
GENERAL SAFETY ADVICE READ THE OPERATING INSTRUCTIONS CAREFULLY BEFORE FIRST USE OF THE APPLIANCE. Read the following instructions carefully, since they give you useful safety information about installation, use and maintenance and help you avoid mishaps and possible accidents. Remove the packing and make sure that the appliance is intact, with special attention to the supply cable. The elements of the packing (plastic bags, polystyrene, etc) do not have to be accessible to the children, in order to preserve them from danger sources. It is recommended not to throw these packing material in the dome stic waste, but to deliver them to the appropriate station of collection or destruction refusals, asking eventually information to the manager of the Sanitation Department of your own municipality. Before connecting the appliance make sure that the mains voltage corresponds to the data specified on the label. If the plug does not suit the socket, let it be replaced with another suitable plug by qualified personnel only, which shall also ensure that the section of the socket cables is suitable for your appliance power absorption. Never pull the supply cord to unplug the appliance. Make sure that the supply cord never comes into contact with hot or cutting surfaces Do not use this appliance if the supply cord is damaged. In case of damage, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. Only connect this appliance on alternating current Generally, the use adaptors multiple plugs and/or extensions is not recommended; should they be necessary, please use only simple or multiple adaptors and extensions in compliance with the safety rules in force, making sure that the capacity absorption limit marked on the simple adaptors and the extensions and the maximum power limit marked on the multiple adaptor are not exceeded. This appliance is to be destined to its special purpose only. Any other use is to be considered as improper and thus dangerous. The manufacturer cannot be responsible for any damages deriving from improper, wrong or incautious use. To avoid any heating risk, it is recommended to unroll completely the supply cord and to unplug the appliance, when not used.

Before cleaning, always unplug the appliance. To protect against electric shock, do not immerse cord, plug or any parts of the appliance into water or other fluids. Do not hold the appliance with wet hands or feet. Do not hold the appliance with naked feet. Do not expose the appliance to atmospheric agents such as rain, wind, snow, hail. Do not use the appliance near explosives, highly flammable mate rials, gases, burning flames, heaters. Do not allow children, disabled people or every people without expe rience or technical ability to use the appliance if they are not properly watched over. Close supervision is necessary when any appliance used by or near children. Make sure that children do not play with this appliance. If you decide not to use the appliance any longer, make it unservice able by simply cutting the supply cable after disconnecting the plug from the socket. ALSO MAKE ANY DANGEROUS PARTS UNSERVICE ABLE, ESPECIALLY FOR CHILDREN WHO COULD PLAY WITH THE APPLIANCE.
DESCRIPTION Fig.1 1. Tank cover 2. Steam knob 3. Indicator 4. Coffee filter 5. Filter holder 6. Filter block 7. Filter holder handle
Before the first use 1. Remove the coffee machine from the package and check the components according to the production de sciptions. 2. Clean all the detachable components following the “Cleaning and Maintenance” section. 3. Place the coffee machine on a stable surface, far from water taps or sinks. 4. Follow the “Espresso coffee preparation” and “Milk frothing” sections without coffee and/or milk. Espresso coffee preparation
1. Ensure that the coffee machine is not plugged to an electric socket, and that the steam knob (2) is on OFF RELEASE position. 2. Open the tank cover (1) by turning it anti clockwise. Use the glass carafe (10) to measure water before pouring it into the tank. The maximum water tank capacity is equivalent to number 4 as marked on the carafe, and the minimum level is to number 2. Water, at any case, must not exceed the bar that is seen inside the water tank, about 5 cm from the edge of the tank itself. Turn the tank cover (1) clockwise to close it properly.

3. Insert the coffee filter (4) into the filter holder (5). 4. Add ground coffee using the measuring spoon (15) without pressing too much. 5. Insert the filter holder (5) into its position on the coffee machine, aligning the tubers properly with the grooves of the coffee machine so that there will be no leakages from the edge of the filter holder. 6. Put the glass carafe (10) on the removable drip shelf (8) that is already well inserted into the drip tray (9). 7. Plug the coffee machine to an electric socket. 8. Turn the steam knob (2) to “ ” position and the indicator will light up and coffee will flow out after about 2 minutes. 9. When coffee has arrived to the desired level, turn back the steam knob (2) to “PAUSE” position and the in dicator will be off. Alternatively, wait until the coffee stops flowing out by itself and turn back the steam knob (2) to “PAUSE” position. 10. Remove the carafe holding it by the handle (11) only. 11. Remove the filter holder (5) by its handle (7) and place the frothing head (13) above the removable drip shelf (8). 12. Place the steam knob (2) to position OFF RELEASE. Let all the steam be released completely from the tank through the frothing head (13) and the coffee machine will cool down. 13. Open the tank cover (1) only when no steam is coming out from the frothing head (13).
Milk frothing 1. Ensure that the coffee machine is not plugged to an electric socket, and that the steam knob (2) is on OFF RELEASE position. 2. Open the tank cover (1) by turning it anti clockwise. Use the glass carafe (10) to measure water before pouring it into the tank. The maximum water tank capacity is equivalent to number 4 as marked on the carafe, and the minimum level is to number 2. Water at any case must not exceed the bar that is seen inside the water tank, about 5 cm from the edge of the tank itself. Turn the tank cover (1) clockwise to close it properly. 3. Plug the coffee machine to an electric socket. 4. Add about 150ml of milk into a 300 or 350 ML mug that has a diameter not less than 70+/-5 mm. it’s recom mended to use whole milk at room temperature o from refrigerator instead of hot milk. 5. Turn the steam knob (2) to position and the indicator will light up. 6. Steam will come out after about 30 seconds. Plunge the frothing head (13) into the mug of milk. Froth milk by moving the mug slightly around the frothing head and then up and down. 7. Turn the steam knob (2) to PAUSE position to stop the frothing process. 8. Remove the mug and frothed milk is ready. 9. Turn the steam knob (2) to OFF RELEASE to turn off the coffee machine. 10. Unplug the coffee machine from the electric socket.
To prepare a cappuccino: Simply pour the espresso coffee prepared in advance into the frothed milk to obtain a cappuccino. Add sugar if preferred to serve. WARNINGS: Do not leave the coffee machine un attended during operation! Allow the coffee machine to cool down before preparing coffee for the second time. Turn the steam knob (2) to OFF RELEASE position to turn off the coffee machine. Allow the coffee machine to cool down before putting it away.
Cleaning and Maintenance 1. Turn off the coffee machine and allow it to cool down completely before cleaning and maintenance. 2. Clean the body with a clean damp cloth, and empty the water tank. 3. Before and after using, wash all the removable parts with water. 4. Remove the filter holder by turning it clockwise and empty any coffee residue and rinse it with water or use a mild detergent for coffee machines. 5. The glass carafe and its lid are dishwashing safe.

Eliminating mineral deposits 1. The internal parts must be cleaned every 2-3 months to be free from mineral deposits. 2. Fill the tank with water and descaler for coffee machines (the scale of water and descaler is 4:1, or following instructions for use of the descaler itself). Alternatively you can use citric acid (one hundred parts of water and three parts of citric acid) instead of descaler. 3. Wait 15 minutes then operate the coffee machine following the instructions in the “Espresso coffee prepara tion” without adding coffee ground into the filter. 4. Repeat the operation 4 or 5 times. 5. Refill the water tank with only water and repeat the operation from the beginning for 3 times.
For any improvement reasons, Beper reserves the right to modify or improve the product without any notice.
The European directive 2011/65/EU on Waste Electrical and Electronic Equipment (WEEE), requires that old household electrical appliances must not be disposed of in the normal unsorted municipal waste stream. Old appliances must be collected separately in order to optimize the recovery and recycling of the materials they contain, and reduce the impact on human health and the environment. The crossed out “wheeled bin” symbol on the product reminds you of your obligation, that when you dispose of the appliance, it must be separately collected.
GUARANTEE CERTIFICATE This appliance has been checked in the factory. From the date of original purchase a 24 month guarantee ap plies to material and production defects. The purchase receipt and the guarantee certificate must be submitted together in case of claim to guarantee. The guarantee is valid only with a guaranty certificate and proof of purchase (fiscal receipt) indicating the date of purchase and the model of the appliance For any technical assistance, please contact directly the seller or our head office in order to preserve the applian ce’s efficiency and NOT TO void the guarantee. Any intervention on this appliance by non-authorized persons will automatically void the guarantee. GUARANTEE CONDITIONS If the appliance shows defects as a result of faulty material and/or production during the period of guarantee, we guarantee repair free of charge on condition that: - The appliance has been used properly and for the purpose for which it has been intended. - The appliance has not been tampered with, otherwise it is not maintainable. - The purchase receipt shall be presented. - The appliance showing a fair wear and tear shall not be covered by this guarantee. Therefore, any part that could be accidentally broken or having visible signs of use in consumable products (such as lamps, batteries, heating elements…) the aesthetic parts are excluded from the guarantee, and any defect whatsoever resulting from non-respect of the rules for use, negligence in usage and/or maintenance of the appliance, carelessness, wrong or improper installation, damage during transport and any other damage not attributable the supplier. For every defect that could not be repaired within the guarantee period, the appliance will be replaced free of charge. In any case, if the part to be replaced for defect, breakage or malfunction is an accessory and/or a detachable part of the product, Beper reserves the right to replace only the very part in question and not the entire product
TECHNICAL ASSISTANCE Even after the guarantee period we will always pay attention to repairs for defected appliances. For technical assistance and/or repairs after the guarantee period you can directly contact the below address: CONTACT YOUR DISTRIBUTOR IN YOUR COUNTRY OR ATER SALES DEPARTMENT BEPER. E-MAIL as sistenza@beper.com WHICH WILL FORWARD YOUR ENQUIRIES TO YOUR DISTRIBUTOR.
Pages referenced in this manual — manufacturer, support and downloads.
Owners and our team usually reply within a day — and your question helps the next person too.
Be the first to ask — other owners or our team will answer.