Instruction/ maintenance manual of the product SPC-530 Advantech
Go to page of 17
SPC-530 Rackmount Server PC User's Manual.
Copyright Notice This document is copyrighted, April 2000, by Advantech Co., Ltd. All rights are reserved. Advantech Co., Ltd. reserves the right to make improvements to the products described in this manual at any time without notice.
Contents Chapter 1 General Information ................................................................... 1 1.1 Introduction ................................................................................................................. 1 1.2 Model list .
SPC-530 User's Manual 1 Chapter 1 General Information 1.1 Introduction The SPC-530MB / SPC-530BP , the PC/A T-compatible computer , is designed for high-reliability applica- tions. Not only easily installed and maintained in mission critical applications and harsh environments, it is also a high-end rackmount fault-resilient server PC.
2 SPC-530 User's Manual • Paint color: Front panel: Pantone Black 4C 2X; Chassis: Brushed finish, Ni • Operating temperature : 0 to 50 o C (32 to 122 o F) • Relative humidity : 20 to 90% • CE compliant Hot-swap AC-DC 400-watt A TX redundant power supply (RPS-400A TX) • Output rating : 400 watts (max.
SPC-530 User's Manual 3 Fault detection and alarm notification • Power failure: This operates only when you have installed the redundant power supply (RPS-400A TX). If either of the two power modules fails, the dedicated LED (PWR) changes color from green to red, and an audio alarm also sounds.
4 SPC-530 User's Manual 1.4 Dimensions Unit = mm SPC-530BP (Can be fitt ed with a 20-slot backplane) SPC-530MB (Can be fitt ed with a 12" x 13" motherboard).
SPC-530 User's Manual 5 2.1 Removing the cover Chapter 2 System Setup The SPC-530 series is an A TX-compatible computer designed for industrial applications. This rugged chassis meets the EIA RS-310C 19" rackmount standard. Setting up your SPC-530 series requires only a screwdriver and a small amount of time.
6 SPC-530 User's Manual 2.2 Removing the handles The handles and mounting ears for the front panel can be removed as follows. Please see Figure 2.2 below: 2.3 The cooling fans There are three cooling fans inside the chassis. T o replace or service the fans, open the top cover as in Figure 2.
SPC-530 User's Manual 7 2.4 Removing the disk drive bay 2.4 Installing the disk drives 1. Open the top cover as in Figure 2.1. There is one independent disk drive bay on the front of the chassis. Remove the four outer screws which mount the drive bay to the chassis.
8 SPC-530 User's Manual 2.6 Installing the power supply unit There is one 400 W A TX redundant power supply installed at the front of the chassis.
SPC-530 User's Manual 9 PCA-6120P4 Rev . A1: 15 ISA / 4 PCI / 1 PICMG-slot passive backplane Dimensions: 420 x 260 mm Appendix A Backplanes (Optional) T ermination resistor signals The termination resistors provide an impedance mismatch at the end of the bus, to prevent signal reflections.
10 SPC-530 User's Manual PCA-61 19P7 Rev . A1: 15 ISA / 4 PCI / 1 PICMG-slot passive backplane Dimensions: 420 x 260 mm.
SPC-530 User's Manual 11 PCA-61 19P17 Rev . A1: 1 ISA / 17 PCI / 1 PICMG-slot passive backplane Dimensions: 420 x 260 mm.
12 SPC-530 User's Manual SPC-530MB Appendix B Exploded Diagrams.
SPC-530 User's Manual 13 SPC-530BP.
14 SPC-530 User's Manual Appendix C Safety Instructions 1. Please read these safety instructions carefully . 2. Please keep this User's Manual for later reference. 3. Please disconnect this equipment from any AC outlet before cleaning. Do not use liquid or sprayed detergent for cleaning.
An important point after buying a device Advantech SPC-530 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Advantech SPC-530 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Advantech SPC-530 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Advantech SPC-530 you will learn all the available features of the product, as well as information on its operation. The information that you get Advantech SPC-530 will certainly help you make a decision on the purchase.
If you already are a holder of Advantech SPC-530, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Advantech SPC-530.
However, one of the most important roles played by the user manual is to help in solving problems with Advantech SPC-530. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Advantech SPC-530 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
