Instruction/ maintenance manual of the product Backyard Kitchen Brinkmann
Go to page of 32
1 0 0 1 5 0 2 0 0 2 5 0 3 0 0 3 5 0 4 0 0 4 5 0 5 0 0 5 5 0 6 0 0 6 5 0 7 0 0 OWNER’S MANUAL W ARNING HAZARDOUS EXPLOSION MA Y RESUL T IF THESE W ARNINGS AND INSTRUCTIONS ARE IGNORED. READ AND FOLLOW ALL W ARNINGS AND INSTRUCTIONS IN THIS MANUAL TO A VOID PERSONAL INJURY , INCLUDING DEA TH OR PROPERTY DAMAGE.
WE W ANT YOU T O ASSEMBLE AND USE YOUR GRILL AS SAFEL Y AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO A TTRACT YOUR A TTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL.
2 W ARNING • Never use natural gas in a unit designed for liquid propane gas. • Never use charcoal briquets or lighter fluid in a gas grill. • Leak test all connections before first use, even if grill was purchased fully assembled and after each tank refill.
CYLINDER SPECIFICA TIONS: When purchasing or exchanging a cylinder for your gas grill, it must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339 as applicable with a listed over-filling prevention device (OPD).
4 The cylinder must also be equipped with: • A shut-off valve terminating in a T ype 1 gas cylinder valve outlet. • A T ype 1 valve that prevents gas flow until a positive seal is obtained. • An arrangement for vapor withdrawal. • A collar to protect the cylinder shut off valve.
W ARNING FILLING THE LP GAS CYLINDER: • Allow only qualified LP gas dealers to properly fill or repair your LP gas cylinder . • New tanks should be purged prior to filling; inform LP gas dealer if you are using a new tank. • DO NOT allow the cylinder to be filled beyond 80% capacity .
6 W ARNING • Never use your grill without leak testing all gas connections and hoses. See the section on "Leak T esting" in this manual for proper procedures. The pressure regulator and hose assembly supplied with your gas grill is designed to work with an LP gas supply cylinder .
LEAK TESTING: T o prevent fire or explosion hazard: • DO NOT smoke or permit ignition sources in the area while conducting a leak test. • Perform test OUTDOORS only in a well ventilated area. • Never perform a leak test with a match or open flame.
W ARNING 8 6. Check each place listed (A -M) for growing bubbles which indicates a leak. 7. T urn OFF gas supply at cylinder valve. 8. T urn on control knobs to release gas pressure in hose. 9. T urn control knobs to “ off ” position. 10. T ighten any leaking connections.
Read, understand and follow all warnings and instructions contained in this manual. DO NOT skip any of the warnings and instructions contained in the preceding sections of this manual.
LIGHTING THE SIDE BURNER: 1. Open or remove the lid to the side burner before lighting. 2. T urn on the side burner by pressing in and rotating the control knob to the HIGH position. 3. Press and hold the igniter button on the main control panel until the burner ignites.
11 OPERA TING THE GRILL: Never use Charcoal or Lighter Fluid inside your Gas Grill. Read and follow all warnings and instructions contained in the preceding sections of this manual. BREAKING IN YOUR GRILL: • In manufacturing and preserving the components of your grill, oil residue may be present on the burner and cooking surfaces of your grill.
INDIRECT COOKING: • Indirect cooking is the process of cooking your food without the heat source being directly under your food. Y ou can sear meats over a high flame on one side of the grill while slow cooking a roast on the other (unlit) side of the grill.
THE SINK: • Attach a standard garden hose to the supply line and a spigot to provide water for the faucet. T urn on the water supply to the garden hose. The faucet handle turns on and of f the water flow . NOTE: Do not leave water supply to garden hose on when not in use.
Follow the instructions listed below . BEFORE STORING YOUR GRILL: • Ensure that the fuel supply tank valve is fully closed. • Clean all surfaces. • Lightly coat the burners with cooking oil to prevent excess rusting. • If storing the grill indoors, disconnect the LP tank and leave the LP tank OUTDOORS.
COOKING GRILLS • Clean with mild soap detergent and water . A brass bristled brush or a nylon cleaning pad can be used to remove residue from the cast iron cooking surface. Do not use steel wire bristles to clean the cast iron cooking grills. Steel can cause the finish to chip or crack.
16 • T o protect your grill from excessive rust, the unit must be kept clean and covered at all times when not in use. A grill cover may be ordered directly from Brinkmann by calling 1-800-468-5252 or 1-800-527-0717. • W ash cooking grill and briquet grate with hot, soapy water , rinse well and dry .
1 W ater supply hose 1 Upper kitchen frame 1 Right side panel 1 Grease cup wire frame 1 Grease cup 1 T ank hook bracket 2 Side burner legs 1 Axle 1 Control panel 1 Grill bottom frame 1 Kitchen bottom .
1 0 0 1 5 0 2 0 0 2 5 0 3 0 0 3 5 0 4 0 0 4 5 0 5 0 0 5 5 0 6 0 0 6 5 0 7 0 0 (Proof of purchase will be required.) Inspect contents of the box to ensure all parts are included and undamaged.
19 P ARTS BAG CONT AINS: 10 #8 X 3/8 ” sheet metal screws 1 1 Stainless steel sheet metal screws 4 M6 X 12 bolts 34 M6 X 35 bolts 4 Plastic inserts 2 Cotter pins 2 Hood pivot pins 10 M6 X 5 hex nuts.
Choose a good, cleared assembly area and get a friend to help you put your grill together . Lay cardboard down to protect grill finish and assembly area. Step 1 Assemble side burner legs to open end of grill bottom frame using four M6 X 35 bolts (hand tighten only at this point).
Step 4 Attach tank support bracket to open end of grill bottom frame using two M6 X 35 bolts and M6 X 5 hex nuts. NOTE: Securely tighten all bolts at this time. Step 5 Attach locking casters to bottom of right straight legs and plain casters to bottom of middle straight legs).
22 Step 9 Attach kitchen upper support frame using eight M6 X 35 bolts. Four small holes in frame should be positioned on left side and face up. Step 10 Add face panel using four stainless steel sheet metal screws. NOTE: T op of face panel has larger flat area above ribs.
23 Step 13 Slide baskets into slots located on inside of doors. Step 14 Attach right side panel between straight legs using four #8 X 3/8" sheet metal screws. Panel should be mounted with louvers toward bottom of panel. Then add four plastic inserts into holes on straight legs.
Step 18 Mount lower grill housing onto upper grill frame using four M6 X 35 bolts and M6 X 5 hex nuts. Step 19 Remove four bolts from burner supports on bottom of burner . Insert the grill burner into the lower grill housing by sliding V enturi tubes through the large square opening in the bottom of the housing.
25 Step 21 Place hood on top of lower grill housing and insert hinge pins through upper and lower hinges, then secure with cotter pins. Bend ends of cotter pin around hinge pin to secure. Step 22 Attach one handle stand using two M6 X 12 bolts and M6 X 5 hex nuts.
Step 25 Slide side burner frame onto burner legs. Align holes in frame with holes in leg. Secure using three stainless steel sheet metal screw . Step 26 Place side burner grid over burner .
Step 29 Install drain by placing rubber gasket around opening in bottom of basin. Insert drain through opening. Place second gasket under bottom side of the basin and over the drain.
28 Step 37 Add control knobs to valves by aligning the notched stem of the valve with the cut outs on the knobs. Smallest knob is for side burner control. Step 38 Connect wire leads from both burner electrodes to the spark igniter . Side burner wire will go through hole in kitchen frame.
R BACKY ARD KITCHEN COVER Our heavy-duty , durable vinyl cover with felt backing provides years of protection for Brinkmann Backyard Kitchen. This top-of-the-line cover comes with closure strips at both ends to prevent cover from slipping or blowing off.
ACCESSORIES LOOK FOR THESE AND OTHER BRINKMANN ACCESSORIES A T YOUR LOCAL RET AILER WHERE SMOKERS ARE SOLD, OR ORDER DIRECT BY CALLING 1-800-468-5252. THE UL TIMA TE 5-PIECE BBQ TOOL SET Yo u ’ ll be the envy of your fellow outdoor chefs with this ultimate BBQ tool set.
Owner ’ s Manual for Models 810-3620-0 1 1/01, 2/02, 7/02 140-3620-0 For one-year from date of purchase, The Brinkmann Corporation warrants the Brinkmann Stainless Steel Backyard Kitchen TM against defects due to workmanship or materials to the original purchaser .
An important point after buying a device Brinkmann Backyard Kitchen (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Brinkmann Backyard Kitchen yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Brinkmann Backyard Kitchen - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Brinkmann Backyard Kitchen you will learn all the available features of the product, as well as information on its operation. The information that you get Brinkmann Backyard Kitchen will certainly help you make a decision on the purchase.
If you already are a holder of Brinkmann Backyard Kitchen, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Brinkmann Backyard Kitchen.
However, one of the most important roles played by the user manual is to help in solving problems with Brinkmann Backyard Kitchen. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Brinkmann Backyard Kitchen along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
