Instruction/ maintenance manual of the product EE-25-2 Empire Products
Go to page of 16
Page 1 R-2688 WARNING: If the information in this manual is not followed exactly , a fir e or explosion may result causing pr op- erty damage, personal injury or loss of life. — Do not stor e or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
Page 2 R-2688 SECTION PAGE Important Safety Information ................................................................................................... .................. 3 Safety Information for Users of LP Gas ...................................
Page 3 R-2688 • Installation and repair should be done by a QUALIFIED SERVICE PERSON. The appliance should be inspected before use and at least annually by a professional service person. More frequent cleaning may be required due to excessive lint from carpeting, bedding materials, etc.
Page 4 R-2688 Some people cannot smell well. Some people cannot smell the odor of the chemical put into the gas. You must find out if you can smell the odorant in propane. Smoking can decrease your ability to smell. Being around an odor for a time can affect your sensitivity or ability to detect that odor.
Page 5 R-2688 Instructions to Installer 1. Installer must leave instruction manual with owner after installation. 2. Installer must have owner fill out and mail warranty card supplied with unvented room heater. 3. Installer should show owner how to start and operate un- vented room heater.
Page 6 R-2688 WA TER VAPOR: A BY -PRODUCT OF UNVENTED ROOM HEA TERS Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.3KW's) of gas input per hour.
Page 7 R-2688 GAS SUPPL Y The gas line can be routed either through the floor or wall. The gas line opening should be made at this time. Location of the opening will be determined by the position of floor joists and the valve and union used for servicing.
Page 8 R-2688 When facing the front of the appliance the following minimum clearances to combustible construction must be maintained. Left side 5 inches (127mm). Right side 5 inches (127mm). Do not install in alcove or closet. Rear wall 0 inches (0mm).
Page 9 R-2688 Refer to Figure 7 for measurements in order to locate (3) mount- ing holes on wall. Figure 7 is the front view of the heater. On Solid Wall 1.
Page 10 R-2688 LIGHTING INSTRUCTIONS 1. STOP! Read the safety information above. 2. Set the thermostat (gas control knob) to lowest setting. 3. Turn off all electric power to the appliance (if appli- cable). 4. Remove front panel. 5. Push in gas control knob slightly and turn clockwise to "OFF".
Page 11 R-2688 MAIN BURNER FLAME CHARACTERISTICS There will be a short blue inner flame with a much larger lighter blue secondary flame. The burner flame may have a small yellow tip when hot. Dust in the combustion air will produce an orange or red flame.
Page 12 R-2688 1. Spark electrode does not produce spark. a. Spark electrode broken - replace. b. Ignitor wire may not be attached to spark electrode - attach. c. Ignitor wire damaged - replace. d. Piezo ignitor defective - replace. 2. Spark electrode produces spark but pilot does not light.
Page 13 R-2688 PLEASE NOTE: When ordering parts, it is very important that part number and description of part coincide. 22 VF-150 Frame Assembly 23 R-1945 Ignitor Wire 24 732063 Electrode 25 R-1970 T.
Page 14 R-2688 PAR TS VIEW.
Page 15 R-2688 INSTALLING OPTIONAL BLOWER EEB-1. If heater is installed on wall, in order to install optional blower, the heater must be removed from wall.
Page 16 R-2688 .. . . . Wiring The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code ANSI/NFPA No. 70 , if an external electrical source is utilized.
An important point after buying a device Empire Products EE-25-2 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Empire Products EE-25-2 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Empire Products EE-25-2 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Empire Products EE-25-2 you will learn all the available features of the product, as well as information on its operation. The information that you get Empire Products EE-25-2 will certainly help you make a decision on the purchase.
If you already are a holder of Empire Products EE-25-2, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Empire Products EE-25-2.
However, one of the most important roles played by the user manual is to help in solving problems with Empire Products EE-25-2. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Empire Products EE-25-2 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
