Instruction/ maintenance manual of the product XD5125 Dual
Go to page of 12
INSTALLATION/OWNER'S MANUAL AM/FM/CD Receiver XD5 1 25.
XD5125 INSTALLATION Preparation Please read entire manual before installation. Before You Start • Disconnect negative battery terminal. Consult a qualified technician for instructions.
XD5125 INSTALLATION Installation 3 TYPICAL MOUNTING METHOD.
5 AMP XD5125 INSTALLATION Wiring Diagram 4 FUSES When replacing fuses, make sure new fuse is the correct type and amperage. Using an incorrect fuse could damage the radio. The XD5125 uses one 5 amp AGC fuse (Battery) and one 0.5 amp AGC fuse (Ignition) located in-line.
XD5125 OPERATION Control Locations 5 Release Tuning Volume Up Mode Mute Audio Eject Auxiliary Input Band EQ Display Track Up Track Down Mono/Stereo/CD Intro Local/Distance/CD Repeat Loudness/CD .
XD5125 OPERATION 6 General Operation Press RELEASE and pull away from the left side to remove. To re-install, insert right side of faceplate first then push left side to secure. Pres s POWE R to turn the unit on. Inse rtin g a CD will turn the unit on autom atic ally .
XD5125 OPERATION General Operation 7 Press and hold DISP until the clock begins to flash, then release. Press TRA CK to adjust the hours and TRACK to adjust the minutes. Press DISP momentarily to save the selected time.
XD5125 OPERATION Tuner Operation 8 Turn the rotary encoder to tune the unit up or down and select the desired station. Press MONO during FM tuner operation to select mono or stereo (default) reception of the broadcast signal. Press LOC during FM tuner operation to activate local tuning for strong station reception only.
XD5125 OPERATION CD Player Operation 9 With the label facing up, insert a disc into the CD slot. The CD will automatically begin playback. Press the EJECT button to stop and eject CD. The unit will change to tuner mode. If the disc is not removed within 10 seconds, the unit will reload the disc.
XD5125 WARRANTY Limited One Year Warranty 10 This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
XD5125 OPERATION Specifications 11 Frequency response: 20Hz-20kHz Channel separation @ 1kHz: >50dB D/A converter: 1 Bit Tuning range: 87.5MHz-107.
XD5125 OPERATION Troubleshooting Problem Cause Action Unit will not turn on (no power) Yellow or red wire not connected or incorrect voltage Check connections for proper voltage (11~16V.
An important point after buying a device Dual XD5125 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Dual XD5125 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Dual XD5125 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Dual XD5125 you will learn all the available features of the product, as well as information on its operation. The information that you get Dual XD5125 will certainly help you make a decision on the purchase.
If you already are a holder of Dual XD5125, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Dual XD5125.
However, one of the most important roles played by the user manual is to help in solving problems with Dual XD5125. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Dual XD5125 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
