Instruction/ maintenance manual of the product Audio Cable KP10 Cambridge Audio
Go to page of 20
KP10 A -BUS k e ypad Installation Guide.
2 Incognito KP1 0 CONTENTS Introduction.......................................................3 System options.................................................4 Installation not es..............................................8 Rear panel connections.
Incognito A-BUS ke ypad 3 Thank you for purchasing this Cambridge Audio Incognito product. Incognito is a cost-effective, modular based system using standard Cat-5 or Cat-6 cable to distribute hi-fi quality sound and video around a home.
The KP1 0 k eypad can be used in two main configurations: 1. As par t of a full Incognito syst em, where it is plugged into an Incognito hub (AH1 0), perhaps with other Incognit o accessories such as a video switching unit (VH1 0) or local input module (LM1 0) fitted.
Incognito A-BUS ke ypad 5 Speaker cable PS10 Speaker cable SS10 SS10 AH10 Cat-5/5e cable KP10-EU KP10-EU KP 1 0 A -BUS k eypad.
A-BUS Ready / Incognito Ready For use with an A-BUS Ready/Incognit o R eady unit (see diagram opposite) the Mode switch MUS T be in the "Standard A-BUS/Incognito Ready" position as sho wn below: In this configuration the ke ypad is wired directly to the am plifier/receiver .
Incognito A-BUS ke ypad 7 Impedance 4 - 8 ohms Loudspeaker Terminals Important Please ensure that loudspeaker terminals are fully tightened Veuillez s'assurer que les bornes de l'enceinte so.
8 Incognito KP1 0 The KP1 0 is fitted on the w all by fixing it into a standar d UK 4 7mm depth single-gang electrician’s back-bo x (pattress). All knock-outs in the back -box should be remo ved t o pro vide maximum ventilation.
Incognito A-BUS ke ypad 9 Safety precautions Care should be tak en when choosing the site f or a KP1 0, the k eypad must ne ver be installed in a back-bo x which also contains mains wiring or in areas of high humidity . The KP1 0 runs on 2 4 V DC supplied through the connecting cable.
Cat5 to KP10 punch down connectors A Cat-5 cable (terminat ed with an RJ45 jack plug) is used to connect the KP1 0 to an AH1 0 hub or A-BUS Ready receiv er . The KP1 0 has punch down connect ors for the eight individual conductors of the Cat-5 cable (use a small flat-bladed screwdriv er).
Incognito A-BUS ke ypad 11 Line-in/Line-out connections on subwoofer Screened audio cable Preamp output connections on rear of KP10 Gain adjust The maximum output of the KP1 0 can be limited b y turning these down. Alt ernatively , if the sound lev el is too q uiet, the Gain can be turned up.
12 Incognito KP1 0 The six LEDs indicate the function status of the KP1 0. List ed below are each of the functions of the corresponding LEDs: Minimum volume / Source select Volume / Source select / Ba.
Incognito A-BUS ke ypad 13 Standby/On Press to switch the k eypad between On and Standb y mode. By pressing and holding the Standby butt on f or about 2 seconds, all KP1 0s connected t o the AH1 0 hub will be turned of f.
14 Incognit o KP10 OPERA TING INSTRUCTIONS Important! As mentioned previously , the KP1 0 can be switched between two modes of operation; a standard A-BUS mode f or compatibility with other manufacturers A-BUS Ready eq uipment (Standard A-BUS/Incognito R eady mode), and an Incognito A-BUS hub mode (AH1 0 mode).
Af ter holding bo th buttons down f or a shor t period, the second LED on the k eypad will light indicating that Bass adjust mode has been activat ed. In this mode pressing the V olume up/down k e ys will adjust the Bass (low frequencies) le vel.
16 Incognito KP1 0 Note: This f eature is only av ailable if the KP1 0 is par t of a full Incognito multi-r oom system with one or two Local In put Modules (LM1 0) fitted. The local source selection mode will need t o be activat ed to configure the KP1 0 correctly .
Incognito A-BUS ke ypad 17 Continuing to hold V olume up and Po wer buttons will light LED 5, t o indicat e that Off mode is a vailable f or selection, and no source will be select ed. T o select these modes, wait till the corresponding LED is lit and then release Po wer and V olume up buttons.
18 Incognit o KP10 Input impedance 45 k ohms Frequency response 20Hz – 20kHz +/- 1dB THD <0.2% @ 1W , 20Hz – 20 kHz S/N ratio > 80 dB ‘A ’ weighted Volume control range - 80 dB, 36 st ep.
Incognito A-BUS ke ypad 19 Cambridge Audio w arrants this product t o be free from def ects in materials and workmanship (subject t o the terms set f or th below). Cambridge A udio will repair or replace (at Cambridge Audio’s option) this pr oduct or any def ective parts in this product.
Incognito KP10- EU www.cambridge-audio.com Par t No. AP18303/2.
An important point after buying a device Cambridge Audio Audio Cable KP10 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Cambridge Audio Audio Cable KP10 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Cambridge Audio Audio Cable KP10 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Cambridge Audio Audio Cable KP10 you will learn all the available features of the product, as well as information on its operation. The information that you get Cambridge Audio Audio Cable KP10 will certainly help you make a decision on the purchase.
If you already are a holder of Cambridge Audio Audio Cable KP10, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Cambridge Audio Audio Cable KP10.
However, one of the most important roles played by the user manual is to help in solving problems with Cambridge Audio Audio Cable KP10. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Cambridge Audio Audio Cable KP10 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
