Instruction/ maintenance manual of the product SFM1 Sony
Go to page of 16
INSTALLATION MANUAL SFM1 Sony Electronics, Inc. 16540 West Bernardo Drive San Diego, CA 92127 www.sony.com IN-SFM1.R2.
PBL-110 Projector Mount Page - 2 - Installation Manual.
SFM1 Installation Manual Page - 3 - Table of Contents WARNING STATEMENTS ............................................................................................................ ................. - 4 - PARTS LIST ..................................
SFM1 Page - 4 - Installation Manual Warning Statements WARNING: THE WALL STRUCT URE MUST BE CAPAB LE OF SUPPORTING AT LE AST FIVE (5) TIMES THE WEIGHT OF THE DISPLAY. IF NOT, THE WALL STRUCTURE MUST BE REINFORCED. PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVIC E TECHNICIAN, AS OUTLINED IN THE IN STALLATION INSTRUCTIONS, MUST BE ADHERED TO.
SFM1 Installation Manual Page - 5 - Parts List NOTE: This wall mount is shipped with all proper installation hardware and com ponents. Make sure that none of these parts are missing and/or damaged be fore beginning installati on. If there are parts missing and/or damaged, please stop the installa tion and contact Sony Electronics (800)222-7669.
SFM1 Page - 6 - Installation Manual Flat Panel Mount Location WARNING : INVERT THE FLAT PANEL. PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILUR E TO DO SO WILL RESULT IN DAMAGING THE FLAT P AN EL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY PROTECTION TO THE GLASS.
SFM1 Installation Manual Page - 7 - Figure 3. Mounting Bracket Installation NOTE : The mounting guides are designed w ith a center viewing guide on the side of them . There will be a “notch” cut on the side of the bracket (Figure 4 ). Figure 4 . Locating the Center of the Flat Panel 2.
SFM1 Page - 8 - Installation Manual Griplates™ 1. The Griplates™ have M4, M5, M6 a nd M8 hole patterns to fit the hardwa re that the flat panel requires. Example : If your display uses M8 x 20 Phillips head screws. Use the M8 mounting points (Figure 5).
SFM1 Installation Manual Page - 9 - Wood Stud Location 1. Using a stud finder, locate the 16” or 24” stud centers behind the wall. 2. Once found, make a pencil mark on the center of the wood studs (Figure 7). NOTE : The wall plates have three 16” and 12” mounting slot positions.
SFM1 Page - 10 - Installation Manual Marking the Mounting Points 1. Place the bottom portion of the wall plate to the refere nce line and m ark the four (4) lag bolt mounting points through the wall pl ate slots on the wall. 2. Level the wall plate with the reference ar row pointing up to the ceiling (Figure 9).
SFM1 Installation Manual Page - 11 - 3. Use the information below when mounting to the following surfaces (Figure 10): Wood Studs : Drill four (4) ¼” pilot holes to the marked wall. Concrete Wall : Drill four (4) 3/8” pilot holes to the m arked wall 16" Figure 10 .
SFM1 Page - 12 - Installation Manual Securing the Wall Plat e to a Concrete W all 1. Level and secure the plate to the wa ll with the reference arrow f acing up to the ceiling. 2. Use a minimum diameter of 5/16” x 2 ¼” wedge anchors – commercially available (Figure 12).
SFM1 Installation Manual Page - 13 - Securing the Flat Panel to the Wall Mount WARNING : At least (2) qualified personnel are strongly recommended for installati on of this product. Failure to do so could result in se rious injury and possible da mage to the flat panel.
SFM1 Page - 14 - Installation Manual CSL2 Security Cable 1 3 4 2.
SFM1 Installation Manual Page - 15 - Technical Specifications (127) (36.91) (31.75) (606 .92) (406.4) (406.4) (406.4) (49.53) (711.2) (88.9) A. Wall plate B.
SFM1 Page - 16 - Installation Manual Warranty Limited Lifetime Warranty This product carries a limited lifetime warranty from ship date against defects in materials and workm anship. Sony Electronics is not liab le for improper installation that results in damage to mounts, adapters, display equipment or personal injury.
An important point after buying a device Sony SFM1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Sony SFM1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Sony SFM1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Sony SFM1 you will learn all the available features of the product, as well as information on its operation. The information that you get Sony SFM1 will certainly help you make a decision on the purchase.
If you already are a holder of Sony SFM1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Sony SFM1.
However, one of the most important roles played by the user manual is to help in solving problems with Sony SFM1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Sony SFM1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
