



* IR Illumination Range under ideal conditions. Objects at or beyond this range may be partially or completely obscured, depending on the camera application. ** Not intended for submersion in water. Installation in a sheltered location recommended.
189mm / 7.4”
67mm / 2.6”
60mm / 2.4”

Copyright © 2012 Lorex Technologies Inc. As our products are subject to continuous improvement, Lorex reserves the right to modify product design, specifications and prices, without notice and without incurring any obligation. E&OE

Installing the Camera Connecting the Camera Cable Extension Options Extend the cable run for your camera up to 300ft or more depending on the cable type used. See table below:


Notes:
Connect the BNC and power connectors to the camera
Connect the BNC connector to the video input of the monitor / DVR, and connect the included power connector to a power adapter. See Setup Diagram below for details.

Troubleshooting

2. Drill the holes for the mounting screws. 3. Connect the video and power cables as shown in the next section ‘Connecting The Camera‘. 4. Feed the cable through the cable notch (if running the cables along the wall / ceiling) or through the mounting surface (if running the cables through the wall / ceiling). 5. Mount the camera stand to the desired surface using the provided screws. Make sure all three screws are fastened tightly at the connection points. 6. Set the position and angle of the camera using the provided Allen key.
Attach the included BNC to RCA adapter to connect the extension cable to RCA inputs (i.e. for a TV connection).



Male Power · Female Power · Cable Notch
Common problems, likely causes, and what to do.
| Problem | Possible cause | Remedy | |
|---|---|---|---|
| No picture / signal | • Ensure your TV is on the correct input channel. Common terms of an input channel: INPUT, AV CHANNEL, LINE1, LINE2, AUX. • If your camera is connected to a VCR / DVR, ensure it is properly connected to your TV / Monitor. • Ensure connections are properly connected. • Ensure the camera power supply is plugged in. | p.2 | |
| Picture is too bright | • Ensure your camera isn’t pointed directly at a source of light (e.g. sun or spot light). • Slide the sunshade (bullet cameras featuring adjustable sunshades only) forward to block excess light. • Move your camera to a different location. | p.2 | |
| Picture is too dark | • If using during the day, the camera may not be getting enough light. Slide the sunshade (bullet cameras featuring adjustable sunshades only) backwards to let in more light. • Check the brightness and contrast settings of the device your camera connects to (TV / Monitor / DVR). | p.2 | |
| Night vision is not working | • The night vision activates when light levels drop. The area may have too much light. | p.2 | |
| Picture is not clear | • Check the camera lens for dirt, dust, spiderwebs. Clean the lens with a soft, clean cloth. • Make sure that the cable run is within the limitations specified in the section ‘Cable Extension Options’. | p.2 | |
| Bright spot in video when viewing camera at night | • Night vision reflects when pointing a camera at a window. Move the camera to a different location. | p.2 | |
| BNC connection does not connect to my TV. | • Use a BNC to RCA adapter at the end of the extension cable. | p.2 |
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.