EN
Official user manual

321 Studios 29AV

2 pages·90 KB·Coffeemaker·PDF·ENDEFRITNLJA
321 Studios 29AV
Table of Contents 5 sections Eyebolt Applications · For Installation of · Control 29AV · CAUTION · … ShowHide
Page 1 of the 321 Studios 29AV user manual — Eyebolt Applications
Page 1 · click to enlarge
Page 1

Eyebolt Applications

For Installation of

Control 29AV

When suspending JBL Control 29AV loudspeakers, you MUST utilize Load-Rated Steel Forged Shoulder Eyebolts. The load rating must be stamped on the side of the eyebolt and there must be a shoulder, as shown in Fig 1. The correct threading for the Control 29AV is M6. This means that the threaded shaft has a diameter of 6mm. The threaded shaft length will vary according to which insert point is being utilized.

321 Studios 29AV — Eyebolt Applications diagram (page 1)
Fig. 1 · Eyebolt Applications

Top & Bottom Inserts -- When using the installation points at the top and bottom of the cabinet, where the flat surfaces are, the eyebolt threads directly into the insert. Be sure to tighten the bolt all the way down so that the shoulder is snug against the surface of the cabinet. To do this, you must ensure the correct length of bolt so that the threads do not “bottom out” (stop turning) before the shoulder reaches the cabinet surface. For the top or bottom inserts, the shaft should be 12mm (1/2 inch). See Figure 2:

321 Studios 29AV — Eyebolt Applications diagram (page 1)
Fig. 2 · Eyebolt Applications

For top or bottom inserts, use 6 mm x 1mm pitch x 12 mm thread length steel forged shoulder eyebolts

Page 2 of the 321 Studios 29AV user manual — EYEBOLT APP 06/01
Page 2 · click to enlarge
Page 2

Side Inserts -- When using the installation points on the sides of the cabinet, you must use the included bevel washers. These washers provide a uniform flat surface for the shoulder of the bolt and also compensate for the draft (angle) of the sidewalls of the cabinet. In this application, the thread length must be longer to reach through the washer, while not “bottoming out”. The shaft should be 25.4 mm (1 inch). See Figure 3:

321 Studios 29AV — CAUTION diagram (page 2)
Fig. 3

For side inserts, use 6 mm x 1mm pitch x 25.4 mm thread length steel forged shoulder eyebolt.

CAUTION

Installation must only be done by qualified persons using safe rigging practices. Load eyebolts in accordance with the eyebolt

manufacturer’s loading guidelines.

For additional information, refer to JBL Professional’s Tech Note

Vol 1 #14, “Basic Principles for Suspending Loudspeakers”

Eyebolt Sources -- These sizes of forged shoulder steel eyebolts are available from a wide variety of industrial hardware suppliers, or directly from JBL Professional:

EB-6X12 = 6 mm x 1mm pitch x 12 mm thread length, forged shoulder steel eyebolt, load

rated.

EB-6X25 = 6 mm x 1 mm pitch x 25.4 mm thread length, forged shoulder steel eyebolt, load

rated.

EYEBOLT APP 06/01

Ask about the 321 Studios 29AV

Owners and our team usually reply within a day — and your question helps the next person too.

Add your email to get notified when it’s answered — no spam, ever.

0 questions
No questions yet about the 321 Studios 29AV

Be the first to ask — other owners or our team will answer.

Original document

321 Studios 29AV manual PDF

2 pages·90 KB·Coffeemaker·PDF
Click any page above to open it here
Page 1 / …
100%
Loading pages…