Instruction/ maintenance manual of the product SHD-R 3000 Karcher
Go to page of 37
5.956-486 A2005937 (06/03) SHD-R 3000 Betriebsanleitung ! www.karcher.com.
Operating Instructions T o be handed to the operator Read these instructions carefully before star ting up the unit Retain f or future ref erence Notes about these operating instructions Before starting up the interior cleaner for the first time, please carefully read through these instructions.
English SHD-R 3000 5.956-486 A2005937 (06/03) A. For your safety 1 . Safety information and instructions 2 . Noise protection 3 . Authorized operators 4 . Personal protective equipment 5 . Emergency drill 6 . Safety devices 7 . Applicable regulations 8 .
SHD-R 3000 English 5.956-486 A2005937 (06/03) 1 . Safety information and instructions The following symbols are used throughout these Operating Instructions: ! Danger! Denotes an immediate and present danger. Failure to observe this notice could lead to severe injury or death.
English SHD-R 3000 5.956-486 A2005937 (06/03) A2 A. For your safety 5 . Emergency drill Turn mains supply voltage off at system master switch. Turn off supply of cleaning liquid. If a handgun is being used, release any remaining pressure in the system by pressing the lever on the handgun.
SHD-R 3000 English 5.956-486 A2005937 (06/03) A3 8 . Using the system for its intended purpose This system is used for pumping a cleaning liquid at high-pressure, for the purpose of: with the handgun attached – cleaning containers, boxes, cases and equipment parts, etc.
English SHD-R 3000 5.956-486 A2005937 (06/03) A4 A. For your safety 1 0 . Schematic diagram of area classification.
SHD-R 3000 English 5.956-486 A2005937 (06/03) A5 A. For your safety 11. Area Classification In the BetrSichV and EN 1127-1, hazardous (potentially explosive) areas are classified into zones according to the frequency and duration of the occurrence of hazardous, potentially explosive atmospheres.
English SHD-R 3000 5.956-486 A2005937 (06/03) 1 . T ypes of system Static or mobile systems The static system is intended to be installed on a base, has been mounted onto a rigid steel frame, is most suitable for use in conjunction with fixed-installation high-pressure lines.
SHD-R 3000 English 5.956-486 A2005937 (06/03) B2 B. T ypes of system, and operating information Cleaning liquids T ype of system (see rating plate) Cleaning liquid W orking pressure/ Pressure setting .
English SHD-R 3000 5.956-486 A2005937 (06/03) B3 B. T ypes of system, and operating information Cleaning liquids T ype of system (see rating plate) Cleaning liquid W orking pressure/ Pressure setting .
SHD-R 3000 English 5.956-486 A2005937 (06/03) B. T ypes of system, and operating information B4 Cleaning liquids T ype of system (see rating plate) Cleaning liquid W orking pressure/ Pressure setting .
English SHD-R 3000 5.956-486 A2005937 (06/03) B5 B. T ypes of system, and operating information 2 . System start-up Emergency drill Turn mains supply voltage of at system master switch. Turn off supply of cleaning liquid. If a handgun is being used, release any remaining pressure in the system by pressing the lever on the handgun.
SHD-R 3000 English 5.956-486 A2005937 (06/03) C1 C. System functions 1 Transmission casing 2 Crankshaft with drive 3 Seal (oil compartment) 4 Gland 5 Seal (grease compartment) 6 Lubrication nipple or .
English SHD-R 3000 5.956-486 A2005937 (06/03) C2 C. System functions Operational sequence of the high- pressure pump Cleaning liquid is taken in by the piston. Suction valves (9) prevent cleaning liquid from flowing backwards. Action of piston pumps cleaning liquid onwards.
SHD-R 3000 English 5.956-486 A2005937 (06/03) D1 D . T echnical specifications Unit SHD-R 3000 (F) SHD-R 3000 (F) S SHD-R 3000 (F) SSR 1) SHD-R 3000 (F) SLA 1) SHD-R 3000 (F) SV A SHD-R 3000 (F) LM El.
English SHD-R 3000 5.956-486 A2005937 (06/03) E1 E. Care and maintenance 1 . General information It is a fundamental requirement for ensuring that this system functions safely and reliably that maintenance is carried out regularly in accordance with the following schedule.
SHD-R 3000 English 5.956-486 A2005937 (06/03) E2 E. Care and maintenance 2 . Maintenance schedule Frequency T ype of pump SHD-R 3000 (F) Action Pr ocedure By whom? 1, 2, 4, 10 hours after initial star t- up .
English SHD-R 3000 5.956-486 A2005937 (06/03) E3 E. Care and maintenance 2 . Maintenance schedule Frequency T ype of pump SHD-R 3000 (F) Action Procedure By whom? Monthly or after e very 160 operating.
SHD-R 3000 English 5.956-486 A2005937 (06/03) E4 E. Care and maintenance 3 . Maintenance tasks Changing the oil ! Danger! Burns hazard due to hot oil and hot system components. Allow pump to cool down for 15 minutes before changing oil. i Important! Waste oil may only be disposed of by the operators of special collection points.
English SHD-R 3000 5.956-486 A2005937 (06/03) E5 E. Care and maintenance V-belt Test tension of V-belt and adjust as follows: Switch off system, and ensure that it cannot be switched back on again unintentionally. Remove guard over V-belt. Test belt tension.
SHD-R 3000 English 5.956-486 A2005937 (06/03) F1 F . T r oubleshooting Who is permitted to repair faults on the system? Operator Tasks that are marked “Operator” may only be carried out by persons who have been instructed in the safe operation and maintenance of high-pressure systems.
English SHD-R 3000 5.956-486 A2005937 (06/03) F . T r oubleshooting F2 1 . Fault-finding Prob lem Component P ossible cause Remedy By whom? System does not star t up Control circuitr y No v oltage sup.
SHD-R 3000 English 5.956-486 A2005937 (06/03) F3 F . T r oubleshooting 1 . Fault-finding Prob lem Component P ossible cause Remedy By whom? Knocking noise V -belt V -belt has snapped Replace V -belt (.
English SHD-R 3000 5.956-486 A2005937 (06/03) ! Hazard! The following mounting and accessory kits must not be used for operation with solvents or in a hazardous (potentially explosive atmosphere) area.
SHD-R 3000 English 5.956-486 A2005937 (06/03) G2 Pressure-relief valve Function The pressure-relief valve is an integrated solenoid valve. The pressure-relief valve is only active during the start-up phase when the system is configured for star-delta starting.
English SHD-R 3000 5.956-486 A2005937 (06/03) G3 G. Mounting kits and accessories Figure A 170/1.
SHD-R 3000 English 5.956-486 A2005937 (06/03) G4 G. Mounting kits and accessories Figure A 172.
English SHD-R 3000 5.956-486 A2005937 (06/03) G5 G. Mounting kits and accessories Figure A 173.
SHD-R 3000 English 5.956-486 A2005937 (06/03) G6 G. Mounting kits and accessories Figure A 161.
English SHD-R 3000 5.956-486 A2005937 (06/03) G7 G. Mounting kits and accessories Figure A 154.
SHD-R 3000 English 5.956-486 A2005937 (06/03) H1 H. W arranty The applicable warranty conditions in different countries are issued by the respective national distributor of KÄRCHER products. In the event of a warranty claim, please contact your original dealer or the nearest authorized customer service centre.
English SHD-R 3000 5.956-486 A2005937 (06/03) I1 I. System installation This system should only be installed by Kärcher Customer Service engineers, persons who have been specially authorized by Kärcher. Unpacking the system Unpack the system and deliver the packag- ing materials to an appropriate collection point for recycling.
SHD-R 3000 English 5.956-486 A2005937 (06/03) I. System installation I2 Dimensional diagram: Static system Mobile system approx. 1100.
English SHD-R 3000 5.956-486 A2005937 (06/03) J1 J. Declaration of Conformity EC Declaration of Conformity We herewith declare that the design and type of machine named in the following as well as the model marketed by us complies with the relevant fundamental health and safety requirements of the EC Directives.
SHD-R 3000 English 5.956-486 A2005937 (06/03) J2 J. Declaration of Conformity EC Declaration of Conformity We herewith declare that the design and type of machine named in the following as well as the model marketed by us complies with the relevant fundamental health and safety requirements of the EC Directives.
English SHD-R 3000 5.956-486 A2005937 (06/03) K1 K. T est recor d T ype no.: Factory no.: Commissioned on: T ests carr ied out on: .............................................................................................................. Results .
An important point after buying a device Karcher SHD-R 3000 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Karcher SHD-R 3000 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Karcher SHD-R 3000 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Karcher SHD-R 3000 you will learn all the available features of the product, as well as information on its operation. The information that you get Karcher SHD-R 3000 will certainly help you make a decision on the purchase.
If you already are a holder of Karcher SHD-R 3000, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Karcher SHD-R 3000.
However, one of the most important roles played by the user manual is to help in solving problems with Karcher SHD-R 3000. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Karcher SHD-R 3000 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
