Instruction/ maintenance manual of the product IN198203AV Campbell Hausfeld
Go to page of 8
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
2 Operating Instructions 2. Use of a Ground Fault Interrupter (GFI) is strongly recommended. Ground Fault Interrupters can significantly reduce the possibility of injury if an electrical short occurs.
3 Operating Instructions LOAD DEVICES 1. All load devices and extension cords should use three prong terminals. Refer to the following chart for extension cord and cable size requirements. 2. Allow the engine to run for 2-3 minutes before applying any electrical loads.
4 Operating Instructions 2. In accordance with national and local standards, a double throw transfer switch must be installed in the system. Always shut off main power prior to temporary connection of the generator to a building electrical system.
5 Operating Instructions Alternator field is not energized Low output voltage with no load High output voltage with no load Low output voltage under load Erratic output voltage Noisy operation 1. Engine speed is too slow 2. Open, shorted, or incorrect wiring 3.
6 Operating Instructions Control Panel Models Only Y ellow White 120 V Duplex Receptacle NEMA 5-15R Tab broken on brass side 240 V Duplex Receptacle NEMA 6-20R Gn Gn Gn Green Gn Red Red Circuit Breake.
7 Operating Instructions Lamp Dim Lamp Bright TESTING GENERATOR DIODES The following method eliminates the need to disconnect the diodes from the generator wiring. 1. Use a 12 Volt battery and automotive lamp (Type 5001) to test the diodes in the generator.
Notes Operating Instructions 8.
An important point after buying a device Campbell Hausfeld IN198203AV (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Campbell Hausfeld IN198203AV yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Campbell Hausfeld IN198203AV - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Campbell Hausfeld IN198203AV you will learn all the available features of the product, as well as information on its operation. The information that you get Campbell Hausfeld IN198203AV will certainly help you make a decision on the purchase.
If you already are a holder of Campbell Hausfeld IN198203AV, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Campbell Hausfeld IN198203AV.
However, one of the most important roles played by the user manual is to help in solving problems with Campbell Hausfeld IN198203AV. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Campbell Hausfeld IN198203AV along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
