Instruction/ maintenance manual of the product 415.1615111 Kenmore
Go to page of 28
Use & Care Guide Model: 415.16151110 ® ® ® P/N G550-001-020801 Sears Brands Management Corporation Hoffman Estates, IL 60179 U.S.A. www.kenmore.
If you smell gas: |. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lld. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. |. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
For Your Safety ...................................... 2 Grill Information Center .............................. 2 Product Record Information ........................... 2 Safety Symbols ...................................... 2 Installation Safety Precautions .
LP Tank / x, II _/ • NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cyllnder beyond 80°/0 full. • if the information in the two points above is not followed exactly, a fire causing death or serious injury may occur.
LP Tank Exchange * Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks.
Hold coupllng nut and regulator as shown for proper connection to LP tank valve. Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise.
For Safe Use of Your Grill and to Avoid Serious Injury: • Do not let children operate or play near grill. • Keep grill area clear and free from materials that burn. • Do not block holes in sides or back of grill. • Check burner flames regularly.
Turn controls and gas source or tank OFF when not In use. if ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure, if the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accldently ignite with risk of injury.
f CAUTION SPIDER ALERT! if you notice that your griIJ is getting hard to light or that the flame isn't as strong as it should be, take the time to check and dean the burner tubes. SPIDER WEBS CONTROL PANEL INSIDE BURNER TUBE i BURNER Spiders or smafl insects have been known to create "flashback" problems.
Indirect Cooking Poultry and large cuts of meat cook slowly to perfection on the grill by indirect heat. Place food over unlit burner(s); the heat from lit burners circulates gently throughout the grill, cooking meat or poultry without the touch of a direct flame.
I I Key Qty Description Part# 1 1 LEFT LEG ASSEMBLY G550-1300-W1 2 1 MATCH HOLDER G401-OO79-W1 3 1 RIGHT LEG ASSEMBLY G550-1400-W1 4 1 BOTTOM SHELF G550-0800-W1 5 1 FRONT PANEL G550-O900-W2 6 2 TANK E.
® _ii ¸ _i!i_!i © 12 o 464220311.
CAUTION: When unpacking grill components, two people should raise grill head from the shipping box. E1 Bottom Shelf to Legs [] Place bottom shelf end with cut out hole for LP cylinder between leg assembly with axle holes. Attach to right and left leg assemblies with (4) 1/4-20x1-1/2" screws and (4) 1/4-20 flange nuts.
B Front Panel [] Attach front panel to grill cart with (6) #8-32x3/8" sheet metal screws. Make sure metal tabs for tank exclusion wires are toward the bottom of cart.
Wheels and Leg Extenders to Cart [] Turn cart assembly upside down. [] Insert axle rod through wheel, wheel spacer, legs and other wheel. Be sure to face "cone" side of wheel against leg. Attach with (t) axle washer and hitch pin. [] Hammer leg extenders into right legs.
Grill Head to Cart [] Stand cart upright. [] This step requires two people to lift and position grill head onto cart. [] Carefully lower the grill head onto the cart. Make sure the regulator hose is hanging outside the cart. Attach head to cart with (4) 1/4-20xl/2" screws.
Right Side Shelf [] Attach towel bar to right side shelf with (2) #10-24x3/8" screws, 5mm lock washers and 5ram flat washers (A). [] Hook side walt of shelf over support brackets on side of firebox (B).
Side Burner Shelf [] Hook side wall of side burner shelf over support brackets on side of firebox (A). [] Inside firebox insert (4) fiber washers and (4) 1/4-20xl/2" screws as shown (B). [] Attach shelf using (4) 1/4-20 flange nuts (C). Lid removed for clarity Side Burner Shelf / 1/4-20xl/2" screws Qty.
Sideburner Valve, $ideburner Sideburner Bezel, Ignitor Wire, Control Knob [] Position valve behind fascia and line up holes (A). [] Insert (1) of the #8-32x3/8" stainless steel screws, but do not fully tighten. [] Slip bezel under inserted screw and position as shown (A).
Heat Shield [] Attach heat shield over burners inside front of grill with (2) #8-32x3/8" sheet metal screws. Heat Shield / #8-32x3/8" sheet metal screws Qty.
Heat Diffusers [] Place heat diffusers over burners by inserting tabs into slots in front of firebox. Opposite ends of heat diffusers rest on pins in back of firebox. Cooking Grate and Swing Away [] Place cooking grates onto grate rests. [] Insert ends of Swing Away pivot wire into holes in sides of grill lid.
Grease Cup Cllp, Grease Cup, Grease Tray [] Hang grease cup clip from bottom of grease tray and place grease cup into grease cup clip. Place the tray into the cart. Tio. Failure to install grease cup clip and cup will cause hot grease to drip From bottom of grill with risk of fire or propertydamage.
EMERGENCIES: Jf a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection.
Troubleshootlng (continued) Burner(s) will not light using ignitor. (See Electronic Ignition Troubleshooting also) Burner(s) will not match light. Sudden drop in gas flow or low flame. Flames blow out. Flare-up. ELECTRONIC IGNMON: No spark, no ignition noise.
Troubleshooting - Electronic Ignltion SECTION I No sparks appear at any electrodes when Electronic Ignition Button is pressed; no noise can be heard from spark module. SECTION II No sparks appear at any electrodes when Electronic Ignition Button is pressed; noise can be heard from spark module.
26 o 464220311.
464220311 o 27.
iiiiiiiiiiiiiiiiiiiiii!ii_Y iiiiiiiiiiiiiiiiiiiiii _ iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii Your Home For troubleshooting, product manuals and expert advice: managemylife wv, rw.
An important point after buying a device Kenmore 415.1615111 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenmore 415.1615111 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenmore 415.1615111 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenmore 415.1615111 you will learn all the available features of the product, as well as information on its operation. The information that you get Kenmore 415.1615111 will certainly help you make a decision on the purchase.
If you already are a holder of Kenmore 415.1615111, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenmore 415.1615111.
However, one of the most important roles played by the user manual is to help in solving problems with Kenmore 415.1615111. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenmore 415.1615111 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
