Instruction/ maintenance manual of the product gl280 Black & Decker
Go to page of 16
GL280 GL301 GL315 GL337 GL350.
2 English (Original instructions) 6.
3 C E B A D F.
4 G H I J K L.
5 M N O.
6 Intended use Y our Black & Decker trimmer has been designed for trimming and nishing lawn edges and to cut grass in conned spaces. This appliance is intended for consumer use only .
7 u Before use, check the power supply cord and extension cord for signs of damage, ageing and wear . If a cord becomes damaged during use, disconnect the cord from the mains supply immediately . DO NOT TOUCH THE CORD BEFORE DISCONNECTING THE SUPPL Y .
8 u Secure the guard with the screw . W arni ng! Neve r us e th e to ol u nles s th e gu ard is p rope rly tte d. Releasing the cutting line In transit, the cutting line is taped to the spool housing. u Remove the tape holding the cutting line (1 1) to the spool housing (12).
9 u Remove the empty spool (23) from the spool cover . u Remove any dirt and grass from the spool cover and housing. u T ake the new spool and push it onto the boss in the spool cover . Rotate the spool slightly until it is seated. u Unclip the end of one of the cutting lines and feed the line into one of the eyelets (24).
10 u Remove the spool and unwind the cutting line, then wind it on neatly again as described above. Replace the spool as instructed. Maintenance Y our Black & Decker corded/cordless appliance/tool has been designed to operate over a long period of time with a minimum of maintenance.
1 1 EC declaration of conformity MACHINERY DIRECTIVE OUTDOOR NOISE DIRECTIVE % GL280/GL301/GL315/GL337/GL350 Black & Decker declares that these products described under "technical data" are in compliance with: 2006/42/EC, EN 60335-1, EN 60335-2-91 2000/14/EC, Lawn T rimmer, L ≤ 50 cm, Annex VIII KEMA Quality B.
12.
13.
14.
ENGLISH Do not forget to register your product! www.blackanddecker .co.uk/productregistration Register your product online at www.blackanddecker .co.uk/productregistration or send your name, surname and product code to Black & Decker in your country .
90553705 REV -0 03/2010 Australia Black & Decker (Australia) Pty . Ltd. T el. 03-8720 5100 20 Fletcher Road, Mooroolbark, Fax 03-9727 5940 Victoria, 3138 New Zealand Black & Decker T el. +64 9 259 1 133 5 T e Apunga Place Fax +64 9 259 1 122 Mt Wellington Auckland 1060 United Kingdom Black & Decker T el.
An important point after buying a device Black & Decker gl280 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Black & Decker gl280 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Black & Decker gl280 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Black & Decker gl280 you will learn all the available features of the product, as well as information on its operation. The information that you get Black & Decker gl280 will certainly help you make a decision on the purchase.
If you already are a holder of Black & Decker gl280, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Black & Decker gl280.
However, one of the most important roles played by the user manual is to help in solving problems with Black & Decker gl280. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Black & Decker gl280 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
