Instruction/ maintenance manual of the product EIA-422 Digi
Go to page of 2
90033900D EIA-422 Mode (EtherLite 2 or 162 only) To operate a port of the EtherLite 162 EIA-422 in EIA-422 mode, set the port ’s EIA-422 ENABLED switch to the up position. Set the TERMINA- TION (422 ON LY) switch to the down position. This switch connects a 120 ohm, 1/2 watt resistor across the input signals.
Installing the EtherLite Hardware 1. Write the MAC address of the EtherLite module on the following line. It will be needed during software installation. This address is printed on a label next to the power plug at the back of the unit. MAC Address # 00AOE7______________ 2.
An important point after buying a device Digi EIA-422 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Digi EIA-422 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Digi EIA-422 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Digi EIA-422 you will learn all the available features of the product, as well as information on its operation. The information that you get Digi EIA-422 will certainly help you make a decision on the purchase.
If you already are a holder of Digi EIA-422, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Digi EIA-422.
However, one of the most important roles played by the user manual is to help in solving problems with Digi EIA-422. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Digi EIA-422 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
