
GENERAL SAFETY ADVICE READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE FIRST USE OF THE APPLIANCE. Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents. Remove the packing and make sure that the appliance is intact, with special attention to the supply cable. The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in the dome stic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality. Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label. If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption. Never pull the supply cord to unplug the appliance. Make sure that the supply cord never comes into contact with hot or cutting surfaces Do not use this appliance if the supply cord is damaged. In case of damage, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Only connect this appliance on alternating current Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded. This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use. To avoid any heating risk, it is recommended to unroll completely the supply cord and to unplug the appliance, when not used.

Before cleaning, always unplug the appliance. To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids. Do not hold the appliance with wet hands or feet. Do not hold the appliance with naked feet. Do not expose the appliance to atmospheric agents such as rain, wind, snow, hail. Do not use the appliance near explosives, highly flammable mate rials, gases, burning flames, heaters. Do not allow children, disabled people or every people without expe rience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children. Make sure that children do not play with this appliance. If you decide not to use the appliance any longer, make it unservice able by simply cutting the supply cable after disconnecting the plug from the socket. ALSO MAKE ANY DANGEROUS PARTS UNSERVICE ABLE, ESPECIALLY FOR CHILDREN WHO COULD PLAY WITH THE APPLIANCE.
A. Pitcher lid B. Pitcher C. Boiler D. Disc filter E. Gasket F. Support base G. Power cable H. On/off switch I. Pilot light J. Safety valve K. Funnel filter L. 1 cup filter adaptor M. Tube
ASSEMBLING Fig.2 1. Place the appliance on a stable surface far away from water taps and sinks and heat sources. 2. Check that the voltage of the mains power supply corresponds to the value indicated on the appliance’s rating plate. Only connect the appliance to a power outlet that is properly earthed. The manufacturer declines all liability for any accidents caused if the system is not correctly earthed.

HOW TO PREPARE THE COFFEE 1. Check that the coffee maker is cold, and then unscrew it by holding the boiler (C) with one hand and turning the handle of the pitcher (B) anticlockwise with the other (Fig.1). 2. Remove the funnel filter (K). 3. To prepare 3 cups of coffee, fill the boiler (C) with fresh water until reaching the safety valve (J) that is visible also inside the boiler (C),without exceeding it (Fig.2). To prepare 1 cup of coffee, fill the boiler with water up to around 2 centimeters below the safety valve. TIP: Use fresh and soft water. Salty or hard water will weaken the flavor of coffee. IMPORTANT: do not use the coffee maker without water in the boiler or alternatively using hot water for faster operation. 4. Insert the funnel filter (K) in the boiler (C) ( Fig. 3). To prepare one cup of coffee, also insert the 1 cup filter adapter (L) in the funnel filter (K) ( Fig. 4). 5. Fill the funnel filter (K) with ground coffee, without pressing it (Fig. 5). Fill it a little at a time to overfilling. 6. Distribute the ground coffee uniformly and remove any excess coffee from the edge of the funnel filter. IMPORTANT: Use good quality, medium-ground coffee for MOKA coffee makers. Do not use barley coffee with this coffee maker. 7. Tighten the coffee maker securely, without exaggerating, holding the boiler (C) with one hand and turning the pitcher clockwise with the other, without pushing on the handle. 8. Rest the coffee maker on the support base (F) ( Fig. 6) . Close the pitcher lid (A). 9. Press the on/off switch (Fig. 7) The coffee will start to be released from the tube (M) after a few minutes. 10. When coffee stops coming out, pour it into suitable cups and stir it well before serving. Coffee preparation process will take about 4 to 5 minutes. IMPORTANT: The first time that the coffee maker is used, all the accessories should be washed with hot water. Then make a few batches of coffee to throw away.
CLEANING AND MAINTENCE 1. Before performing the cleaning operations, wait for the coffee maker cool down after use. 2. Clean the inside of the tube (M) periodically. 3. Regularly check all the filters (D, K, L) and the gasket (E). Replace if there are signs of wear or deterioration. Use original spare parts only. 4. Every so often check to make sure that the holes in all the filters (D, K, L) are not blocked; if necessary, clean using a pin (Fig. 8). 5. Do not wash the coffee maker in the dishwasher. 6. When cleaning do not use solvents or abrasive detergents. Simply clean it with a sponge, keeping attention not to wet the electrical parts. 7. When there is the necessity to remove and/or replace the disc filter (D) and the gasket (E), it’s important to reinsert them properly in their respective place to avoid dangerous leakages of hot water.
Never rinse the boiler (C) under running water and never immerse it in water. Fig.3
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.

The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee ap plies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee.
The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance
For any technical assistance, please contact directly the seller or our head office in order to preserve the applian ce’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee.
GUARANTEE CONDITIONS If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that:
- The appliance has been used properly and for the purpose for which it has been intended. - The appliance has not been tampered with, otherwise it is not maintainable. - The purchase receipt shall be presented. - The appliance showing a fair wear and tear shall not be covered by this guarantee.
Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier.
For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge.
In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product
TECHNICAL ASSISTANCE Even after the guarantee period we will always pay attention to repairs for defected appliances. For technical assistance and/or repairs after the guarantee period you can directly contact the below address:
CONTACT YOUR DISTRIBUTOR IN YOUR COUNTRY OR ATER SALES DEPARTMENT BEPER. E-MAIL as sistenza@beper.com WHICH WILL FORWARD YOUR ENQUIRIES TO YOUR DISTRIBUTOR.
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.