Instruction/ maintenance manual of the product DCT365 Dacor
Go to page of 16
Installa tion I nstru ctions Distinc tive S erie s Coo k to p Models DCT305, DCT365 Part No. 106927 Rev . E.
Installation Instructions .................................................... 7 V erify Package Contents .................................................. 7 Installing the Cooktop ...................................................... 7 Connecting the Gas Line .
1 Impor tant Information About Safety Instructions • The Important Safety Instructions and warnings in these instructions are not meant to cover all possible problems and conditions that can occur . Use common sense and caution when installing, maintaining or oper- ating this or any other appliance.
2 Impor tant Safety Instructions • Read the accompanying use and care manual com- pletely before operating this appliance. • Keep packaging materials away from children. Plastic sheets and bags can cause suffocation. • If you receive a damaged product, immediately con- tact your dealer or builder .
3 Installation Specifications W ARNING Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. All tolerances ±1/16” (±1.6 mm) unless otherwise noted. 2” (5.1 cm) 1 3/4” (4.
4 Electrical Requirements W ARNING T o prevent an electric shock hazard, the power supply must meet the specifications stated below . It is the own- er ’s responsibility to make sure that the electrical service meets electrical requirements and that the electrical outlet has been properly installed by a licensed electrician.
5 Cabinet and Counter top Layout W ARNING • Failure to meet or exceed the maximum and minimum dimensions/clearances stated in these instructions may result in a fire hazard. • Follow the countertop manufacturer ’s instructions regarding the minimum corner radius, use of heat reflective tape, reinforcement of corners, etc.
6 Stiffener Cabinet face Countertop Floor 3/8” min. (1.0 cm) space behind raised vent chassis to clear stiffener 3/8” min. (1.0 cm) flat countertop overhang required behind cutout ERV3615 raised vent.
7 V erify Package Contents • Hold down brackets (2) • Grates (3) • Burner sets (5) • Gas pressure regulator with 3/4” to 1/2” reducer • Stainless steel cleaner Installing the Cooktop W ARNING • V erify that the power supply meets the specifications on page 4 before proceeding.
8 Installation Instructions SimmerSear ™ Burner Assembly (center of cooktop) Standard Burner Assembly Left Rear Standard Burner Assembly - DCT305 Igniter Igniter Burner cap (bottom shown) Burner cap.
9 Installation Instructions IMPORT ANT : Install the grates as instructed below for longest life. When installed properly , the openings in the grates are centered over the burners. 3. Locate the notch on the bottom of each grate. 4. Use the notch on the bottom of each grate to determine location and orientation.
10 Installation Instructions HIGH position HIGH position LOW position LOW position V erifying Proper Operation W ARNING • Make sure that power to the electrical outlet is turned off at the circuit breaker panel or fuse box and that the gas is turned off at the gas supply valve before pro- ceeding.
11 Installation Instructions Installation Checklist W ARNING • T o ensure a safe and proper installation, the follow- ing checklist should be completed by the installer to ensure that no part of the installation has been over- looked. • Proper installation is the responsibility of the home- owner .
12 W iring Diagram Wiring Diagram - DCT305/DCT365 V erify proper operation after servicing 120 V ac, 60 Hz. power supply W ARNING Label all wires prior to dis-connection when servicing controls. Wiring errors can cause improper and dangerous operation.
.
Dacor●600 AntonBlvd.Suite1000CostaMesa,CA 92626●Phone:(800)793-0093●Fax:(626)403-3130●www .
An important point after buying a device Dacor DCT365 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dacor DCT365 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dacor DCT365 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dacor DCT365 you will learn all the available features of the product, as well as information on its operation. The information that you get Dacor DCT365 will certainly help you make a decision on the purchase.
If you already are a holder of Dacor DCT365, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dacor DCT365.
However, one of the most important roles played by the user manual is to help in solving problems with Dacor DCT365. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dacor DCT365 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
