date

Page 10 of the Lorus V145 user manual — (Cal. V182)
Page 10 · click to enlarge
Page 10

* If necessary, you can change the date during this period by first changing time to a time outside that period. Then set the date and then turn the hands to the current time. 2 Check if AM/PM is set correctly to configure the time hand.

* The watch is designed to change the date once in 24 hours. Turn the hands past 12 to find out if the watch is set in AM or PM. If the date changes, time is in AM and if the date does not change then time is PM. 3 If you want to set the minute hand, first turn the pointer 4 to 5 minutes further than desired time and then rotate it back to the exact minute. 4 The date should be reset at the end of February and even months.

Page 11 of the Lorus V145 user manual — HOW TO PREVENT ENERGY FROM RUNNING OUT
Page 11 · click to enlarge
Page 11

WARNING FUNCTION IN CASE OF INSUFFICIENT ENERGY

G When the energy stored in the battery is reduced to almost zero,

the second hand will move with a two-second interval instead of the normal one-second period. G In that case, the watch must be recharged what you can do by

To expose the watch to light. Otherwise the watch will be after about 3 days (Cal. V145) / 1 day (Cal. V182) stop functioning. (For charging, see HORLOGS AND STARTING)

HOW TO PREVENT ENERGY FROM RUNNING OUT

I Wear the watch in such a way that it does not become by your sleeve

covered.

I If you do not wear the watch then keep it on a

as light as possible.

* The temperature should not exceed 50 degrees Celsius.

Page 12 of the Lorus V145 user manual — NOTE WHEN CHARGING
Page 12 · click to enlarge
Page 12

NOTE WHEN CHARGING

G This watch has a rechargeable battery that is only suitable for this

watch. Unlike watches that get their energy from a battery, the rechargeable battery does not need to be replaced.

G The rechargeable battery is a clean energy source that has no adverse effect

on the environment.

VIEW G Never put a silver oxide battery in your watch as it can explode and an

can cause enormous heat. The watch is designed so that it will not function after installing such a battery.

Page 13 of the Lorus V145 user manual — WATERPROOF
Page 13 · click to enlarge
Page 13

MAINTAINING THE QUALITY OF YOUR WATCH

G Water resistance (5 bar)*

WATERPROOF

If .WATER RESISTANT 5 BARS is engraved on the back plate, then your watch is designed and made to reach 5 bar water pressure 5 bar WR

G Non Water Resistant

If .WATER RESISTANTS are not engraved on the back plate, then your watch is not waterproof and it should be ensured that it doesn't get wet because water can cause damage to the watch. If the watch is wet, we ask you to have it checked at an AUTHORISED LORU DEALER or SERVICE CENTRE. M Water resistance (3 bar)

resist and can be used during swimming, yachting and while taking a shower.

G Water resistance (10 bar/15 bar/20 bar)*

If .WATER RESISTANT 10 BAR .,WATER RESISTANT 15 BAR ,WAER RESISTAENT 20 BAR SHALL BE engraved on the back plate, then 10/15/20 bar WR

If ACTIVE WATER RESISTANTS are engraved on the back plate, then your horologist is designed and made to withstand a water pressure of 3 bar so that drops or rain do not cause adverse effects, however it is not designed for swimming or diving.

Your watch is designed and made to withstand a water pressure of 10bar/15 bar/20 bar, and can be used while taking a bath, shallow diving but not for scuba diving. For scuba diving we recommend a Lorus diver watch.

Page 14 of the Lorus V145 user manual — +50 ° C
Page 14 · click to enlarge
Page 14
  • * Before using the watch with a water resistance of 5, 10, 15, 20 bar in the water, make sure that the crown is pressed whole. If you wear the watch in water, do not use the buttons and crown. If you have worn the watch, it is advisable to rinse the watch with clean water and dry thoroughly. * When you showered with your wrist watch to be that 5 bar is water resistant or if you have taken a bath with a watch of 10, 15 or 20 bar it is important to pay attention:
  • Do not use crowns or buttons when the watch is wet from sop or shampoo.
  • If the watch comes into contact with hot water, there is a chance that it will run something forward or behind. For scuba diving we recommend a Lorus diver watch.

TEMPERATURES

Your watch always runs accurately at a temperature between 5° C and 35° C (41° F and 95° F).

cause battery or reduce the life of the battery. At very low temperatures .*5° C (+23° F) for a longer period of time, your watch may be somewhat advanced or behind schedule. This is corrected as soon as the watch is back below normal temperature.

+50 ° C

-5 ° C

Temperatures above 50°C (122°F) may cause leakage of the

Page 15 of the Lorus V145 user manual — STICKER ON LID
Page 15 · click to enlarge
Page 15

MAGNETISM

MAINTENANCE SERVICES OF CABINET AND BAND

Your watch may experience influence from strong magnetic fields. Keeps your watch away from magnetic objects. N S

V o r k o m e n u t u l e rust spots on closet and band, due to dust and moisture, by removing them directly with a soft dry cloth.

SHOCK AND VIBRATION

Light activities do not affect your watch. However, do not drop the watch o f s t o t e n o p h a r d e surfaces.

PERIODICAL MONITORING

It is recommended that the watch be checked every 2 or 3 years by an APPROVED LORUSDEAR to ensure that the

2. 3 years

CHEMICALS

cabinet, crown, buttons, gasket and glass seal remain in order.

Make sure your watch does not become b l o t g e s t e l d a n o p l o s m i d d e l e n , k w i k , cosmetic spray products, r e n i g i n g s m l d e n

STICKER ON LID

If your watch is provided with a sticker on the back cover you should remove it. Transpiration could get below and give rise to rust.

adhesives, lacquer or paint. This allows the closet, band etc. discolour or damage.

Ask about the Lorus V145

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the Lorus V145

Be the first to ask — other owners or our team will answer.

Original document

Lorus V145 manual PDF

15 pages·205 KB·Watch·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…