Instruction/ maintenance manual of the product TC-NT2 TRENDnet
Go to page of 8
TC-NT2 TC-NT2 PROFESSIONAL NETWORK TESTER INSTRUCTION MANUAL.
The Network Cable T ester comes in two modular units, a master unit and a remote terminator . The modular design enables the tester to be used for local loop-back test of a patch cable or remote testing of pre-installed premise wiring.
FEA TURES: 1. T ests pin to pin connection of cables. 2. For loop-back and remote testing. 3. Auto - scan and manual step testing. 4. Checks for opens shorts and cross connected wires. 5. T ests Lan, T elcom, UTP/STP and coax BNC cables. 6. T one feature easily locates remote cable ends.
into the respective jacks (TX, RX) on the master unit. 2. Set the power switch to ON. (a) Auto Scan Mode: Press and release the AUTO button, the LED in the TX row will scroll in sequence (1,2,..., shield and repeat), to indicate the pins being tested.
straight, reverse, miss-wire...etc.) can be determined. i) If more than one LED from the same row is lit or if TX & RX LEDs are unlit simultaneously- This indicates a short . ii) If a LED is skipped - This may indicate an open or a burnt out LED. iii) If no LED will light - please check or replace your battery .
B. REMOTE TEST 1. Connect one end of the test cable to the MASTER unit marked TX . 2. Set the power switch to ON and set the tester to Auto scan. The TX LED will begin to scroll in sequence (1,2,3,..., shield and repeat), to indicate the pins being tested.
cable 1. Set the power switch to ON/TONE and by pressing the TEST button to select a pin to carry a tone or set the tester to AUTO scan, a sequencing tone is supplied on each of the 8 pins, shield and BNC cable. Or set the main unit on shield position.
3. RJ45 to RJ45 patch cord. 4. Carrying pouch. 5. User guide. E. REMARKS 1. The Master tester runs on one 9V standard or alkaline battery . 2. Please make sure the battery is fresh and have sufficient power . If a battery is weak or fails, the LED indicators will be dim or fail to light.
An important point after buying a device TRENDnet TC-NT2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought TRENDnet TC-NT2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data TRENDnet TC-NT2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, TRENDnet TC-NT2 you will learn all the available features of the product, as well as information on its operation. The information that you get TRENDnet TC-NT2 will certainly help you make a decision on the purchase.
If you already are a holder of TRENDnet TC-NT2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime TRENDnet TC-NT2.
However, one of the most important roles played by the user manual is to help in solving problems with TRENDnet TC-NT2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device TRENDnet TC-NT2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
