Instruction/ maintenance manual of the product RH-25-6 Langley/Empire
Go to page of 16
Page 1 12821-6-0406 VENTED ROOM HEA TER MODELS RH-25-6 RH-35-6 EFFECTIVE DA TE APRIL 2006 INST ALLA TION INSTRUCTIONS AND OWNER’S MANUAL — Do not store or use gasoline or other flam- mable vapors and liquids in the vicinity of this or any other appliance.
Page 2 12821-6-0406 SECTION P AGE Important Safety Information ......................................................................................................................3 Safety Information for Users of LP Gas .............................
Page 3 12821-6-0406 • Due to high temperatures, the r oom heater should be located out of traffic and away fr om furnitur e and drap- eries. • Childr en and adults should be alerted to the hazards of high surface temperatur e and should stay away to avoid burns or clothing ignition.
Page 4 12821-6-0406 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. Y ou must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor .
Page 5 12821-6-0406 Introduction Always consult your local Building Department regarding regu- lations, codes or ordinances which apply to the installation of a vented room heater . Instructions to Installer 1. Installer must leave instruction manual with owner after instal- lation.
Page 6 12821-6-0406 Note: Never use plastic pipe. Check to confirm whether your local codes allow copper tubing or galvanized. Note: Since some municipalities have additional local codes, it is always best to consult your local authority and installation code.
Page 7 12821-6-0406 Clearances: When facing the front of the room heater the mini- mum clearances to combustible construction (material) are the following: Right side 6 inches (152mm). Left side 6 inches (152mm). Recommend 18 inches (457mm) on left side for servicing.
Page 8 12821-6-0406 This heater must be properly connected to a venting system. This heater is equipped with a vent safety shutoff system. W arning: Operation of this heater , when not connected to a .
Page 9 12821-6-0406 1. STOP! Read the safety information to the left of this label. 2. Set thermostat to lowest setting. 3. T urn off all electric power to the appliance. (If applicable) 4. Remove access panel (front panel). 5. Push in gas control knob slightly and turn clockwise to “OFF”.
Page 10 12821-6-0406 The correct flame will be almost horizontal, blue and will extend past the thermocouple 1/4" (6mm). The flame will surround the thermocouple just below the tip. On Propane (LP-gas) slight yellow might occur where the pilot flame and the burner flame meet.
Page 1 1 12821-6-0406 T o Remove Main Burner 1. Disconnect the thermocouple and pilot supply line at the pilot burner . 2. Unscrew the nut on the orifice fitting union. Orifice fitting is threaded into the main burner . 3. Remove screw on each side of the main burner and lift out.
Page 12 12821-6-0406 INDEX NO. P AR T NUMBER DESCRIPTION 1 R-6096 Knob & Adaptor Set 2 1 1700 Control Rod Bracket 3 R-2706 ECO Switch 4 R-8195 ECO W ire Assembly 5 1 1699 Control Rod 6 R-6104 Gas .
Page 13 12821-6-0406.
Page 14 12821-6-0406 DRB-1 For V ented Room Heaters Models RH-25-(1, 2, 4, 5, 6) and RH-35-(1, 2, 4, 5, 6) Dir ect V ent W all Furnaces DV -25-(1, 2)SG and DV -35-(1, 2)SG Installing Optional DRB-1 Blower 1. For RH-25-(1, 2, 4, 5, 6) and RH-35-(1, 2, 4, 5, 6) , remove casing front.
Page 15 12821-6-0406 Code, CSA C22.1 , if an external electrical source is utilized. This appliance is equipped with a three-pr ong [grounding] plug for your protection against shock hazard and should be plugged directly into a pr operly grounded three-pr ong receptacle.
Page 16 12821-6-0406 Empire Comfort Systems, Inc. 918 Freeburg A ve. Belleville, IL 62220 PH: 618-233-7420 or 800-851-3153 F AX: 618-233-7097 or 800-443-8648 info@empirecomfort.
An important point after buying a device Langley/Empire RH-25-6 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Langley/Empire RH-25-6 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Langley/Empire RH-25-6 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Langley/Empire RH-25-6 you will learn all the available features of the product, as well as information on its operation. The information that you get Langley/Empire RH-25-6 will certainly help you make a decision on the purchase.
If you already are a holder of Langley/Empire RH-25-6, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Langley/Empire RH-25-6.
However, one of the most important roles played by the user manual is to help in solving problems with Langley/Empire RH-25-6. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Langley/Empire RH-25-6 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
