Instruction/ maintenance manual of the product PW3520 Campbell Hausfeld
Go to page of 14
BUILT TO LAST Gasoline Power ed Horizontal Pr essur e W ashers Product Manual PW2220, PW3005, PW3221, PW3228, PW3520 Carefully read and understand these instructions before operating your pressure washer . © 2003 Campbell Hausfeld/Scott Fetzer IN462600A V 8/03 Frequently Asked Questions .
Pressur e W ashers www .chpower .com Fr equently Asked Questions How do I start my pr essure washer? 1. Make sure you have gas and oil in the engine. 2. T urn the water on, then trigger the gun to make sure the water will flow smoothly out of the nozzle or tip.
ble support. Keep good footing and balance at all times. 10. Follow the maintenance instructions specified in the manual. Risk of injection or severe injury . Keep clear of nozzle. Do not discharge streams at persons. This pr oduct is to be used only by trained operators.
Pressur e W ashers www .chpower .com 4 Pr e-Operation UNP ACKING Remove the equipment and all parts from the carton. The carton should contain the following. • One pressure washer (pump, engine, cart base). • One cart handle assembly . • One spray gun.
TRIGGER SAFETY LA TCH In the engaged position, the trigger safe- ty latch prevents the gun from being trig- gered accidentally . Push the latch fully down to engage it (See Figure 9). Always engage the trigger safety latch when the unit is not in use.
Pressur e W ashers www .chpower .com equipped, turn on the on/off switch to the “on” position. 7. Start the engine. If the engine is cold, completely close the engine choke. If the engine is warm, leave the choke open or just partially closed. Unlock the trigger safety latch on the gun.
If there is not a plastic adjustment knob located on the pump (See Figure 10), then the pressure cannot be adjusted. The only way to adjust the pressure is to move closer or further away from the cleaning surface and adjust the spray fan angle as shown in the next section.
Pressur e W ashers 1. Before triggering the gun, adjust the nozzle or quick connect tip to a wide fan pattern. 2. Place the nozzle approximately 4-5 feet away from the cleaning surface. Then hold the nozzle at a 45 degree angle to the cleaning surface.
9 Operation (Continued) sliding down and streaking. Wait a couple of minutes for the detergent to break down the dirt and grime. Use a brush to lightly scrub heavily soiled areas.
Pressur e W ashers 10 Maintenance Observe regular maintenance intervals to ensure maximum performance and life from the pressure washer . Refer to the schedule for recommended mainte- nance. If you operate the pressure washer in dusty conditions, perform maintenance checks more often.
Engine Oil T ype SAE 10W-30 SAE 30W (Above 60 O F) Engine Oil Capacity Briggs and Stratton V anguard Series 7-8 HP 30 fl. oz. V anguard Series 11-13 HP 5 1 fl. oz. Intek Series 8-10 HP 28 fl. oz. Honda Engines GX Series 4-6.5 HP 20 fl. oz. GX Series 8-13 HP 37 fl.
Pressur e W ashers www .chpower .com Tr oubleshooting Chart - Gasoline Power ed Pressur e W ashers Only Symptom Possible Cause(s) Corrective Action(s) Engine will not start or is hard to start Engine .
13 www .chpower .com Service Recor d Date Maintenance performed Replacement components requir ed Notes Pressure washer will not spray detergent 1. Nozzle not pushed up far enough 2. Clog, kink, or hole in detergent suction hose 3. Hose length too long 4.
Pressur e W ashers 14 www .chpower .com Limited W arranty 1. DURA TION: From the date of purchase by the original purchaser as follows: Standard Duty - One Y ear , Serious Duty - T wo Y ears, Extreme Duty - Three Y ears, Maxus Brand Serious Duty - Three Y ears, Maxus Brand Extreme Duty - Five Y ears.
An important point after buying a device Campbell Hausfeld PW3520 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Campbell Hausfeld PW3520 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Campbell Hausfeld PW3520 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Campbell Hausfeld PW3520 you will learn all the available features of the product, as well as information on its operation. The information that you get Campbell Hausfeld PW3520 will certainly help you make a decision on the purchase.
If you already are a holder of Campbell Hausfeld PW3520, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Campbell Hausfeld PW3520.
However, one of the most important roles played by the user manual is to help in solving problems with Campbell Hausfeld PW3520. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Campbell Hausfeld PW3520 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
