

Cat. No. HCCUR
Owners Manual


Remember to exercise good common sense when using the Home Automation features of your Remote - especially when scheduling unattended devices. There can be some unexpected consequences if not used with care. For example, an empty coffee pot can be remotely turned on. If that should happen, your coffee pot could be damaged from overheating. If an electric heater is turned on by remote control while clothing is draped over it, a fire could result. DO NOT USE the remote for the control of high power heating appliances such as portable heaters.
WARNING: TO PREVENT ELECTRIC SHOCK HAZARD, DO NOT EXPOSE ANY PART OF THE HOME AUTOMATION SYSTEM TO RAIN OR MOISTURE CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE ANY PART OF THE HOME AUTOMATION SYSTEM’S PLUG-IN MODULES OR CONTROLLERS. NO USER- SERVICEABLE PARTS ARE INSIDE. IF YOU SPILL LIQUID ON A UNIT, DISCONNECT THE UNIT FROM THE AC OUTLET TO PREVENT POSSIBLE FIRE OR SHOCK HAZARD AND CONSULT AUTHORIZED SERVICE PERSONNEL. POWERLINE OPERATED EQUIPMENT OR ACCESSORIES CONNECTED TO ANY OF THESE UNITS SHOULD BEAR THE UL LISTING OR CSA CERTIFICATION MARK AND SHOULD NOT HAVE BEEN MODIFIED IN ANY WAY THAT MIGHT DEFEAT THEIR SAFETY FEATURES.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE,
AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,




The 6-in-1 Remote lets you control practically everything electrical in your home. It has IR technology that lets you control all your TV, VCR, Cable and Satellite equipment, and RF technology that lets you control lamps and appliances anywhere in your home. To find out more about configuring the Remote to work with your audio/video equipment, refer to the following section titled “Setting Up Your Remote.”
INDICATOR LIGHT The indicator light flashes when the remote is operating.
POWER Works in the same way as your original remote.
SET UP Used for programming the remote.
HOUSE SYMBOL Lets you control modules to operate lamps and appliances around the home.

TV, VCR, CBL, AUX1, AUX2, SAT Used to select the device to control. SAT includes DBS receivers.
0-9 Used as your original remote and to enter device codes.
LAST Selects the last channel viewed on your TV, VCR, Cable Box or Satellite Receiver.
CHANNEL +/- Works like your original remote. Also used to switch modules on and off.
MUTE Works the same as your original remote.
VOLUME +/- Works like your original remote. Also used to brighten and dim lamps connected to Modules.
TIMER Used to set the Sleep Timer to automatically switch off the TV or modules after a preset time.
CAP (CAPTION) Has different function depending on Mode e.g. TV Closed Caption in TV Mode.
PLAY, REW, FF, STOP, PAUSE Work the same as on your original remote.
REC Record button. Works the same as your original remote. You must press the REC button twice to begin recording.
SHIFT For accessing additional functions.
DISP (DISPLAY) Used to access on-screen information

SETTING UP FOR TV, VCR, CABLE BOX AND SATELLITE RECEIVER
NOTES: For CD players use the AUX 1 or AUX 2 buttons. If your TV/VCR/Cable Box/Satellite Receiver does not respond, try the other codes for your brand. If it still doesn’t respond, try the Code Search method on page 10. If the LED blinked rapidly when you entered the code, you may have entered an invalid code. Recheck the code in the code list (separate sheet) and try again. If some buttons do not operate your equipment, try one of the other codes for your brand.

USING AUX TO CONTROL A SECOND TV, VCR, CABLE BOX
The AUX button is normally used to control an audio component, but it can also be configured to control a second TV, VCR, cable box or satellite receiver.

If you accidentally go past the code, press
CHANNEL -repeatedly until the channel changes again.
*NOTE: You might have to press CHANNEL+ many times (50+). If the device does not have a Channel Up function, use the PLAY button (VCR only) or the POWER button.


The Sleep Timer automatically turns off the TV after the time you set. Press the TV button, then follow the instructions below to set the Sleep Timer:
M ODULES
If you have purchased and installed a Transceiver Module, you can control it and other modules as follows:

HOME CONTROL FUNCTIONS: On: CHANNEL + Off: CHANNEL – Bright: VOLUME + Dim: VOLUME – All Lamps On: POWER All Modules Off: MUTE
TO SET THE HOME CONTROL (HC) SLEEP TIMER
The Sleep Timer switches off the chosen modules after the preset time.

The Remote defaults to House Code A, and in most cases you will not need to change this unless you are experiencing interference from a neighboring Home Control system.


Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this product at the time of its sale by Leviton is free of defects in materials and workmanship under normal and proper use for two years from the purchase date. Leviton’s only obligation is to correct such defects by repair or replacement, at its option, if within such two year period the product is returned prepaid, with proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att: Quality Assurance Department, 59-25 Little Neck Parkway, Little Neck, New York 11362- 2591 (In Canada send to Leviton Mfg. of Canada Ltd., 165 Hymus Blvd., Point Claire, (Quebec), Canada H9R 1E9). This warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation. This warranty is void if this product is installed improperly or in an improper environment, overloaded, misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or not in accordance with any labels or instructions. There are no other or implied warranties of any kind, including merchantability and fitness for a particular purpose, but if any implied warranty is required by the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness for a particular purpose, is limited to two years. Leviton is not liable for incidental, indirect, special, or consequential damages, including without limitation, damage to, or loss of use of, any equipment, lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.
For Technical Assistance Call:
1-800-824-3005 (U.S.A. Only) 1 800 405-5320 (Canada Only) www.leviton.com
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.