Instruction/ maintenance manual of the product 415.1613911 Kenmore
Go to page of 24
Use & Care Guide ModeJ: 415.16139110 I<e ore Elite @ @ @ P/N G523-001-010801 Sears Brands Management Corporation Hoffman Estates, IL 60179 U.S.A.
If you smell gas: |. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lld. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. |. Do not store or use gasoline or other flammable liquids or vapors in the vicinity of this or any other appliance.
For Your Safety. ............................................................. 2 Grill Information Center ............................................. 2 Product Record Information ........................................ 2 Safety Symbols ............
LP Tank f x, II _I • NEVER store a spare LP cylinder under or near the appliance or in an enclosed area. • Never fill a cyllnder beyond 80°/0 full. • if the information in the two points above is not followed exactly, a fire causing death or serious injury may occur.
LP Tank Exchange * Many retailers that sell grills offer you the option of replacing your empty LP tank through an exchange service. Use only those reputable exchange companies that inspect, precision fill, test and certify their tanks.
Hold coupllncj nut and regulator as shown for proper connection to LP tank valve. Leak Testing Valves, Hose and Regulator 1. Turn all grill control knobs to OFF. 2. Be sure regulator is tightly connected to LP tank. 3. Completely open LP tank valve by turning OPD hand wheel counterclockwise.
For Safe Use of Your Grill and to Avoid Serious Injury: • Do not let children operate or play near grill. • Keep grill area clear and free from materials that burn • Do not block holes in sides or back of grill. • Check burner flames regularly.
Main Burner lcjnltor Lighting " Open grill lld during Lighting. • Do not lean over grill while lighting. I. Turn OFF all Gas Burner Control Valves. 2. Turn ON gas at LP cylinder. 3. To ignite any main burner, push in and turn the burner control knob to the _ position.
Sideburner Ignltor Lighting Do not lean over grill while lighting. 1. Open sldeburner lld. Turn ON gas at LP cylinder. 2. Turn sideburner knob to the HI position, push and hold ELECTRONIC IGNITOR button. 3. If sideburner does NOT light within 5 seconds, turn knob to OFF, wait 5 minutes, then repeat lighting procedure.
Cleaning the Main Burner Assembly Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill. 1. Turn gas off at control knobs and LP Tank. 2. Remove cooking grates and heat diffusers. 3. Remove electrode from burner by prying the clip away as shown in Figure A.
Grill Halogen Light LIGHT OPERATION iNSTRUCTiONS 1. Make sure light switch on the control panel is in the "OFF" position. 2. Connect light plug to an extension cord, then plug the extension cord into the outlet on the wall. 3. Turn the light switch to "ON'.
Cleaning the Lens 1. Prior to cleaning, make sure the light switch is in the "OFF" position and the light plug is disconnected from the power supply. 2. Do nat dean the glass lens when warm. Allow to coal before cleaning. Sudden change in temperature may cause cracking of the glass lens.
1 1 LEFT SIDE SHELF G523-1100-W1 48 1 BOTTOM SHELF G523-0025-W1 2 1 FASCIA, LEFT SHELF G523-OO51-W1 49 2 DOOR MAGNET ASSEMBLY G501-0016-W2 3 1 RIGHT SIDE SHELF G523-1200-W1 50 1 TANK SHELF ASSY G523-4.
® 14,464224211.
insert flange on left side shelf into side shelf brackets, shown A. Attach left side shelf rear using two 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown Bo Attach left side shelf front using three 1/4-20xl/2" screws, 7mm lock washers and 7mm fiat washers, shown C 4-20x1/2 '' screw 7mm lock washer y.
insert flange on right side shelf into side shelf brackets, shown A. Attach right side shelf top using two 1/4-20x3/4" screws, 7mm fiat washers, 7mm lock washers and 1/4" nuts, shown B. Attach right side shelf rear using one 1/4-20x3/4" screw, 7mm lock washer and 7mm flat washer, shown C.
Install heat diffusers by sliding one end of each heat diffuser into slots at front of firebox and resting opposite end on pins at back of firebox. Make sure to install the shorter heat diffuser in A position, and install the two longer heat diffusers in B and C position.
Place sideburner grate into sideburner shelf, aligning grate legs with holes in shelf. On back of grill, slide grease tray into opening in lower back panel. U CAUTION Failure to install grease tray will cause hot grease to drip from bottom of grill with risk of Nre or property damage.
H Unscrew electronic ignition cap on cart right side panel. Insert AA battery into ignitor, negative(-) end first. Replace the cap. A_ Battery Electronic Ignition Cap LP TANK IS SOLD SEPARATELY. Fitl and leak check the tank before attaching to grill and regulator (see Use & Care section).
install door organizers Back of left door: Attach bag hook by inserting wire ends in the holes on the door, shown A. Attach condiment tray by sliding it onto tabs on lower door back panel, shown A. Back of right door: Attach condiment trays by sliding them onto tabs on upper and lower door back panel, shown B.
EMERGENCIES: Jf a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department. Gas leaking from cracked/cut/burned hose. Gas leaking from LP cylinder. Gas leaking from LP cylinder valve. Gas leaking between LP cylinder and regulator connection.
Troubleshootlng (continued) Burner(s) will not light using ignitor. (See Electronic Ignition Troubleshooting also) Burner(s) will not match light. Sudden drop in gas flow or low flame. Flames blow out. Flare-up. ELECTRONIC IGNMON: No spark, no ignition noise.
Troubleshooting - Electronic Ignltion SECTION I No sparks appear at any electrodes when Electronic Ignition Button is pressed; no noise can be heard from spark module. SECTION II No sparks appear at any electrodes when Electronic Ignition Button is pressed; noise can be heard from spark module.
iiiiiiiiiiiiiiiiiiiiii!ii_Y iiiiiiiiiiiiiiiiiiiiii _ iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiiiii Your Home For troubleshooting, product manuals and expert advice: managemylife wv, rw.
An important point after buying a device Kenmore 415.1613911 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Kenmore 415.1613911 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Kenmore 415.1613911 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Kenmore 415.1613911 you will learn all the available features of the product, as well as information on its operation. The information that you get Kenmore 415.1613911 will certainly help you make a decision on the purchase.
If you already are a holder of Kenmore 415.1613911, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Kenmore 415.1613911.
However, one of the most important roles played by the user manual is to help in solving problems with Kenmore 415.1613911. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Kenmore 415.1613911 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
