Instruction/ maintenance manual of the product MH125FAV Enerco
Go to page of 20
70056 Rev . A 5/05 ENERCO GROUP , INC., 4560 W . 160TH ST ., CLEVELAND, OHIO 44135 • 216-916-3000 — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appli- ance.
SPECIFICA TIONS T ype of Gas: ............ For use with Propane Only Gas Supply Pressure to regulator ........... Max.: Bottle Pressure . to regulator ........... Mi n.: 5 psig (34.5 kPa) regulator out ......... 28" W .C. (6.97 kPa) Electrical Input: .
OPERA TING PRECAUTIONS This is a propane, direct-fired, forced air heater . It's intended use is primarily temporary heating of buildings under construction, alteration or repair .
Figure 2 MINIMUM CLEARANCE: From normal combustible material Clearance 55, 85, 125 Forced Air From floor ........................................ 0 f t From outlet ....................................... 6 ft From sides ...............................
ODOR F ADE W ARNING W ARNING Asphyxiation Hazard • Do not use this heater for heating human living quarters. • Do not use in unventilated areas. • The flow of combustion and ventilation air must not be obstructed. • Proper ventilation air must be provided to support the combustion air requirements of the heater being used.
OPERA TING INSTRUCTIONS PREP ARING FOR OPERA TION 1 . Check the heater for possible shipping damage. If any is found, immediately notify the factory . 2.
SIZE AND CAP ACITY OF PROP ANE CYLINDERS REQUIRED The charts below show the approximate size of the cylinder required for these heaters. To use the chart: 1 . Select the lowest air temperature expected (at the bottom of the chart). 2 . Move straight up to time of operation desired (left side of chart).
Color Length From T o Black 6" (152mm) I1 (Ignitor) T .B. Line Orange 1 1" (279mm) 1 (Ignitor S park Plug White 4 1/2" (1 14mm) I2(Ignitor) T .B. Return Y ellow 16" (406mm) High Limit T .B. Middle Y ellow 16" (406mm) High Limit T .
Forced Air Propane Construction Heater • Model #55F A V , 85FA V , 125F A V 9 Operating Instructions and Owner’s Manual Enerco Group, Inc.| Forced Air Propane Construction Heater REF.
W ARNING: USE ONL Y MANUF ACTURER’S REPLACEMENT P ARTS. USE OF ANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTS ARE ONLY AVAILABLE DIRECT FROM THE FACTORY AND MUST BE INSTALLED BY A QUALIFIED SERVICE AGENCY. MR. HEATER HOSES F273701 AND F273702 ARE SPECIFICALLY DESIGNED FOR USE WITH THIS HEATER.
ENERCO GROUP , INC., 4560 W . 160TH ST ., CLEVELAND, OHIO 44135 É.-U • (216) 916-3000 Mr. Heater est une marque de commerce déposée d'Enerco Group Inc. © 2003, Enerco/Mr . Heater . T ous droits réservés. ANSI Z83.7/CGA 2,14-2000 Enerco Group Inc.
Appareil de chauffage au prop ane à air pulsé pour chantier de construction - Modèle nº 55F A V 9 Guide d'utilisation et instructions de fonctionnement Enerco Group, Inc. | Appareil de chauffage à air pulsé au gaz propane pour chantier de construction RÉ F.
Nº de pièce Couleur Longueur De à 1040 Noir 152 mm (6 po) 1 (Allumeur) Conduite T .B. 1070 Orange 279 mm (1 1 po) 1 (Allumeur) Bougie d'allumage 1041 Blanc 1 14 mm (4 1/2 po) I2 (Allumeur) Retour T .B. 1044 Jaune 406 mm (16 po) Commande Central T .
T ABLEAU DE DIMENSIONS ET CONTENANCES DES BONBONNES DE GAZ PROP ANE REQUISES Les tableaux qui suivent indiquent la taille approximative de la bonbonne de gaz requise pour ces appareils de chauffage. Pour utiliser le tableau : 1 . Sélectionnez la température de l'air la plus basse prévue (au bas du tableau).
INSTRUCTIONS DE FONCTIONNEMENT A V ANT LE FONCTIONNEMENT 1. Vérifiez soigneusement tout dommage qu'aurait pu subir l'appareil de chauffage pendant l'expédition. Si vous en découvrez, avertissez immédiatement le fabricant. 2. Respectez toutes les « Précautions ».
A VERTISSEMENT LIÉ AUX SUBST ANCES ODORANTES A VERTISSEMENT Risque d'asphyxie • Cet appareil ne doit pas être utilisé pour le chauffage de locaux où demeurent des gens. • Ne l'utilisez pas dans des endroits non aérés. • Le débit de chaleur et d'air de ventilation ne doit pas être obstrué.
Figure 2 ÉCART MINIMUM : entre l'appareil et tout matériel combustible. Écart Air pulsé 55, 85, 125 Du plancher ...................................... 0 pi De la sortie ....................................... 6 p i Des côtés ...............
PRÉCAUTIONS LIÉES AU FONCTIONNEMENT Cet appareil de chauf fage à air pulsé et à feu direct fonctionne au gaz propane. Il est destiné princip alement à chauffer temporairement des édifices en construction, en rénovation ou en réparation. Le gaz propane est plus lourd que l'air .
SPÉCIFICA TIONS T ype de gaz : ........... Pour utilisation de gaz propane seulement Pression de l'alimentation en gaz au régulateur .......... Max. : Pression de la bonbonne à la sortie du régulateur : .................................... 28" W .
V ersion 05/04 L1 nº 70056 ENERCO GROUP , INC., 4560 W . 160TH ST ., CLEVELAND, OHIO 44135 É.-U. • (216) 916-3000 - N'entreposez ni n'utilisez d'essence ou autres liquides ou vapeurs inflammables à proximité de ce type d'appareil.
An important point after buying a device Enerco MH125FAV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Enerco MH125FAV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Enerco MH125FAV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Enerco MH125FAV you will learn all the available features of the product, as well as information on its operation. The information that you get Enerco MH125FAV will certainly help you make a decision on the purchase.
If you already are a holder of Enerco MH125FAV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Enerco MH125FAV.
However, one of the most important roles played by the user manual is to help in solving problems with Enerco MH125FAV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Enerco MH125FAV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
