Instruction/ maintenance manual of the product M5580M-FSU Trango Broadband
Go to page of 33
M5580M – FSU Atlas Fox Wireless Multi Mode Ethernet Bridge Subscriber Unit USER MANUAL February 1 3, 2006.
Table of Contents Trango Trango Broad ba nd Wireless — M558 0 M-FSU (Atlas Fox ) User Manua l Revision 2 page 2 Revision 2 For Firmware V.2p0r8.
Table of Contents Trango Trango Broadba nd Wireless — M5580 M -FSU (Atlas Fox) U ser Manual Revision 2 page iii Table of Contents Preface ...............................................................................................................
Preface Trango Broad ba nd Wireless — M558 0 M-FSU (Atlas Fox ) User Manua l Revision 2 page iv Preface This manual covers the basic configuration and installation of the M5580M-FSU Wi reless Po int to Point Subscriber Unit. The M5580M-FSU consists of a radio with an internal 8 dBi.
Overview Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 1 Chapter 1 Overv iew Each M5580M-FSU acts as an endpoint in a point to multipoint wireless Ethernet trans.
Overview Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 2 Range vs. Throughp ut The followin g table shows a pproxim ate maxim um ranges (at recom mended fade margins ) achievable wi th the M5580M-FSU when associated with an M583 0S-AP in CCK mode.
Overview Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 3 System Contents Each kit consists of one radio with integ rated antenna, one power-ov er-Ethernet (PoE ) injector, one AC adapter, One boot, a nd mount ing hardware .
Overview Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 4 Location of Serial Number & MAC Address The serial number and MAC address label can be found on the back of each radio. The serial number and MAC address is also provided on the system information screen.
Overview Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 5 Location of RJ-45/LED Port The RJ-45 connector, diagnostic LEDs, and reset button are located at the bottom of the radio. Functionality of the LEDs is described later in this text.
Getting Started Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 6 Chapter 2 Getting Started It is recommended that you first provision and test y our the radios on the bench before deplo y ing them in the field. This is a particularly useful exercise for the novice user.
Getting Started Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 7 Configuration Tools M5580M-FSU radios can be configured using either the Command Line Interface (CLI), or the Web Browser (HTTP) interface. Although both methods are comprehensive and powerful, the CLI method provides slightly more functionality.
Getting Started Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 8 System Information (sysinfo) Page To display syst em confi guration and status inform ation type the comm and sysinfo at prom pt. #> sysinfo [Hardwar e Version ] 5580 [MVC Version] 3893mvc_4p5_05091 3.
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 9 Chapter 3 Configur ation Key Concepts Prior to configuring the radios, it is important to understand several key con cepts: Access Point (AP) The AP is typically considered the primary radio within the lin k .
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 10 Subscriber Unit Basic Settings Log into the SU. To receive a comprehensive snapshot of the system’s configuration info and status, type the command sysinf o .
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 11 to execute commands from the #>Set suid 3 AP to this specific SU. AP ID Informational parameter that shows to which AP the SU is Informational Parameter associated.
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 12 AP Autoscan Software switch (1) is to sw 1 [<on | off>] (default is on) turn AP autoscan on or off.
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 13 [Remarks] Remarks [ARQ] on [RF Rx] 0 Kbps [RF Tx] 0 Kbps [Eth Rx] 3 Kbps [Eth Tx] 92 Kbps [Eth Rx] 66,191 bytes [Eth Tx] 79,526 b ytes [RF Rx] 0 by tes [ RF Tx] 0 by tes Success.
Configuration Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 14 If no VALID AP or SU signal is d etect ed the LEDs will not be on at all. In addition, these 4 LEDs shall flash ON for 2 seconds, then OFF for 2 seconds to indicate the 'factory reset' button has been activated and the reset su ccessful.
Using the HTTP Interface Trango Broadba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manual R evision 2 page 15 Chapter 4 Using the HTTP Interface This section describes a few more basic concepts and how to establish a basic w ireless link with the AP, using the Browser (HTTP) Interface.
Using the HTTP Interface Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 16 Configure Basic Cont. Figure 9 Navigation li nks are show n on the left si de of the br owser screen.
Using the HTTP Interface Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 17 Configure Basic Cont. 5. Entered B ase ID , AP ID (not required for establi shing a l ink), and SU ID (This settings must match those entered on the AP for this unit.
Using the HTTP Interface Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 18 Configure Basic Continuo If all settings are entered correctly, and if AP is within op erating ran g e, the SU will establish a wireless connection and Ethernet traffic will begin to pass across the wireless link.
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 19 Chapter 5 Deployment & Installation Once you are familiar with the basic operations of the M5580 M-FSU, y ou are ready for deployment in the field.
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 20 Freq 5788 MHz -98 / -98 -99 / -99 Freq 5792 MHz -85 / -98 -99 / -99 Freq 5796 MHz Ch 4 -79 / -98 -99 / -99 (Survey Cont.
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 21 Example: #> rssi Press any key to stop.
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 22 Strain relief and boot installation Prior to depl oyment, i nsert a properly terminated C at-5 Cable t hrough Boot and the Foa m strain relie f.
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 23 Figure 18 : M5580M-FSU Series SU Wall Mount Figure 19 : Mounting M5580M-FSU with .
Deployment & Installation Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 24 Figure 20 : M5580M – FSU / AD 5 80 0 -2 5 R e fl ect or Di s h on Pole Fi gure .
Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 25 Chapter 6 Cabling and W eather Consider ations Shielded twisted pair Cat-5 cable is recommended for all installations. The shield within the Cat-5 cable does need to be grounded.
Firmware Upgrade Procedure Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 26 Chapter 7 SNMP All current SUs support SNMP via the AP. All poll most be done t hrough the A P. See th e Access 5830 Us er Guide for further inform ation on SNM P.
Firmware Upgrade Procedure Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 27 Chapter 8 Firmware Upgr ade Procedure Before begi nning, ma ke sure that you have adequate TCP access to the unit.
Appendix B Specifications Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 28 Appendix B Command Set Summary Command Description Remarks Apsearch Search for near by APs.
Appendix B Specifications Trango Broad ba nd Wireless — M5580 M-FSU (Atlas Fox ) User Manua l Revision 2 page 29 Appendix A Specifications All specifications apply to M5580M-FSU unless otherwise noted. Data Parameters Modulation Format CCK Certification/Compliance FCC Part 15.
An important point after buying a device Trango Broadband M5580M-FSU (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Trango Broadband M5580M-FSU yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Trango Broadband M5580M-FSU - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Trango Broadband M5580M-FSU you will learn all the available features of the product, as well as information on its operation. The information that you get Trango Broadband M5580M-FSU will certainly help you make a decision on the purchase.
If you already are a holder of Trango Broadband M5580M-FSU, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Trango Broadband M5580M-FSU.
However, one of the most important roles played by the user manual is to help in solving problems with Trango Broadband M5580M-FSU. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Trango Broadband M5580M-FSU along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
