Instruction/ maintenance manual of the product MC-1 BSS Audio
Go to page of 9
User’ s Guide BSS Audio MC-1 Stand-Alone Media Converter • Gigabit Ethernet • Copper to Fiber • 1000Base-T to 1000Base-SX/LX BSS Audio MC-1 Gigabit Ethernet media converter connects 1000Base-T shielded or unshielded twisted-pair copper cable to 1000Base-SX or 1000Base-LX, fiber- optic cable.
2 BSS Audio 800-931-2357 8760 South Sandy Parkway, Sandy, Utah 84070 www.bssaudio.com 800-931-2357 3 Installation Set the 6-position switch The 6-position switch is located on the side of the media converter. • Use a small flat blade screwdriver to set the recessed switches.
4 Installation -- Continued Install Mode During installation, set converter DIP switch 4 DOWN; leave all other switches in the UP position (default) . This disables Transparent Link Pass-Through and A.
6 Installation -- Continued Install the copper cable 1. Locate a 1000Base-T compliant copper cables with male, RJ-45 connectors installed at both ends. 2. Connect the RJ-45 connector at one end of the cable to the RJ-45 port on the MC-1 media converter.
8 Oper ation - Continued Link P ass-T hrough The Link Pass-Through feature allows the media converter to monitor both the fiber and copper RX (receive) ports for loss of signal.
10 11 T echnical Specifications For BSS Audio Model MC-1 or equivalent 0 0 0 2 3 . 2 0 8 E E E I , ™ b a 3 . 2 0 8 E E E I : s d r a d n a t S Data Rate / Delay: 1000 Mbs/300 nsec Dimensions: 3.25" x 0.1" x 4.8" (82mm x 25mm x 122mm) .
12 T r oubleshooting If the media converter fails, isolate and correct the fault by determining the answers to the following questions and then taking the indicated action: 1.
14 15 Compliance Information CE Mark FCC regulations This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
Printed in the U.S.A. Trademark notice All trademarks and registered trademarks are the property of their respective owners. Copyright restrictions All rights reserved.
An important point after buying a device BSS Audio MC-1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought BSS Audio MC-1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data BSS Audio MC-1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, BSS Audio MC-1 you will learn all the available features of the product, as well as information on its operation. The information that you get BSS Audio MC-1 will certainly help you make a decision on the purchase.
If you already are a holder of BSS Audio MC-1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime BSS Audio MC-1.
However, one of the most important roles played by the user manual is to help in solving problems with BSS Audio MC-1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device BSS Audio MC-1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
