Instruction/ maintenance manual of the product GF941 Hotpoint
Go to page of 20
Instructions for Installation and Use Hob Models GF960, GF941.
.
3 CONTENTS Introduction For Your Safety Know your Hob How to use your Hob Practical Advice Care and Cleaning Troubleshooting Installation Electrical Connection Characteristics of Burners and Nozzels A.
4 Your new hob is guaranteed* and will give lasting service. This guarantee is only applicable if the appliance has been installed in accordance with the installation instructions detailed in this booklet. To help make best use of your cooking equipment, please read this booklet carefully.
5 For Your Safety ALWAYS: - make sure you remove all packaging and dispose of safely. - check the soundness of the appliance after it has been unpacked. - make sure you understand the controls before using the appliance. - keep children away from the appliance during use.
6 B. Pan Support for Cookware C. Control Knobs D. Ignitor for Gas Burners F. Flame Failure Device - Activates if the flame accidentally goes out (spills, drafts, etc.
7 How To Use Your Hob The position of the corresponding gas burner is indicated on each control knob. Gas Burners The burners differ in size and power.
8 Practical Advice on Using the Burners F or best perf ormance, f ollow these gener al guidelines: • Use the appropriate cookware f or each bur ner (see table) in order to pre vent the flame from re.
9 Practical Advice Practical Advice on Using the Griddle Preheat the griddle by turning the knob to 12. Settings 1-8 are recommended for reheating food or for keeping it warm after it has been cooked. In general, cooking vegetables can cause stains which are difficult to remove.
10 Care and Cleaning Before cleaning or performing maintenance on your hob, disconnect it from the power supply. To extend the life of the hob, it should be cleaned carefully and thoroughly on a frequent basis, keeping in mind the following: · Do not use steam equipment to clean the appliance.
11 Troubleshooting If the burner does not remain on when set to "Low". Check to make sure that: • The gas holes are not clogged. • There are no draughts near the cooking surface. • The minimum has been adjusted correctly (see Installation section, "Minimum Regulation").
12 Installation The following instructions are intended for the installer so that the installation and maintenance procedures may be followed in the most professional and expert manner possible. Important: Disconnect the appliance from the electrical suppl y before performing any maintenance or repair.
13 Installation Hook position for Hook position for H=30mm top H=40mm top Front Hook position for Back H=20mm top N.B: Use the hook contained in the "accessoires set" f) In the event the hob is not installed above a built-in oven, a wood panel must be inserted as insulation.
14 Installation Adapting the Hob for Different Types of Gas To adapt the hob to a different type of gas than that for which it was designed, (see the sticker under the hob or on the packaging), the burner nozzles must be changed, as follows: • Remove the pan supports and slide the burners out of the hob.
15 Electrical Connection Electrical connection WARNING: THIS APPLIANCE MUST BE EARTHED. The hob is designed to work with alternating current, the supply voltage and frequency indicated on the rating plate (situated under the hob). Make sure that the local supply voltage corresponds to the voltage indicated on the rating plate.
16 Characteristic of the burners and nozzles * At 15°C and 1013 mbar-dry gas * * Propane P.C.S. = 50,37 MJ/kg * * * Butane P.C.S. = 49,47 MJ/kg Naturale P.C.S. = 37,78 MJ/m 3 (1) for models with security device (ref. F ). T able 1 Liquid gas Natural gas Burner Dia meter (mm) The rmal po wer kW (p.
17 Notes.
GB 18 "No company is better positioned to offer an after sales service on a Hotpoint appliance than us - the manufacturer" As part of our commitment to you, all Hotpoint appliances have the added benefit of a fully inclusive parts and labour guarantee for the first 12 months.
GB 19 Guarantee "Satisfaction guaranteed or your money back" We give you a unique 'satisfaction guaranteed' promise - valid for 90 days - after you have purchased your Hotpoint appliance. If there is a technical problem simply call Hotpoint Repair service or visit our web-site at www.
10/2005 P ar t no . FP163 - 01 Over 1200 trained specialists, directly employed by us, ensure that you can have complete confidence in both the appliances and services we offer. Repair Service and Information Desk UK: 08709 066 066 (Open 8 to 8 Mon - Fri, 8 to 6 Sat, 10 to 4 Sun & Bank Holidays) www.
An important point after buying a device Hotpoint GF941 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hotpoint GF941 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hotpoint GF941 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hotpoint GF941 you will learn all the available features of the product, as well as information on its operation. The information that you get Hotpoint GF941 will certainly help you make a decision on the purchase.
If you already are a holder of Hotpoint GF941, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hotpoint GF941.
However, one of the most important roles played by the user manual is to help in solving problems with Hotpoint GF941. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hotpoint GF941 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
