Instruction/ maintenance manual of the product ONU-6040BF-2x ZyXEL Communications
Go to page of 20
www .zyxel.com User ’ s Guide ONU-6040BF-2x Series GEPON Optical Network Unit V ersion 1. 00 Edition 1, 5/2009 2009 ZyXEL Communications Corporat ion C.
ENGLISH 2.
3 Introduction The ONU-6040BF-2x is an opt ical network unit (ONU) that allows you to enjoy high-speed Internet access over optical networks. The ONU-6040BF-2x comes with one fiber , four 10/100 Mbps RJ-45 ports and one co- axial CA TV connector . No conf iguration is required.
4 a. Hold the ONU-6040BF-2x upright, push the top cover forward with the LEDs (lights) facing yo u, then lift up the top cover to r emove it..
5.
6 b. Wind the fiber-optic cable around the tray in the ONU-6040BF-2x. c. Connect the fiber-optic connector into the PON port. d. Put the top cover back. T o av oid possible eye injury , do NOT lo ok into an operating fiber-optic module’s connec tor .
7 3. CA TV : Use a coaxial cable to connect the CA TV port to a television or set-top box with an F-connector . Overly tightened coaxial cable may af fect transmission quality and/or break the connector pin. 4. POWER : Use the included power adaptor to connect this power socket to an appropriate power source.
8 The following table describes the LEDs in detail. Label Color Status Description PWR Green On The ONU-6040BF-2x is getting proper input power voltage and is turned on. Red On The ONU-6040BF-2x is receiving abnormal input powe r voltage. Off The power is off or there is a power failure.
9 T est Y our Internet Connection After you have connected the hardware and turned on the ONU-6040BF-2x, open a web browser on your computer and go to any web site (for example, www .zyxel.c om ) to test your Internet connection. LAN 1 ~ 4 Ye l l o w O n T h e LAN port is connected to an Ethernet device at 100 Mbps.
10 Hardware Installation The ONU-6040BF-2x can be vertically placed on a desktop with the included stand or mounted on a wall. St anding Instructions Place the right p anel of the ONU-6040BF-2x (when facing the LEDs) onto the included stand until the ONU- 6040BF-2x fits in the st and completely .
11 W all-mounting Instructions Complete the following steps to hang your ONU- 6040BF-2x on a wall. 1. Select a position free of obstructions on a sturdy wall. 2. Drill two holes large enough for the M4 tap screws. Make sure the distance between the centers of the holes is 140mm.
12 3. Do not insert the screws al l the way into the wall. Leave a small gap of about 0.5 cm between the heads of the screws and the wall. 4. Make sure the screws are snugly fastened to the wall. They need to hold the weight of the ONU- 6040BF-2x with the connection cables.
13 T roubleshooting 1. The PWR light is not on when I connect power to the ONU-6040BF-2x. • Check that the power source is turned on. • Y ou might be using the wrong power adap tor .
14 NOT attempt to replace the optical cable/ connector yourself. 3. The CA TV light is of f. • Check the PON light. If the PON light is off, see 2 The PON light is off. If the PON light is on , contact your service provider and make sure the video signals can be transmi tted successfully .
15 Specifications S pecifications are accurate at the time of writing. Feature Specification Dimensions (mm) 181 (Wide) x 123.4 (Deep) x 41 (High) Wei g h t < 1 kg Interface PON One PON port Compliant with IEEE 802.
16 Safety W arnings • Do NOT use this product near water , for example, in a wet basement or near a swimming pool. • Do NOT expose your device to dampness, dust or corrosive liquids. • Do NOT store things on the device. • Do NOT install, use, or service this device durin g a thunderstorm.
17 the product where anyone can walk on the power adap tor or cord. • Do NOT use the device if the power adaptor or cord is damaged as it might cause electrocution. • If the power adapt or or cord is damaged, remove it from the power outl et. • Do NOT attempt to rep air the power adaptor or cord.
18 to provide reasonable protection against har mful interference in a commerci al environment. This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radi o communications.
19 purchase, should the product have indi cations of failure due to faulty workmanship and/or materials, ZyXEL will, at its discretion, repair or replace the defective products or components without charge for either p arts or labor , and to whatever extent it shall deem necessary to restore the product or components to proper operating conditi on.
20 transmitted in any form or by any m eans, electronic, mechanical, magnetic, optical, chemical, photocopying, man ual, or otherwise, without the prior written permission of ZyXEL Communications Corporation. Published by ZyXEL Communications Corporation.
An important point after buying a device ZyXEL Communications ONU-6040BF-2x (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought ZyXEL Communications ONU-6040BF-2x yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data ZyXEL Communications ONU-6040BF-2x - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, ZyXEL Communications ONU-6040BF-2x you will learn all the available features of the product, as well as information on its operation. The information that you get ZyXEL Communications ONU-6040BF-2x will certainly help you make a decision on the purchase.
If you already are a holder of ZyXEL Communications ONU-6040BF-2x, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime ZyXEL Communications ONU-6040BF-2x.
However, one of the most important roles played by the user manual is to help in solving problems with ZyXEL Communications ONU-6040BF-2x. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device ZyXEL Communications ONU-6040BF-2x along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
