Instruction/ maintenance manual of the product King Kooker OUTDOOR COOKER Metal Fusion
Go to page of 24
W ARNING ® ASSEMBL Y INSTRUCTIONS AND USE AND CARE MANUAL READ OPERA TING INSTRUCTIONS BEFORE USING YOUR GRILL. RET AIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. MET AL FUSION, INC. 712 St. George A venue. Jef ferson, LA 70121 For Questions and Information Call Us T oll Free at 1-800-783-3885 8:00 AM to 3:30 P .
FOR YOUR SAFETY If you smell gas: 1. Shut of f gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, immediately call your gas supplier or your fire department. IMPOR T ANT SAFETY INFORMA TION 1. Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
3 1) Use the products only outdoors, and only on a noncombustible surface such as brick, concrete, or dirt. NOT SUIT ABLE are surfaces such as wood, asphalt or plastic which may burn, blister , or melt. Do not use under any overhang or roof and keep a minimum of 10 feet of clearance on all sides of the cooker .
4 8) King Kooker ® products are designed for use with propane gas, with the regulator supplied with the product, and must never be used with natural gas. Accessories not recommended by Metal Fusion, Inc., must not be used with King Kooker ® appliances.
5 READ AND UNDERST AND ALL INSTRUCTIONS BEFORE USING YOUR KING KOOKER ® PRODUCT T ABLE OF CONTENTS W ar nings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-4 T able of Contents .
6 MET AL FUSION, INC. LIMITED ONE-YEAR W ARRANTY WHA T THIS W ARRANTY COVERS This warranty covers all components of this outdoor cooker to be free from defects in materials and workmanship, with the exceptions stated below . HOW LONG COVERAGE LASTS This warranty runs for one year from the date of purchase.
7 OWNER’S REGISTRA TION Dear Customer , Thank you for purchasing a King Kooker ® ! Please take a moment to fill out your registration form and return it to us. We are always happy to hear suggestions and comments from our customers about our products.
8 ________________________ ________________________ ________________________ MET AL FUSION, INC. 712 St. George A venue Jefferson, LA 70121 Place Stamp Here FOLD FOLD TAPE HERE.
ASSEMBL Y INSTRUCTIONS FOR COOKERS WITH CAST IRON BURNERS NOTE: The following are general instructions for 5-6” Cast Burners. If your cooker is a 101 PK or has an 1 1” Cast Burners, please refer to the special assembly instructions which have been written especially for these units.
10 NOTE: If your cooker has attachable legs or work table, follow the assembly instructions for these before pr oceding to the Use and Care section. Figure 2 LP GAS T ANK COOKING PO T VENTURI TUBE AIR SHUTTER SPRING 3/8 FEMALE FLARE SWIVEL BURNER ADJUST ABLE REGULA T OR P .
3/8 FEMALE FLARE SWIVEL JET BURNER LP GAS T ANK ADJUST ABLE REGULA T OR P .O .L. CONNECTION (LEFT HAND THREAD) N O BRASS AD APTER ORIFICE CAP (DO NOT REMOVE THIS FITTING) (SOME MODELS MA Y HA VE NEEDLE V AL VES AND PRESSURE REGULA T ORS AS PER FIGURE 3) JET BURNER ASSEMBL Y INSTRUCTIONS TOOLS REQUIRED: ADJUST ABLE WRENCH, LEAK TESTING SOLUTION 1.
12 1. Procedures for assembly of all Camp Stoves is the same, only the number of burners vary . 2 Place burner frame on side so that the casting ends are turned upward.
101 PK ASSEMBL Y INSTRUCTIONS The following warnings are to be followed when using the 101 PK in addition to all other warnings listed in this manual. Obser ve these safety precautions when using a 14.
11” CAST COOKER ASSEMBL Y Required T ools: Adjustable Wrench and Leak T esting Solution 1. Wrench tighten the brass control valve to the 1 1” casting. 2. Wrench tighten the brass 3/8” flare swivel fitting to the brass control valve. 3 . T ighten left handed threads on POL nut hand tight to the cylinder and then secure with a wrench.
15 95 PKP LEG ASSEMBL Y Required T ools: Adjustable Wrench 1 . Match the holes in each leg with the corresponding holes in the cooker . 2. Slide one 1/4” x 1” bolt through each of the twelve holes. These should be directed inward as in the illustration so that the nuts will be on the inside of the assembly .
16 CAMP STOVE LEG ASSEMBL Y Required T ools: Adjustable Wrench 1. Match the holes in each leg with corresponding holes in cooker . 2. Slide 1/4” x 1” bolt through each of the twelve holes. These should be directed inward as in the illustration so that the nuts will be on the inside of the assembly .
17 CS 5 LEG ASSEMBL Y Required T ools: Adjustable Wrench 1. Match the holes in each leg with corresponding holes in cooker . 2. Slide 1/4” x 1” bolt through each of the twelve holes. These should be directed inward as in the illustration so that the nuts will be on the inside of the assembly .
106 PK AND 106 PKPT EXTENSION LEGS ASSEMBL Y INSTRUCTIONS Required T ools: Adjustable Wrench 1. Match the holes in each leg with corresponding holes in cooker . 2. Slide one 1/4” x 1” bolt through each of the three holes in each extension leg and cooker leg.
19 MODEL #TWT WORKT ABLE ASSEMBL Y Required T ools: Adjustable Wrench This unit is designed to be used as a worktable for the preparation of turkeys for frying and for draining afterwards. It is not intended for any other use. It is to be used only with Deep Fryer T urkey Packages.
CONNECTION INSTRUCTIONS 1. Check that your 20 lb. LP gas cylinder is not over-filled. The maximum weight of a properly filled cylinder is approximately 38 lbs. 2. V erify that the cylinder valve has the proper connection for a P .O.L. appliance fitting.
PLACEMENT INSTRUCTIONS IMPOR T ANT PRECAUTIONS: 1. Appliance must be in open area with at least 10 feet of space on all sides. 2. There must be no combustibles or roof overhead. 3. There must be at least 2 feet of space between LP gas tank and cooker .
22 LIGHTING INSTRUCTIONS THE COOKER MUST NOT BE LIT UNTIL THE PRECEDING PLACEMENT INSTRUCTIONS HA VE BEEN COMPLETEL Y FOLLOWED. FOR MODELS WITH ADJUST ABLE REGULA TORS 1. Make certain that the regulator control is turned down to OFF . 2. Open cylinder control valve.
23 TURNING OFF AND STORING THE COOKER AFTER USE After each use turn OFF the King Kooker ® at the regulator/needle valve first, then at the gas cylinder valve. Check to make sure there is no flame and all valves are off before leaving the cooker . NEVER MOVE THE COOKER WHILE IN USE OR STILL HOT (ABOVE 100˚F).
KING GRILLEDINE, KING KOOKER, the KING KOOKER logo, THE KING, THE KING OF OUTDOOR COOKING, and MR. OUTDOORS are trademarks of Metal Fusion, Inc., 712 St.
An important point after buying a device Metal Fusion King Kooker OUTDOOR COOKER (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Metal Fusion King Kooker OUTDOOR COOKER yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Metal Fusion King Kooker OUTDOOR COOKER - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Metal Fusion King Kooker OUTDOOR COOKER you will learn all the available features of the product, as well as information on its operation. The information that you get Metal Fusion King Kooker OUTDOOR COOKER will certainly help you make a decision on the purchase.
If you already are a holder of Metal Fusion King Kooker OUTDOOR COOKER, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Metal Fusion King Kooker OUTDOOR COOKER.
However, one of the most important roles played by the user manual is to help in solving problems with Metal Fusion King Kooker OUTDOOR COOKER. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Metal Fusion King Kooker OUTDOOR COOKER along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
