Instruction/ maintenance manual of the product 30231 Briggs & Stratton
Go to page of 16
030231 Operator’ s Manual Questions? Help is just a moment a wa y! Find your Briggs and Stratton distributor at www .briggsandstratton.com or contact your local Briggs and Stratton dealer . BRIGGS & STRA TT ON PO WER PRODUCTS GR OUP , LLC JEFFERSON, WISCONSIN, U .
SAFETY R ULES 2 T ABLE OF CONTENTS Safety Rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2-4 Featur es and Contr ols . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Assembly . . . . . . . . . . . . . . . . . . . . . . .
SAFETY R ULES 3 • This generator must not be used on marine applications. • Using this generator in marine applications could r esult in bodily injury and/or property damage . W ARNING • When using generator for backup pow er , notify utility company .
SAFETY R ULES 4 WHEN ADJUSTING OR MAKING REP AIRS T O Y OUR GENERA T OR • Disconnect the spark plug wire fr om the spark plug and place the wire wher e it cannot contact spark plug. WHEN TESTING FOR ENGINE SP ARK • Use appr oved spark plug tester .
FEA TURES AND CONTROLS 5 KNO W Y OUR GENERA T OR Read this Operator’ s Manual and safety rules before operating y our g enerator . Compare the illustrations with y our generator , to familiarize yourself with the locations of various controls and adjustments.
ASSEMBL Y 6 ASSEMBL Y Y our generator requir es some assembly and is r eady for use after it has been properl y ser viced with the recommended oil and petr ol. Remo ve Generator F r om Car ton 1. Set the carton on a rigid flat surface . 2. Open carton completely by cutting each corner from top to bottom.
OPERA TION 7 USING THE GENERA T OR System Gr ound The generator has a system ground that connects the generator frame components to the ground terminals on the A C output receptacles. The system gr ound is connected to the A C neutral wire (see “Equipment Description”, earlier in this manual).
OPERA TION 8 OPERA TING THE GENERA T OR Star ting the Engine Disconnect all electrical loads from the generator . Use the following start instruction steps in numerical order: 1. Mak e sure unit is on a le vel surface. IMPOR T ANT : Failure to start and operate unit on a lev el surface will cause the unit not to start or shut down during operation.
OPERA TION 9 4. Check oil lev el daily or after ev ery eight (8) hours of operation. 5. Maintain generator following “Maintenance Schedule” in engine operator’ s manual. 6. Shelter unit from elements. Cr eating a T emporar y Shelter 1. In an emergency , use the original shipping car ton.
OPERA TION 10 RECEPT A CLES A double pole rock er switch circuit br eak er is pro vided to protect all the r eceptacles and generator against electrical ov erload. 110/220 V olt A C , 20 Amp Locking Receptacle Use a NEMA L14-20 plug with this receptacle.
OPERA TION 11 Gr ound F ault Pr otection The duplex receptacles ar e equipped with Gr ound Fault Circuit Inter rupter (GFCI) protection. This de vice meets applicable federal, state and local codes. The generator’ s locking receptacle is not pr otected by a GFCI.
OPERA TION 12 DON'T O VERLO AD GENERA T OR Capacity Y ou must mak e sure y our generator can supply enough rated (running) and surge (starting) watts for the items you will po wer at the same time. Follow these simple steps: 1. Select the items you will po wer at the same time.
SPECIFICA TIONS AND MAINTENANCE 13 SPECIFICA TIONS Starting W attage . . . . . . . . . . . . . . . . . . . . . . 5,400 W atts W attage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3,600 W atts Rated A C Load Curr ent At 110 V olts . . . .
ST ORA GE 14 ST ORA GE The generator should be started at least once every sev en da ys and allow ed to run at least 30 minutes. If this cannot be done and you m ust store the unit for mor e than 30 da ys, use the following guidelines to prepar e it for storage.
TROUBLESHOO TING 15 TR OUBLESHOO TING Pr oblem Cause Solution Engine is running, but no AC output is a vailable. 1. Circuit br eak er is open. 2. P oor connection or defective cord set. 3. Connected device is bad. 4. Fault in generator . 1. Reset circuit br eak er .
BRIGGS & STRA TTON POWER PRODUCTS GROUP , LLC PORT ABLE GENERA TOR OWNER W ARRANTY POLICY LIMITED W ARRANTY Briggs & S tratton Power Products Group, LLC will rep air or replace, free of charge, any part(s) of the portable generator that is defective in material or workmanship or both.
An important point after buying a device Briggs & Stratton 30231 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Briggs & Stratton 30231 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Briggs & Stratton 30231 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Briggs & Stratton 30231 you will learn all the available features of the product, as well as information on its operation. The information that you get Briggs & Stratton 30231 will certainly help you make a decision on the purchase.
If you already are a holder of Briggs & Stratton 30231, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Briggs & Stratton 30231.
However, one of the most important roles played by the user manual is to help in solving problems with Briggs & Stratton 30231. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Briggs & Stratton 30231 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
