Instruction/ maintenance manual of the product WB-1 Wells
Go to page of 12
PRINTED IN UNITED ST A TES OF AMERICA WELLS BLOOMFIELD, LLC 2 ERIK CIRCLE, P . O. Box 280 V erdi, NV 89439 www .wellsbloomfield.com telephone: 775-689-5703 fax: 775-689-5976 IMPORTANT: DO NOT DI SCARD.
212 37055 OpManual for WB-1 and WB-2 Waffle Bakers Unless otherwise specified, all commercial cooking equipment manufactured by WELLS BLOOMFIELD, LLC is warranted against defects in ma terials and wor.
WARRANTY xi SPECIFICATIONS 1 FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 3 AGENCY LISTING INFORMATION 3 INSTALLATION 4 OPERATION 5 CLEANING INSTRUCTIONS 6 MAINTENANCE - S.
FEATURES & OPERATING CONTROLS 2 Fig. 1 Waffle Baker - Features & Operating Controls (WB -2 shown, WB-1 similar) 212 37055 OpManual for WB-1 and WB-2 Waffle Bakers BACK VIEW UPPER GRID (RAISED .
PRECAUTIONS AND GENERAL INFORMATION 3 This appliance is intended for use in commercial establishments only. This appliance is intended to prepare food for human consumpti on. No other use is recommended or autho rized by the manufacturer or its agents.
INSTALLATION NOTE: DO NOT discard the carton or other packing materials until you have inspected the appliance for hidden damage and tested it for proper operation.
CAUTION: HOT SURFACE Exposed surfaces can be hot to the touch and may cause burns. IMPORTANT: The timer bell will ring at the end of the cooking time. The timer bell is only a signal that the waffle is done. It does not turn the heating element on or off.
CLEANING INSTRUCTIONS PREPARATION Unplug appliance fro m ele ctric power Allow appliance to cool completely. FREQUENCY Daily TOOLS Plastic Scouring Pad, So ft-Bristled Fiber Brush Mild Detergent, Non-Abrasive Cleanser Clean Soft Cloth / Sponge CLEANING 1.
PREPARATION Unplug appliance fro m ele ctric power Allow appliance to cool completely. FREQUENCY As needed TOOLS Commercial Carbon Cleaner 1” Bristle Brush, Stiff Fiber Brush Clean Soft Cloth / Sponge REMOVE CARBONIZATION FROM GRIDS 1. Allow the waffle baker to cool to room temperature.
8 TROUBLESHOOTING SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Will not heat Power cord not plugged in, or circuit breaker tripped Establish main power Be sure appliance is plugged in Power switch OFF Turn power switch ON Internal component damage Contact an authorized Wel ls Service Agency for rep air s.
DESCRIPTION PART NO. DRIP TRAY, WB-1 , WB-2 21489 RUBBER FEET (pk 4) 21657 CUST OMER SERVICE DA T A please have this information av ailable if calling for service RESTAURANT ___________ ______________.
Genuine Parts Protect - YOU - All - W ays SER VICE TRAINING - QUALITY SER VICE SER VICE TRAINING - QUALITY SER VICE CUSTOMER SA TISF ACTION CUSTOMER SA TISF ACTION Commercial Food Equipment Service As.
An important point after buying a device Wells WB-1 (or even before the purchase) is to read its user manual. We should do this for several simple reasons:
If you have not bought Wells WB-1 yet, this is a good time to familiarize yourself with the basic data on the product. First of all view first pages of the manual, you can find above. You should find there the most important technical data Wells WB-1 - thus you can check whether the hardware meets your expectations. When delving into next pages of the user manual, Wells WB-1 you will learn all the available features of the product, as well as information on its operation. The information that you get Wells WB-1 will certainly help you make a decision on the purchase.
If you already are a holder of Wells WB-1, but have not read the manual yet, you should do it for the reasons described above. You will learn then if you properly used the available features, and whether you have not made any mistakes, which can shorten the lifetime Wells WB-1.
However, one of the most important roles played by the user manual is to help in solving problems with Wells WB-1. Almost always you will find there Troubleshooting, which are the most frequently occurring failures and malfunctions of the device Wells WB-1 along with tips on how to solve them. Even if you fail to solve the problem, the manual will show you a further procedure – contact to the customer service center or the nearest service center
