Instruction/ maintenance manual of the product Grosvenor Charnwood
Go to page of 9
Operating and Installation Instructions CHARNWOOD GROSVENOR Bishops Way, Newport, Isle Of Wight, PO3O 5WS, U.K. Tel: (01983) 537799 Fax: (01983) 5377887.
Important Information It is most important that both you, the customer and the installation engineer not only follow the in structions in this booklet, but that you are satisfied that the following conditions have been complied with.
Please go through this section with the installation engineer so that you fully understand all the basic operating and maintenance procedures for your stove. The engineer will be happy to answer your questions and give you any help you may need. General Notes This stove is not for use with any solid fuels.
Should the stove burner cut out for any reason you should not try to re-light it for at least 5 minutes. If you are then unable to re-light the pilot as described earlier you should contact your stove supplier or engineer.
the top of the burner unit. Ideally a vacuum cleaner should be used, but if not a soft brush will do. 2. Check the condition of the coals. Any damaged ones will affect the efficient operation of the stove and should be replaced with new ones available from your stove supplier.
Notes to the Installation Engineer: Please make sure the customer is familiar with the initial lighting and operating procedures before leaving the site and that this instruction booklet is left with them when the final commissioning is complete. Please check that the following components are included before you start on the assembly.
the stove and that the chimney is in good condition. If not, a chimney liner must be installed or a suitable class 2 gas flue used. An up-draught is necessary to ensure the products of combustion are fully evacuated. The stove must be installed in accordance with current gas and building regulations applicable.
Fig. 4. Coal Layer 2 Natural Gas 1st Layer below shown dotted 11 12 13 14 15 16 17 18 19 20 21 L L L L L L L L L L L ø8.0 Holes Air Tunnel Air Tunnel 1 2 3 4 5 6 7 8 9 10 Fig.
Fig. 6. Coal Layers 2 & 3 LPG 16 17 18 19 20 21 22 23 24 25 26 1st Layer below, shown dotted 3rd Layer L L L L L L L L S S S ø8.0 Holes 1 2 3 4 5 10 6 13 15 7 8 9 11 12 14 Fig.
An important point after buying a device Charnwood Grosvenor (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Charnwood Grosvenor yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Charnwood Grosvenor - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Charnwood Grosvenor you will learn all the available features of the product, as well as information on its operation. The information that you get Charnwood Grosvenor will certainly help you make a decision on the purchase.
If you already are a holder of Charnwood Grosvenor, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Charnwood Grosvenor.
However, one of the most important roles played by the user manual is to help in solving problems with Charnwood Grosvenor. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Charnwood Grosvenor along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
