Instruction/ maintenance manual of the product TN-2055 Winegard
Go to page of 16
Ver. 1.5 4/1/2009 - 1 - TravelNet Internet Only Cellular Router Installation Gu ide ATTENTION INSTALLER Parts List: • TravelNet Cellular Router (TN-2033, T N-2055) • 110 volt adapter with green co.
Ver. 1.5 4/1/2009 - 2 - TravelNet’s Cellular Router System is Preconfigured And Ready to Install with these Easy Steps Installation Instructions: 1. Install the TravelNet Rout er and Edimax Router equipment i n a convenient place such as upper cabinet (Velcro works well on the base of th e each unit).
Ver. 1.5 4/1/2009 - 3 - Figure 2 Note that the antenna mount s are anchored to the 7” x 7” alumi num ground plane and that everything is well sealed. Figure 3 3. Insert the small end of th e cable through the ¾” diameter hole in t he stainless antenna mount and feed the cable th rough.
Ver. 1.5 4/1/2009 - 4 - Figure 4 4. Route the 2 antenna cab les to the cable entr y hole in the coach roof. Securel y attach the cable entr y c over over the cable entry point on t he coach roof using screws and caulk (Figure 6) Antenna cables sh ould be directed to the TravelNet R outer.
Ver. 1.5 4/1/2009 - 5 - Figure 6 6. Carefull y attach the ant enna cables to the SMA Antenna Mount s on the TravelNet router. Caution should be taken to not over tighten the S MA cable connectors. Figure 7 7. Connect power supplies for both devices to AC source or 12 VDC source.
Ver. 1.5 4/1/2009 - 6 - Figure 8 8. Check table below for LED status. Light Status LINK SVC LAN Off No Connect ion (IP address ) No Power No Connection On Green-- 1XRTT Connection Yellow Blinking-- No Signal (RSS I) Red-- Connected to LAN On Red— EV-DO Connection Yellow Solid— RSSI < -88 On Green Solid -- RSSI > -88 9.
Ver. 1.5 4/1/2009 - 7 - Activation I nstru ctions for model T N-2055 and TN-2 03 3 : ( Sprint TN-2033 users skip to page 9 ) Verizon TN-2055 Activation: 1. Connect an Ethernet Cab le directl y to the TravelNet Cellular Router and th e Laptop. 2. Enable the Local Area Network, when connected, go to the nex t step.
Ver. 1.5 4/1/2009 - 8 - Figure 1 1 8. Click on the Over The Air Activation b utton. 9. If Network Stab ility is OK For Activation ( if Not Ok for Activation, wait 3 minutes.) If Not OK for Activation for 15 additio nal minutes, contact Support. 10. Click the Activate button.
Ver. 1.5 4/1/2009 - 9 - 19. Click on the Status- W ireless button, and verify that there is a Current IP address. This may take several minut es depending on the carrier network. Figure 1 3 20. Click on the Home button. 21. Click on the Restart button and confirm b y clicking the Restart butt on again, and wait 30 seconds.
Ver. 1.5 4/1/2009 - 10 - 5. Enter the user name ‘ctek ’ and password ‘ctek’ 6. Click the Log In button. 7. Click on the Activation but ton. 8. Click on the Over the Air Activ ation button Figure 1 6 9. If Network Stabilit y is Ok for Activation then go to step 9, i f Not Ok, then wait 3 minutes.
Ver. 1.5 4/1/2009 - 11 - Figure 1 8 15. At the bottom of the page, click the Update butt on. 16. Ok, then click the Home button. 17. Click on the Restart button and confirm b y clicking the Restart butt on again, and wait 30 seconds. Figure 1 9 18. Click on the Home button.
Ver. 1.5 4/1/2009 - 12 - Figure 20 WEP Ke y Setup Figure 2 1 1. Log into the E dimax WiFi Ro uter at 192. 168.2.1 2. Enter the Username ‘admin’ an d Password ‘1234’ 3. Go to W IRELESS SETTINGS > SECURIT Y 4. Encryption t ype: select WEP 5. Key Length : 64-bit 6.
Ver. 1.5 4/1/2009 - 13 - Figure 22 WEP Key Set up Parameters Default Description Key Length 64-bit You can select the W EP key length f or encryption, 64-bit or 128 -bit.
Ver. 1.5 4/1/2009 - 14 - To connect your X P comput er to your wi reless netw ork Configuring the Windows XP Wireless Clients (With WEP) Configuration of the Wi ndows XP wireless clients for WEP key a.
Ver. 1.5 4/1/2009 - 15 - To connect your Windows Vista computer to your wireless network Vie w and connect to available w irel ess netw orks Applies to all editio ns of Windows Vist a. If you have a mobile PC, you can see a list of available wireless netwo rks, and then connect to one of those n etworks, no matter where you are.
Ver. 1.5 4/1/2009 - 16 - QUESTIONS? CA LL OUR SUPPORT LINE: 877-47 5-7771 or visit our website FAQ a t http://www.winegard.com TravelNet Winega rd Company Support: (87 7) 475-7771 FAX: 847-9 91-3328.
An important point after buying a device Winegard TN-2055 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Winegard TN-2055 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Winegard TN-2055 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Winegard TN-2055 you will learn all the available features of the product, as well as information on its operation. The information that you get Winegard TN-2055 will certainly help you make a decision on the purchase.
If you already are a holder of Winegard TN-2055, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Winegard TN-2055.
However, one of the most important roles played by the user manual is to help in solving problems with Winegard TN-2055. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Winegard TN-2055 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
