Instruction/ maintenance manual of the product S-460 Weber
Go to page of 32
YOU MUST READ THIS OWNER’S GUIDE BEFORE OPERATING YOUR GAS GRILL. m DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flames. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department.
www . weber.com ® 2 DaNGers aND w arNiNGs m DANGER Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property. m WARNINGS m Do not store a spare or disconnected liquid propane cylinder under or near this barbecue.
www . weber.com ® 3 3 w arraNty Weber-Stephen Products Co. (Weber) hereby warrants to the ORIGINAL PURCHASER of this Weber ® gas grill that it will be free of defects in material and workmanship fro.
www . weber.com ® 4 8 9 11 12 41 43 42 44 45 7 46 34 35 36 37 38 39 40 10 2 3 4 5 6 1 S460_NG_US 47 23 24 25 26 27 28 29 30 31 32 33 48 49 50 51 53 52 54 55 14 15 16 17 18 19 20 21 13 22 expl oDeD vi.
www . weber.com ® 5 5 Shroud Har dw are 1. Shroud 2. Thermometer 3. Thermometer Bezel 4. Handle 5. Grill Out 6. TM Handle Light Rotisser ie Motor 7. Rotisser ie Brac ket 8. W arming Rac k 9. Cooking Grat es 1 0. Flav orizer 11. ® Bars Burner T ubes 1 2.
www . weber.com ® 6 OPERATING The natural gas supply is easy to use and gives you more cooking control than charcoal fuel. • Theseinstructionswillgiveyoutheminimumrequirementsforassemblingyour Weber ® gas barbecue.
www . weber.com ® 7 7 Slide out Bottom tray - Remove excess grease, then wash with warm soapy water, then rinse. Flavorizer ® bars and Cooking grates - Clean with a suitable stainless steel bristle brush. As needed, remove from grill and wash with warm soapy water, then rinse with water.
www . weber.com ® 8 Gas iNstruc tioNs CHECK FOR GA S LEAKS m W ARNING: The gas connections of y our Summit ® gas grill hav e been factory test ed. We do ho we ver r ecommend that you leak c heck all gas connections bef ore oper ating y our Summit ® gas grill.
www . weber.com ® 9 9 3) Remov e the control panel. Tilt panel f orwar d and lift up and a wa y from grill. Be careful not t o break or disconnect the wires f or the control panel lights. Rest the contr ol panel against the lef t side of the grill (A) exposing the v alv es, b urners, igniter , and manifold.
www . weber.com ® 10 3 1 2 7 6 4 5 * The grill illustrated may have slight differences than the model purchased. Check: 1) Main g as line to manif old connection. 2) R otisserie (I.R. Burner) gas line connection. 3) Bulkhead and g as supply hose connection.
www . weber.com ® 11 11 A B C D E SNAP IGNITION OPERATION m Always open the lid before igniting the burners Each control knob has its own igniter electrode built in. To create a spark you must push the control knob in (A) and turn to “START/High” (B) .
www . weber.com ® 12 1 2 3 4 5 * The grill illustrated may have slight differences than the model purchased. LIGHTING Summary lighting instructions are inside the left hand cabinet door.
www . weber.com ® 13 13 1 3 4 5 2 6 * The grill illustrated may have slight differences than the model purchased. MAIN BURNER MANUAL LIGHTING m DANGER Failure to open the lid while igniting the barbe.
www . weber.com ® 14 opera tiNG iNstructioNs The most important thing to know about grilling is which cooking method to use for a specific food, Direct or Indirect. The difference is simple: place the food directly over the fire, or arrange the fire on either side of it.
www . weber.com ® 15 15 opera tiNG iNstructioNs USING THE SEAR S T A TION ™ Y our W eber ® gas barbecue includes a sear burner for searing meats such as st eak, poultry par ts, fish, and chops). Searing is a direct grilling technique which br owns the surf ace of the food at a high temperatur e.
www . weber.com ® 16 opera tiNG iNstructioNs 1) Open the lid. 2) Make sur e all burner control knobs are turned of f. (Push contr ol knob in and turn clockwise t o ensure that it is in the “OFF” position.) 3) Turn on the gas supply at source. m W ARNING: Do not lean ov er the open barbecue.
www . weber.com ® 17 17 SEAR ST A TION ™ BURNER MANU AL LIGHTING m D ANGER Failur e to open the lid while igniting the barbecue’ s burner s, or not waiting 5 min utes to allo w the gas to c lear if the barbecue does not light, may r esult in an explosiv e f lame-up which can cause serious bodil y injury or death.
www . weber.com ® 18 opera tiNG iNstructioNs LIGHTING THE SMOKER BURNER SMOKER BURNER SNAP IGNITION Note: The control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”.
www . weber.com ® 19 19 opera tiNG iNstructioNs 2 1 2 3 4 5 6 7 8 9 MANUALLY LIGHTING THE SMOKER BURNER 1) Open the lid. m DANGER Failure to open the lid while igniting the grill, or not waiting 5 minutes to allow the gas to clear if the grill does not light, may result in an explosive flare-up which can cause serious bodily injury or death.
www . weber.com ® 20 m WARNING: Setup up the rotisserie with food before lighting rotisserie burner. OPERATING 1) Plug power cor d into pow er source. m C A UTION: Inspect power cord before each use. If cord is damaged, do not use. Contact the Customer Service Representative in your area using the contact information on our web site.
www . weber.com ® 21 21 opera tiNG iNstructioNs LIGHTING THE ROTISSERIE BURNER ROTISSERIE BURNER SNAP IGNITION Note: Each control knob snap igniter creates a spark from the igniter electrode to the burner lighting tube. You generate the energy for the spark by pushing in the control knob and turning to “START/HI”.
www . weber.com ® 22 opera tiNG iNstructioNs MANUALLY LIGHTING THE ROTISSERIE BURNER m ATTENTION: READ BEFORE LIGHTING ROTISSERIE BURNER After a period of non-use, before lighting the Rotisserie Burner, a few seconds must pass for the gas supply line to fill.
www . weber.com ® 23 23 OPERATING THE HANDLE LIGHT The Weber Grill Out ™ Handle Light has a built-in “Tilt Sensor.” With the power button (a) activated, the light will come on when the grill lid is open. The light will turn off when the lid is closed.
www . weber.com ® 24 PROBLEM CHECK CURE Rotisserie burner does not light. Did you hold the burner control knob in and hold in for 20 seconds until after burner ignited? Try to relight burner by holding burner control knob in and continue holding in until 20 seconds after burner has ignited.
www . weber.com ® 25 25 maiNteNaNce MAIN BURNER CLEANING PROCEDURE TURN OFF THE GAS SUPPLY. Remove the manifold (See “Replacing Main Burners”). Look inside each burner with a flashlight. Clean the inside of the burners with a wire (a straightened-out coat hanger will work).
www . weber.com ® 26 maiNteNaNce Be careful not t o break or disconnect the wires f or the control panel lights. Rest the contr ol panel against the lef t side of the grill (A) exposing the v alv es, b urners, igniter , and manifold. 8) Remov ethet woscre wsthatsecurethemanif oldtothecookbo x.
www . weber.com ® 27 27 ANNUAL MAINTENANCE INSPECTION AND CLEANING OF THE SPIDER/INSECT SCREENS To inspect the Spider/Insect screens, remove the control panel. If there is dust or dirt on the screens, remove the burners for cleaning the screens. Brush the Spider/Insect screens lightly with a soft bristle brush (i.
www . weber.com ® 28.
www . weber.com ® 29 29.
©2009The following tr ademarks are register ed in the name ofWeber -Stephen P roducts Co ., an Illinois corporation, located at 200 East D aniels Road, P alatine, Illinois 60067 U .
PLEASE CONTINUE ON BACK / POR F A VOR CONTINÚE EN EL REVERSO / VE UILLEZ CONTINUER A U VERSO. ➤ ➤ ➤ thaNK you F or purchasiNG a weber ® Grill. you’ve maDe a wise iNvestmeNt , Now t aKe a Few miNutes aND protec t it by re GisteriNG your proDuct .
©2008 We ber-Stephen Products Co. All rights reser v ed. Printed in U.S.A. 557 98_0708 Thanks for sha ring your contact inform ation with us. Aga in, it all stays strictly between us — Weber does not sh are customers’ names with anyone else.
An important point after buying a device Weber S-460 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Weber S-460 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Weber S-460 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Weber S-460 you will learn all the available features of the product, as well as information on its operation. The information that you get Weber S-460 will certainly help you make a decision on the purchase.
If you already are a holder of Weber S-460, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Weber S-460.
However, one of the most important roles played by the user manual is to help in solving problems with Weber S-460. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Weber S-460 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
