Instruction/ maintenance manual of the product ZCG560G Zanussi
Go to page of 20
EN User manual Cooker ZCG560G CH.
Contents Safety information _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 2 Product description _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 4 Before first use _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ 5 Hob - Daily use _ _ _.
• This appliance is not connected to a combustion prod- ucts evacuation device. It must be installed and con- nected in accordance with current installation regula- tions. Particular attention must be given to the relevant requirements regarding ventilation.
• Glass lids can shatter when hot. Turn off all the burners before shutting the lid. Care and cleaning • Before maintenance, make sure that the appliance is cold. There is a risk of burns. There is a risk that the glass panels can break. • Keep the appliance clean at all times.
Cooking surface layout 1 4 2 3 1 Auxiliary burner 2 Semi-rapid burner 3 Semi-rapid burner 4 Rapid burner Accessories • Oven shelf For cookware, cake tins, roasts. • Flat baking tray For cakes and biscuits. • Flat aluminized baking tray For cakes and biscuits.
2. Push the knob down for 10 seconds and turn it counterclockwise to the maximum position . 3. Keep the knob pushed for approximately 10 sec- onds. This will let thermocouple warm up. If not, the gas supply is interrupted. 4. Adjust the flame when it is regular.
Warning! For safety reasons, do not clean the appliance with steam cleaners or high-pressure cleaners. Warning! Do not use abrasive c leaners, steel wool pads or acids, they can cause damage to the appliance. • To clean the enamelled parts, ca p and crown, wash it with warm soapy water.
Oven - Using the accessories Warning! Refer to "Safety information" chapter. Inserting the bakin g tray Put the tray in the centre of the oven cavity, between the front and rear wall. This ensures that the heat can circulate in front of and behind the baking tray.
Cooking times Cooking times depend on the type of food, its consisten- cy, and volume. Initially, monitor the performance when you cook. Find the best settings (heat setting, cooking time, etc.) for your cookware, recipes and quantities when y ou use this appli- ance.
Food Weight (g) Tray type Shelf level Preheating time (minutes) Termostat po- sition Cooking / baking time (minutes) Romanian sponge cake 600+600 2 round alu- minized trays (diameter: 25 cm) 3 10 2-3 .
Removing the oven door and the glass panel 1 Open the door fully and hold the two door hinges. 2 Lift and turn the levers on the two hinges. 3 Close the oven door to the first opening position (halfway). Then pull for- ward and remove it from its seat.
Problem Possible cause Remed y The oven does not heat up. The necessary settings are not set. Control the settings. Steam and condensation collect on the food and in the oven. You left the dish in the oven for too long. Do not keep the dishes in the oven for longer than 15-20 minutes after the cooking ends.
Gas burners BURNER NORMAL POW- ER REDUCED POWER Type of gas Pressure Inj. diamet er Cons. kW kW mbar mm g/h Auxiliary burner 1,00 0,35 Natur al gas G20 20 0,70 - 1,00 0,35 Butane G30 50 0,43 72,71 0,8.
Important! When installation is complete, make sure that the seal of each pipe fitting is correct. Use a soapy solution, not a flame! The gas supply ramp is on the rear side of the control panel. Warning! Before gas connection disconnect the mains plug from the mains socket or switch off the fuse in the fuse box.
1. Remove the bottom plate of the oven cavity ( A ) to get access to the oven burner ( B ). 2. Release the screw ( C ) which keeps the burner in po- sition. 3. Carefully move the burner off the injector support ( D ). Slowly move it to the left side. Make sure that the burner bush stays on the burner mouthpiece.
Packaging material The packaging material is environmentally-friendly and recyclable. Plastic parts are marked with international abbreviations such as PE, PS, etc. Dispose of the packag- ing material in the containers provided for this purpose at your local waste management facility.
17.
18.
19.
www.zanussi.com/shop 892942646-D-452011.
An important point after buying a device Zanussi ZCG560G (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Zanussi ZCG560G yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Zanussi ZCG560G - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Zanussi ZCG560G you will learn all the available features of the product, as well as information on its operation. The information that you get Zanussi ZCG560G will certainly help you make a decision on the purchase.
If you already are a holder of Zanussi ZCG560G, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Zanussi ZCG560G.
However, one of the most important roles played by the user manual is to help in solving problems with Zanussi ZCG560G. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Zanussi ZCG560G along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center