Instruction/ maintenance manual of the product TN-2301 Winegard
Go to page of 18
Ver. 1.5 4/21/2009 - 1 - TravelNet Data/Voice Cellular Router Installation Guide ATTENTION INSTALLER Parts List: • TravelNet Da ta/Voice Cellular Route rs ( Models TN-2301/T N-2303/TN-2305) • Gree.
Ver. 1.5 4/21/2009 - 2 - TravelNet’s Cellular Router System is Preconfigured And Ready to Install with these Easy Steps Installa tion Instructions: ( Models TN-23 01/TN-2303/TN-2305 ) 1. Install the T ravelNet Rout er and Edimax Rout er equipment in a convenient place such as uppe r cabinet (Velcro works well on the base of the each unit).
Ver. 1.5 4/21/2009 - 3 - Position the a ntennas near the cable entry point. Here the TravelNet unit was located in the front overhead (Figure 1) with the antenn as mounted close by on the roof. Figure 2 Note that the antenna mount s are anchored to t he 7” x 7” aluminum ground plane and that e verything is well sealed.
Ver. 1.5 4/21/2009 - 4 - mounts securely to the ground p lane and coach roof as shown. Secure the antenna cable to the roof as shown. Figure 4 4. Route the 2 antenna cab les to the cable entry hole in the coach roof.
Ver. 1.5 4/21/2009 - 5 - Setup the Tr a velNet Data/Voi ce Ter minal Setting up your Car rier Account. Your TravelNet-DV requires both a data plan for internet service and a voice plan for analog phone service. Locate t he “Account Application” (yel low sheet) in the “End User Env elope”.
Ver. 1.5 4/21/2009 - 6 - 1. Remove Battery Compartment Door on the bottom of the unit. Figure 7 2. Installing the AT&T SIM (Sprint and Verizon users skip to Step 3) Figure 8 Install the SIM Ca rd into the SI M card holder in the batt ery compartment.
Ver. 1.5 4/21/2009 - 7 - 3. Install the Battery & Secure the compartment door. Install the Rechargeable Battery Pack into the battery compartment. Remove the battery compartment door, insert the battery connector into the battery terminal, arrange the battery pack in the compartment, and replace the battery compartment door.
Ver. 1.5 4/21/2009 - 8 - Connect Ethe rnet cable to the Ethernet port on the T ravelNet Network Port (as shown) and to the Edimax W AN port (as shown) Antenna ca bles not shown fo r clarity. Figure 1 2 6. Attach Phone Cable Connect an RJ-11 Phone cable fr om a standard phone to the Phone input (J1 Figure 1 3 7.
Ver. 1.5 4/21/2009 - 9 - 8. Turn on Cell Router Power using switch. Figure 1 4 9. Understanding the LED Lights Figure 1 5 Note : LED’s are tricolored, Green, Amber and Red and this corresponds to the background colors of the table below.
Ver. 1.5 4/21/2009 - 10 - TravelNet Data/V oice (TN-2303) Termin al Setup A cti vate your Sprint TravelNet Data/Voice on the Sprint Network Your TravelNet Data/Voice requires a data plan for internet and a voice plan to hook up the analog phon e. Locate the “Account Application” (yell ow sheet) in the “End User Envelope ”.
Ver. 1.5 4/21/2009 - 11 - Figure 17 1. When all devices are connected an d powered on, use your compute r to connect to the Trav elNet Device Manager . • Launch your W eb browser (Internet Expl orer or Firefox). • Go to the browser’s address bar, ty pe http://192.
Ver. 1.5 4/21/2009 - 12 - Figure 19 • Proceed to Set Up a Wireless WA N Data Connection . TIP : Bookm ark the T ravelNet Device M anager access page ( http: //192.
Ver. 1.5 4/21/2009 - 13 - 5. Click Setup, click W ire less WAN in the Setup m enu. 6. PSD Auto Connect select Alwa y s On 7. Do a hard restart of all ne twork devices in order, f irst the TravelNet Ce llular Router, 2 nd the W iFi Router, and finally laptop.
Ver. 1.5 4/21/2009 - 14 - NOTE; Do not touch the gold-colored areas of your SIM Card. Figure 2 0 2. Install the Rechargeable Ba ttery Pack into the ba ttery compartment . (Fig. 20 above) • _ W ith t he battery compartm ent door open, in sert the battery connec tor into the battery term inal.
Ver. 1.5 4/21/2009 - 15 - • _ In a vehicle environment, groundin g to the frame and bat tery or alternato r can reduce static or buzzing during voice c alls.
Ver. 1.5 4/21/2009 - 16 - Figure 23 WEP Key Set up Parameters Default De scription Key Length 64-bit You can select the WEP key length for encryption, 64-bit or 128-bit.
Ver. 1.5 4/21/2009 - 17 - Use the following proced ure to configure Wi ndows XP with SP 2 for your infrastructure mode wireless network when the wireless networ k adapter supports W ireless Auto Configuration: 1.
Ver. 1.5 4/21/2009 - 18 - 1. Open Connect to a Netw ork by clicking the Start but ton , and then clicking Connect to . 2. In the Show list , click Wireless .
An important point after buying a device Winegard TN-2301 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Winegard TN-2301 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Winegard TN-2301 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Winegard TN-2301 you will learn all the available features of the product, as well as information on its operation. The information that you get Winegard TN-2301 will certainly help you make a decision on the purchase.
If you already are a holder of Winegard TN-2301, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Winegard TN-2301.
However, one of the most important roles played by the user manual is to help in solving problems with Winegard TN-2301. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Winegard TN-2301 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
