Instruction/ maintenance manual of the product 3CS2 Hatco
Go to page of 20
HYDRO-HEA TER Sanitizing Sink Heaters Food Rethermalizers/Bain-Marie Heaters Installation & Operating Manual I&W #07.05.133.00 This manual contains important safety information concerning the maintenance, use, and operation of this product. Failure to follow the instructions contained in this manual may result in serious injury .
Sanitizing Sink Heaters and Food Rethermalizers/Bain- Marie Heaters. W e recommend all installation, operating and safety instructions appearing in this manual be read prior to installation or operation of your Hatco Hydro- Heater .
CAUTIONS W ater in the unit and holding vessel is very hot. W ear protective gloves and pr oper attir e when operating to avoid injury . Do not use extension pipes on the inlet and outlet connections on heater units. Poor performance or unsafe conditions may occur .
IMPOR T ANT SAFETY INSTRUCTIONS 2 Form No. HHM-1 103 IMPOR T ANT! Read the following important safety instructions to avoid personal injury or death, and to avoid damage to the equipment or pr operty . CAUTIONS Do not overtighten unions or nuts. Overtightening may cause leaks.
Model 208 V olt 240 V olt FR2-3 NEMA 6-20P NEMA 6-20P FR2-4 NEMA 6-30P NEMA 6-30P SPECIFICA TIONS MODEL DESCRIPTIONS 3 ALL MODELS The Hydro-Heater mounts to the underside of a holding vessel, leaving the entire vessel area free. Units are shipped ready to install with all gaskets and fittings.
SPECIFICA TIONS 4 Form No. HHM-1 103 Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG*† Circuit Br eaker* Shipping W eight 3CS2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) 3CS2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) 3CS2-6 208 6 1 28.8 10 40 27 lbs.
Kilowatts Wir e Sizing Fuse or Model V oltage (kW) Phase Amps A WG* † Circuit Br eaker* Shipping W eight FR2-3 208 3 1 14.5 12 20 24 lbs. (1 1 kg) FR2-4 208 4 1 19.2 12 30 24 lbs. (1 1 kg) FR2-6 208 6 1 28.8 10 40 27 lbs. (12 kg) FR2-3 240 3 1 12.5 12 20 24 lbs.
SPECIFICA TIONS 6 Form No. HHM-1 103 SIZING INFORMA TION Hatco recommends the following guidelines be used to ensure proper operation and sanitation. For 3CS2 Series in a Manual W arewashing Application • Minimum 2000 watts (2 kW) per square foot (.
INST ALLA TION 7 PLUMBING An adhesive backed paper template is shipped with the unit and is used to locate the sink strainer holes. Use the following procedure to install the heater unit to the holding vessel. NOTE: The FR2 heater should be positioned with no mor e than 3' (914 mm) on either side when mounted under holding vessel.
INST ALLA TION 8 Form No. HHM-1 103 CAUTION Do not overtighten unions or nuts. Overtightening may cause leaks. NOTE: A 3/4" (19 mm) hose or pipe may be connected to the heater sump drain and run to an open sight drain. The sump drain should not be permanently connected to the sanitary drain system.
NOTE–AUTO-FILL UNITS ONL Y: When the tank water level r eaches the low water pr obe the display will show the curr ent water temperatur e and a small red light will glow in the upper left-hand corner of the display indicating the heating elements ar e ener gized.
10 Form No. HHM-1 103 OPERA TION NOTE: If steps 6-9 ar e interrupted or no changes ar e made for 15 seconds the contr oller will go back to its original setting without accepting the change. NOTE: If unit displays “E1” or “E2” the internal water sensing pr obe is out of temperatur e range.
OPERA TION 11 Form No. HHM-1 103 W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: W ater T emp. At Start-Up T emperature °F (°C) W ater Heated T o: MINUTES TO HEA T T ABLE * * Results may vary depending upon wattage/square foot. As wattage per foot increase, the speed of heating will increase.
12 Form No. HHM-1 103 MAINTENANCE GENERAL W ARNING T o avoid any electrical shock hazard, or physical burns turn the power OFF at the fuse disconnect switch/circuit br eaker or unplug the unit from the power sour ce and allow to cool completely before performing any maintenance or cleaning.
13 Form No. HHM-1 103 MAINTENANCE OPTIONAL POWER FLUSH CLEANING NOTE: Power Flush Kit sold separately . 1. Turn power switch to OFF position. 2. Connect one end of a drain hose onto the sump drain outlet and place the open end in a bucket or open site drain in a manner according to local plumbing codes.
Form No. HHM-1 103 14 MAINTENANCE DELIMING INSTRUCTIONS CAUTION Inspect daily for lime and sediment buildup inside unit. Excessive amounts can affect unit performance and reduce the operating life of the unit. NOTE: Pr oduct failur e caused by liming or sediment buildup is not cover ed under warranty .
Form No. HHM-1 103 15 MAINTENANCE W ARNING If service is requir ed on this unit, contact your Authorized Hatco Service Agent, or contact the Hatco Service Department at 800-558-0607 or 414-671-6350; fax 800-690-2966 or international fax 414-671-3976. W ARNING This product has no “user” serviceable parts.
Form No. HHM-1 103 16 HA TCO LIMITED W ARRANTY 1. PRODUCT W ARRANTY Hatco warrants the products that it manufactures (the “Products”) to be free from defects in materials and workmanship, under no.
Form No. HHM-1 103 17 NOTES.
HA TCO CORPORA TION P .O. Box 340500, Milwaukee, WI 53234-0500 U.S.A. (800) 558-0607 (414) 671-6350 Parts & Service Fax (800) 690-2966 Int’l. Fax (414) 671-3976 www .hatcocorp.com HA TCO AUTHORIZED P ARTS DISTRIBUTORS Printed in U.S.A. November 2003 ALABAMA Jones McLeod Appl.
An important point after buying a device Hatco Hatco 3CS2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Hatco Hatco 3CS2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Hatco Hatco 3CS2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Hatco Hatco 3CS2 you will learn all the available features of the product, as well as information on its operation. The information that you get Hatco Hatco 3CS2 will certainly help you make a decision on the purchase.
If you already are a holder of Hatco Hatco 3CS2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Hatco Hatco 3CS2.
However, one of the most important roles played by the user manual is to help in solving problems with Hatco Hatco 3CS2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Hatco Hatco 3CS2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center