Instruction/ maintenance manual of the product 1010A Patton electronic
Go to page of 7
USER MANUAL MODEL 1010A Miniature, High Speed Short Range Modem with T ransformer Isolation SALES OFFICE (301) 975-1000 TECHNICAL SUPPORT (301) 975-1007 Part# 07M1010A-A Doc# 03901 1UA Revised 1 1/8/9.
A PPENDIX D BLOCK DIAGRAM 1.0 W ARRANTY INFORMA TION Patton Electronics warrants all Model 1010A components to be free from defects, and will—at our option—repair or replace the product should it fail within one year from the first date of shipment.
2.0 GENERAL INFORMA TION Thank you for your purchase of this Patton Electronics product. This product has been thoroughly inspected and tested and is warranted for One Y ear parts and labor .
3.0 CONFIGURA TION The Model 1010A is designed to be easy to use. There are no internal jumpers or DIP switches to set, so there is no need to open the case to configure the unit (you may need to open the case for wire connection—refer to section 4.
4.0 INST ALLA TION Once you have properly configured the DTE/DCE switch, you are ready to connect the Model 1010A to your system. This section tells you how to properly connect the Model 1010A to the twisted pair and RS-232 interfaces, and how to operate the Model 1010A.
When connecting two Model 1010As, it is necessary to use a "cross over" cable. The diagram below shows how a cross over cable should be constructed for an environment where both Model 1010As use a 6-wire RJ-1 1 connector . Similar logic should be followed when using RJ-45 connectors or a combination of the two.
1. Open the unit by gently inserting a screw driver between the DB-25 connector and the lip of the plastic case (see below). Y ou don't have to worry about breaking the plastic, but be careful not to bend the D-sub connector . Once the unit has been opened, you will be able to see the terminal blocks located at the rear of the PC board.
An important point after buying a device Patton electronic 1010A (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Patton electronic 1010A yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Patton electronic 1010A - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Patton electronic 1010A you will learn all the available features of the product, as well as information on its operation. The information that you get Patton electronic 1010A will certainly help you make a decision on the purchase.
If you already are a holder of Patton electronic 1010A, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Patton electronic 1010A.
However, one of the most important roles played by the user manual is to help in solving problems with Patton electronic 1010A. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Patton electronic 1010A along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
