Instruction/ maintenance manual of the product DR30GIS Dacor
Go to page of 24
Ins t all a tio n I nst r u c tio ns Dis tin c t iv e ™ 30 - Inch Gas R ange Part No. 105908 Rev . D THIS APPLIANCE HAS BEEN TESTED IN ACCORDANCE WITH THE LA TEST EDITION OF ANSI Z21.
T able of Contents Customer Ser vice Information IMPORT ANT : • Installer : In the interest of safety and to minimize problems, read these installation instructions completely and carefully before you begin the installation process. Leave these installation instructions with the customer .
1 Impor tant Information About Safety Instructions The Important Safety Instructions and warnings in this manual are not meant to cover all possible problems and conditions that can occur . Use common sense and caution when installing, maintaining or operating this appliance.
2 Impor tant Safety Instructions General Safety Precautions T o reduce the risk of fire, explosion, electric shock, serious injury or death when installing or using this appliance, follow basic safety precautions, including the following: • Read the accompanying use and care manual completely before operating this appliance.
3 Impor tant Safety Instructions • Do not expose the knobs to direct flame, hot utensils or other sources of heat. • Always ensure that the light fixture lens cover is in place when using the oven. The lens cover protects the light bulb from breakage caused by high oven temperatures or mechanical shock.
4 Installation Specifications Product Dimensions 1 1/8” (2.9 cm) DR30GI[F]S: 1/4” (6.4 mm) thick top trim Front of open door Front of handle Front panel Rear of front panel Backguard thickness 26 1/8” (66.4 cm) 28 9/16” (72.5 cm) Front of knobs 28” (71.
5 Installation Specifications W ARNING • This appliance must be installed and electrically grounded in conformance to local codes. • In the absence of local codes, the appliance installation must conform with the National Fuel Gas Code, ANSI Z223.
6 Installation Specifications W ARNING • Failure to meet or exceed the maximum and minimum dimensions/clearances stated may result in a fire hazard. • T o eliminate the risk of burns or fire by reaching over heated surface units, cabinet storage space located above surface units should be avoided.
7 Cabinet Depth Greater Than 24” Partial Side Panels Installed, Range Back Overhanging Countertop (T op View) 2 Cabinet Depth Greater Than 25 1/8” Partial Side Panels Removed, Range Back Overhangi.
8 24” - 24 1/4” Cabinet Depth Partial Side Panels Installed (T op View) 2 24 1/4” - 27 1/2” Cabinet Depth Partial Side Panels Installed (T op View) Custom Cabinet 27 1/2” or Deeper , Partial.
9 Installing the Anti-T ip Bracket Locate the anti-tip bracket included in the parts box. There are two ways to mount the anti-tip bracket: • Floor mounting (preferred method) • W all mounting (alternate method). Use this method if floor mounting is not suitable.
10 Attaching the bracket to a concrete floor: • Drill four (4) 3/8” diameter countersink holes through any existing floor covering to the concrete slab below . • Drill the 4 holes for the anchors 1 1/4” (3.2 cm) deep into the concrete slab using a 3/16” masonry bit.
11 Installing the Anti-Tip Bracket on the W all 1. Determine the suitability of wall mounting the anti-tip bracket. T o use the wall mount option, the range front panel must not be more than 27 3/8” (69.5 cm) from the wall and the bracket screws must be able to thread into the base plate inside the wall behind.
12 Side Panel Removal (Model DR30GIS/DR30GIFS only) If the range will be installed with the partial side panels removed: 1. Remove the three screws just below the oven opening that hold the kick panel in place. 2. Pull the kick panel straight out to snap it off of the range.
13 Rear T rim Piece Installation (Model DR30GIS/DR30GIFS only) For self-rimming installations, with or without a raised vent, install the included 1 inch deep rear trim piece to overhang the countertop/raised vent in back. Use the two (2) included #8 x 1/4 screws.
14 Installation Instructions Moving the Range to Final Location 1. Peel the protective plastic coating off of the range, including the range door . 2. Uncoil the power cord and route it to the electrical outlet so that it does not become trapped behind the range when it is pushed back.
15 Cooktop Assembly W ARNING Never attempt to operate the range’s cooktop with any of the burner rings, burner caps or grates removed. 1. Remove the burner rings, burner caps and grates from their shipping cartons. 2. Install the burners as shown. Gently twist each piece back and forth after installation to make sure it is properly seated.
16 Installation Instructions V erifying Proper Operation W ARNING Before operating the range, read the accompanying use and care manual completely . 1. Before beginning the test procedure, make sure all range control valves are in the “OFF” position, and all burner rings, burner caps and grates are properly positioned on the spill tray .
17 Installation Instructions Installation Checklist W ARNING T o ensure a safe and proper installation, the installer must perform the following checklist to ensure that no part of the installation has been overlooked. Proper installation is the responsibility of the homeowner .
18 Notes.
19 Notes.
20 Notes.
.
Dacor ● 14425 Clark Avenue, City of Industry , CA 91745 ● Phone: (800) 793-0093 ● Fax: (626) 403-3130 ● www .dacor.com.
An important point after buying a device Dacor DR30GIS (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dacor DR30GIS yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dacor DR30GIS - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dacor DR30GIS you will learn all the available features of the product, as well as information on its operation. The information that you get Dacor DR30GIS will certainly help you make a decision on the purchase.
If you already are a holder of Dacor DR30GIS, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dacor DR30GIS.
However, one of the most important roles played by the user manual is to help in solving problems with Dacor DR30GIS. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dacor DR30GIS along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
